G-Tech : Jurnal Teknologi Terapan
Vol 10 No 4 (2026): G-Tech, Vol. 10 No. 4 October 2026

Improvement of the M8 Nut Production Process to Reduce Defects Using the PDCA Cycle

Firmansyah Sulistiyono (Politeknik Negeri Subang)
Yadi Hikmah Setiana (Politeknik Negeri Subang)
Firdaus Ashari (Politeknik Negeri Subang)
Berliantara Badharuddin Suharto Putra (Politeknik Negeri Subang)



Article Info

Publish Date
20 Oct 2026

Abstract

Product quality is important in manufacturing because defective products can increase material, time, and labor waste. This study aimed to reduce defects in the M8 nut production process in a Teaching Factory laboratory using the PDCA (Plan-Do-Check-Act) cycle. The improvement process included problem identification, root cause analysis using the 5M+1E approach, corrective actions, and evaluation of the results. During the initial trial production, 80 M8 nuts were produced, consisting of 72 conforming (OK) and 8 nonconforming (NG) products, resulting in a defect rate of 10%. The analysis identified variations in raw material dimensions and the absence of systematic material inspection and sorting as factors requiring improvement. Corrective actions included inspecting and sorting raw materials before production. After the improvement, 800 products were produced, with 799 conforming products and 1 nonconforming product, resulting in a defect rate of 0.125%. This represents a 98.75% reduction in the defect rate. The results indicate that PDCA supported by 5M+1E analysis can provide a systematic approach to reducing defects and improving the quality of M8 nut production in a Teaching Factory environment.

Copyrights © 2026






Journal Info

Abbrev

g-tech

Publisher

Subject

Computer Science & IT Decision Sciences, Operations Research & Management Energy Engineering

Description

Jurnal G-Tech bertujuan untuk mempublikasikan hasil penelitian asli dan review hasil penelitian tentang teknologi dan terapan pada ruang lingkup keteknikan meliputi teknik mesin, teknik elektro, teknik informatika, sistem informasi, agroteknologi, ...