Claim Missing Document
Check
Articles

Found 2 Documents
Search

Pengaruh Variasi Suhu Penekanan Terhadap Kualitas dan Sifat Mekanik Serat Daun Nanas Berbasis Resin Epoksi untuk Aplikasi Komposit Roni Suhartono; Yadi Hikmah Setiana; Didin Komarudin
IRA Jurnal Teknik Mesin dan Aplikasinya (IRAJTMA) Vol 4 No 3 (2025): Desember
Publisher : CV. IRA PUBLISHING

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.56862/irajtma.v4i3.361

Abstract

This study aims to evaluate the effect of varying pressing times at a constant temperature, using the hot-press method and the same resin mixture, on the material's quality and mechanical properties. Tensile testing was conducted in accordance with ASTM D3039 using specimens measuring 250 × 20 × 2 mm to ensure accurate mechanical measurements on thin laminates. The process began with selecting healthy pineapple leaves, followed by extrusion. A chemical treatment was then applied by immersing the fibers in a 5% NaOH solution for 2 hours. The fibers were subsequently mixed with resin and pressed for 20, 30, and 40 minutes at 100 °C. The results showed that the first sample, pressed for 40 minutes, achieved a tensile strength of 55.25 MPa. The second sample, pressed for 30 minutes, reached 50.38 MPa, while the third sample, also pressed for 30 minutes, achieved 47.8 MPa. The 40-minute pressing time can be considered the recommended working point, as evidenced by the highest tensile strength of 55.25 MPa.
Improvement of the M8 Nut Production Process to Reduce Defects Using the PDCA Cycle Firmansyah Sulistiyono; Yadi Hikmah Setiana; Firdaus Ashari; Berliantara Badharuddin Suharto Putra
G-Tech: Jurnal Teknologi Terapan Vol 10 No 4 (2026): G-Tech, Vol. 10 No. 4 October 2026
Publisher : Universitas Islam Raden Rahmat, Malang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.70609/gtech.v10i4.11439

Abstract

Product quality is important in manufacturing because defective products can increase material, time, and labor waste. This study aimed to reduce defects in the M8 nut production process in a Teaching Factory laboratory using the PDCA (Plan-Do-Check-Act) cycle. The improvement process included problem identification, root cause analysis using the 5M+1E approach, corrective actions, and evaluation of the results. During the initial trial production, 80 M8 nuts were produced, consisting of 72 conforming (OK) and 8 nonconforming (NG) products, resulting in a defect rate of 10%. The analysis identified variations in raw material dimensions and the absence of systematic material inspection and sorting as factors requiring improvement. Corrective actions included inspecting and sorting raw materials before production. After the improvement, 800 products were produced, with 799 conforming products and 1 nonconforming product, resulting in a defect rate of 0.125%. This represents a 98.75% reduction in the defect rate. The results indicate that PDCA supported by 5M+1E analysis can provide a systematic approach to reducing defects and improving the quality of M8 nut production in a Teaching Factory environment.