Garuda - Garba Rujukan Digital

Article Per Year (5 Year)

All

International Journal of Science and Engineering (IJSE)

ijse
Website

Published by Universitas Diponegoro

ISSN : - EISSN : - DOI : -

Core Subject : Engineering,

Engineering

The scope of journal covers all area in the application on chemical, physical, mathematical, biological, agricultural, corrossion, and computer science to solve the engineering problems.

Arjuna Subject : -

Articles 5 Documents

Search results for , issue "Vol 1, No 1 (2010)" : 5 Documents clear

The Effect of Functionalization Carbon Nanotubes (CNTs) on the Performance of PES-CNTs Mixed Matrix Membrane Ahmad Mustafa; Tutuk Djoko Kusworo; Abdullah Busairi; Ahmad Fauzi Ismail
International Journal of Science and Engineering Vol 1, No 1 (2010)
Publisher : Chemical Engineering Diponegoro University

A new type of mixed matrix membrane consisting of functionalized carbon nanotubes (CNTs) and polyethersulfone (PES) is prepared for biogas purification. PES mixed matrix membrane with and without modification of carbon nanotubes were prepared by a dry/wet phase inversion technique using a pneumatically flat sheet membrane casting machine system. The modified carbon nanotubes were prepared by treating the carbon nanotubes with chemical modification using Dynasylan Ameo (DA) silane agent to allow PES chains to be grafted on carbon nanotubes surface. The results from the FESEM, DSC and FTIR analysis confirmed that chemical modification on carbon nanotubes surface had taken place. Meanwhile, the nanogaps in the interface of polymer and carbon nanotubes were appeared in the PES mixed matrix membrane with unmodified of carbon nanotubes. The modified carbon nanotubes mixed matrix membrane increases the mechanical properties, the productivity and purity of biogas. For PES-modified carbon nanotubes mixed matrix membrane the maximum selectivity achieved for CO2/CH4 is 36.78

Application of Activated Carbon Mixed Matrix Membrane for Oxygen Purification Tutuk Djoko Kusworo; Ahmad Fauzi Ismail; Ahmad Mustafa; , Budiyono
International Journal of Science and Engineering Vol 1, No 1 (2010)
Publisher : Chemical Engineering Diponegoro University

This study is performed primarily to investigate the effect of activated carbon on oxygen separation performance of polyethersulfone mixed matrix membrane. In this study, polyethersulfone (PES)-activated carbon (AC) mixed matrix membranes were fabricated using dry/wet technique. This study investigates the effect of polyethersulfone concentration and activated carbon loading on the performance of mixed matrix membrane in terms of permeability and selectivity of O2/N2 gas separation. The fabricated flat sheet mixed matrix membranes were characterized using permeation test, Field Emission Scanning Electron Microscopy (FESEM) analysis and Differential Scanning Calorimetry (DSC). It was found that the activated carbon loading affected the gas separation performance of mixed matrix membrane. PES- 1wt% AC membrane yielded 3.75 of O2/N2 selectivity, however 5 wt% of AC can produced 5 O2/N2 selectivity

Study on Treatment of Slaughterhouse Wastewater by Electro-coagulation Technique B. Budiyono; I Nyoman Widiasa; Seno Johari
International Journal of Science and Engineering Vol 1, No 1 (2010)
Publisher : Chemical Engineering Diponegoro University

Electro-coagulation (EC) is well known as a technique for removing suspended solids as well as oils and greases from wastewater. The aims of this research are to study the performance of the EC technique to treat a high strength wastewater from slaughterhouse in batchwise mode. The effect of various process variables such as number and electrode material, initial pH, suspended solid (SS) content, and operating time was investigated The electrolytic cell (electro-coagulator) used was a 600 ml cylinder glass reactor with working volume 400 ml and equipped by magnetic stirrer without temperature control. Cast iron (Fe) and aluminum (Al) cylinder were used as anode/cathode pair. The number of electrode was varied 1 and 2 pairs. The effective area of the electrode pair was 6.28 cm2. The DC power supply was controlled by a voltmeter and be adjusted constant at 125 A/m2 for each test runs. The initial SS concentration were varied from 1250, 2100, 3000, and 4000 mg/L by diluting wastewater. It is found that effluent temperature depends on SS and increases up to 98 °C when SS content was 4000 mg/L. One and two pairs of Fe-Al electrode will give SS removal efficiency are 97.2 and 99.6 %, respectively. However, the higher electrode number will need the shorter time to get certain removal efficiency of SS. Number of electrodes didn’t give the significant impact to the final pHs. With initial pH 7.05 both two pair of electrode will give the final pH relatively constant to 7.80. Further work will be conducted to optimize the CD and charge loading to avoid the excessive temperature increase

CO2 Removal from Biogas Using Carbon Nanotubes Mixed Matrix Membranes Tutuk Djoko Kusworo; Ahmad Fauzi Ismail; , Budiyono; I Nyoman Widiasa; Seno Johari; , Sunarso
International Journal of Science and Engineering Vol 1, No 1 (2010)
Publisher : Chemical Engineering Diponegoro University

A new type of mixed matrix membrane consisting of polyethersulfone (PES) and carbon nanotubes (CNTs) is prepared for biogas purification application. PES mixed matrix membrane with and without modification of carbon nanotubes were prepared by a dry/wet phase inversion technique using a pneumatically membrane casting machine system. The modified carbon nanotubes were prepared by treating the carbon nanotubes with chemical modification using acid treatment to allow PES chains to be grafted on carbon nanotubes surface. The results from the FESEM, DSC and FTIR analysis confirmed that chemical modification on carbon nanotubes surface had taken place. Meanwhile, the nanogaps in the interface of polymer and carbon nanotubes were appeared in the PES mixed matrix membrane with unmodified of carbon nanotubes. The modified carbon nanotubes mixed matrix membrane increases the mechanical properties and the permeability of all gases. For PES-modified carbon nanotubes mixed matrix membrane the maximum selectivity achieved for CO2/CH4 is 23.54

Foam Behaviour of An Aqueous Solution of Piperazine- N-Methyldiethanolamine (MDEA) Blend as A Function of The Type of Impurities and Concentrations Iwan Ratman; Tutuk Djoko Kusworo; Ahmad Fauzi Ismail
International Journal of Science and Engineering Vol 1, No 1 (2010)
Publisher : Chemical Engineering Diponegoro University

This study focuses on the effect of impurities in the natural gas stream on the characteristic of foam behaviour in the blended piperazine and MDEA solution. Hydrocarbon liquids, Iron Sulphide, Sodium Chloride, Acetic Acid, Methanol and Polyethylene Glycol were used as the impurities. The results indicated that the type of impurities determined the foam formation of the amine solution. The concentration of piperazine-MDEA blends also enhanced to the increasing of the foam height of blended piperazine-MDEA. Iron sulfide, hydrocarbon and sodium chloride are the impurities which apparently contributed to the high foaming tendency of the solutions. At the same concentration of the impurities, iron sulfide appeared as the most influential contaminant to the foam formation, which promoted the highest foamability in any concentrations of the blend piperazine-MDEA

Page 1 of 1 | Total Record : 5

Filter by Year

2010 2010

Filter By Issues

All Issue Vol 13, No 1 (2019) Vol 10, No 2 (2016) Vol 10, No 1 (2016) Vol 9, No 2 (2015) Vol 9, No 1 (2015) Vol 8, No 2 (2015) Vol 8, No 1 (2015) Vol 7, No 2 (2014) Vol 7, No 1 (2014) Vol 6, No 2 (2014) Vol 6, No 1 (2014) Vol 5, No 2 (2013) Vol 5, No 1 (2013) Vol 4, No 2 (2013) Vol 4, No 1 (2013) Vol 3, No 2 (2012) Vol 3, No 1 (2012) Vol 2, No 2 (2011) Vol 2, No 1 (2011) Vol 1, No 2 (2010) Vol 1, No 1 (2010) ARTICLE IN PRESS More Issue

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota semarang,

Jawa tengah

INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name -

Contact Email -

Phone -

Journal Mail Official -

Editorial Address -

Location Kota semarang, Jawa tengah INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota semarang,

Jawa tengah

INDONESIA