cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
-
Contact Email
-
Phone
-
Journal Mail Official
-
Editorial Address
-
Location
Kota semarang,
Jawa tengah
INDONESIA
KAPAL Jurnal Ilmu Pengetahuan dan Teknologi Kelautan
Published by Universitas Diponegoro
ISSN : 18298370     EISSN : 23019069     DOI : 10.14710/kapal.
Core Subject : Science,
Earth & Planetary Sciences
Jurnal ini merupakan Jurnal Ilmiah untuk mengembangkan ilmu dibidang Ilmu Pengetahuan & Teknologi Kelautan. Jurnal ini diterbitkan oleh Teknik Perkapalan Universitas Diponegoro 3 (tiga) kali dalam 1 tahun pada bulan Februari, Juni dan Oktober.
Arjuna Subject : -
Articles 9 Documents
 1 
Search results for , issue "Vol 18, No 2 (2021): June" : 9 Documents clear
The TLP 2-DOF as an alternative model for extreme wave application Akmal, Jamiatul; Lubis, Asnawi; Tanti, Novri; Nuryanto, Nuryanto; Murti, Adam Wisnu
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.37187

Abstract

Tension Leg Platform (TLP) is an offshore platform structure used for deep-sea oil and gas exploration. The main structure of the TLP consists of a deck, pontoon, mooring system, and foundation. TLP operates in a balance of buoyancy, structural weight, and mooring tension. The problem is the construction of TLP in the deep sea, where sometimes extreme waves appear could damage the TLP structure. This paper proposes a new model of TLP that is more stable to extreme waves. The method is to separate the mass of the deck and the mass of the pontoon into two flexible parts, which are connected by a cantilever spring system. Thus the TLP motion becomes two degrees of freedom (TLP 2-DOF). Using the dynamic vibration absorber (DVA) method, the ratio of the deck mass, pontoon mass, and spring stiffness are adjusted so that the primary mass movement is minimal. Furthermore, the ratio of the amplitude of the deck movement as the primary mass to the wave amplitude is analyzed, which is known as the operator response amplitude (RAO). The results showed that the TLP 2-DOF model was more stable. As an illustration, at resonance conditions, this model can reduce RAO to about 67%.
The Effect of Trim on Tanker, Container and Bulk Carrier Ship Toward the Reduction of Ship’s Exhaust Gas Emission Undap, Robin; Fadillah, Arif
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.33877

Abstract

Emission is one of the few environmental problems, and ships are one of the modes of transportation that produce it. This study aims to define the impact of using optimal trim during the cruising phase, so it can decrease the resistance and the fuel consumption, which will lead to less emission produced by the ship. The type and amount of ships used in this study are three tanker ships, three container ships, and two bulk carrier ships. The methodology used in this study is by using Holtrop’s resistance calculation method with the help of Maxsurf software. The resistance, the power needed, and the fuel consumption is calculated on 22 trim variations and seven speed variations. This study determined that the average decrease in fuel consumption caused by trim optimization for tanker, container, and bulk carrier ships is 5.641%, 8.269%, and 15.704%. Furthermore, the average decrease of emissions produced by tanker, container, and bulk carrier is 6.494%, 11.317%, and 13.775%, respectively. These results are narrowed down to conclude that trim optimization can reduce fuel consumption by up to 9.871% and decrease the emission produced by up to 10.529% for the three types of ships used in this study.
Roll Motion Analysis on Unmanned Surface Vehicle with Remote Controlled Weapon Station Models to Combat Piracy in Surabaya West Access Channel Habibah, Natasya; Habib, Kevin Rizqul; Claresta, Gianiti; Siregar, Hadi Mulki
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.37020

Abstract

The dense shipping activity in the Surabaya West Access Channel (SWAC) is accompanied by a high rate of piracy which had 13 cases during 2013–2018. An Unmanned Surface Vehicle (USV) with Remote Controlled Weapon Station (RCWS) was created to overcome this piracy, increase work effectiveness, and reduce potential casualties. This study aims to create a design of USV equipped with RCWS complies with the requirements then analyzes the stability and seakeeping (roll motion) because it is one of the most determining factors of the stability and safety of the ship. The research method in this study is a simulation process based on system engineering theory starting from the formulation of requirements, design making, and then simulation. Five design models are created and simulated to analyze their stability and seakeeping performance. The design results are a monohull USV equipped with an RCWS with the main dimension of 1.7 m long, 0.9 m wide, and 1.04 m high. The stability simulations conclude that Model 4 is the most stable platform with the highest peak value of GZ for 0.112 m in angle degree of 108.2°. The seakeeping simulations show that at wave heading 45°, model 3 has the highest RAO with the peak value of 4.703 at the frequency of 0.4 rad/s. At wave heading 90°, model 5 has the highest RAO with the peak value of 0.095 at the frequency of 0.4 rad/s. At wave heading 135°, model 1 has the highest RAO of 0.012 at the frequency of 0.581 rad/s.
The Strength and Fatigue Life analysis of Sedan Car Ramp of The Ferry Ro-Ro 5000 GT Using Finite Element Method Alamsyah, Alamsyah; Nurcholik, Samsu Dlukha; Suardi, Suardi; Pawarah, M U; Jumalia, Jumalia
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.37518

Abstract

The Ferry Ro-Ro 5000GT has three levels of car deck that are connected by internal ramps. Two issues that have to be paid attention during the operation of the internal ramp there are the strength capacity and the design fatigue life of the internal ramp structure. The purpose of the research is to determine the strength and fatigue life of the internal ramp construction. The method used the Finite Element Method using a static load by load case of point load at top girder and between girders. Results of the research detected the maximum stress value is in the load case of the point load (three sedan car) at between of the girder is 52.143 MPa with the fatigue life is 44.47 years with the load cycle is 7300000 cycle while the minimum stress value detected at the load case of the point load (two sedan cars) at top girder is 34.199 MPa with the fatigue life is 195.92 years with the load cycle is 50000000 cycle. For the safety factor, ramp construction 6.08 ~ 10.38. The safety factor value above is still in safe condition because the value is SF > 1.
Benchmark Study of FINETM/Marine CFD Code for the Calculation of Ship Resistance Firdhaus, Ahmad; Suastika, I Ketut; Kiryanto, Kiryanto; Samuel, Samuel
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.39727

Abstract

Benchmarking can be used to test CFD programs for selecting turbulence models, grid dependency studies, testing different numerical schemes and source codes, and testing different boundary conditions. CFD simulation in this study uses FINE™/Marine 7.2-1 software. The solver process at NUMECA uses the ISIS-CFD flow solver developed by EMN, which uses the incompressible unsteady Reynolds-average Navier stoke equation (RANSE). The solver is based on the finite volume method, and Turbulence models use SST k-ω models. The free surface flow around a model surface ship (DTMB 5415) advancing in calm water under steady conditions is numerically simulated. The geometry of the DTMB 5415 ship hull was provided in igs file format. The 1996 International Towing Tank Conference has recommended the DTMB 5415 combatant as a benchmark case for CFD computations of ship resistance and propulsion. The results compare well with the available experimental data. They allow an understanding of the differences that can be expected from vicious and potential flow methods due to their different mathematical formulations. It is demonstrated that the complementary application of these methods allows good predictions of the total ship resistance.
Real-Time Fuel Consumption Monitoring System Integrated With Internet Of Things (IOT) Hapsari, Adella Winanda; Prastowo, Hari; Pitana, Trika
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/kapal.v18i2.37180

Abstract

Fuel is an important aspect in the operation of ships that require high costs. The high cost of fuel is not followed by an automatic fuel monitoring process. By not using the fuel consumption monitoring method that works automatically, the shipping management does not know for sure the ship's fuel consumption is in accordance with the shipping mileage, thus triggering fraud committed by the ship's crew against the ship's fuel. Fuel consumption monitoring is carried out primarily to identify opportunities to improve energy efficiency and reduce costs. By following technological developments, Internet of Things (IoT) technology has begun to be applied in various industrial fields because it can transmit data in real-time via the internet network without human-to-human or human-to-computer interaction. In this research, the design of models and experiments related to a monitoring system for fuel consumption was carried out using sensors and microcontrollers integrated with the internet to obtain accurate and real-time data. The test results show that the volume of fuel available in the tank, the volume of fuel discharged, the flow rate of fuel, and the location of the system can be known by the user in real-time via the IoT website. Based on the results of measurements using an ultrasonic level sensor, it is known that the measurement results are quite accurate with a deviation of ± 0.5 cm. Meanwhile, the measurement results by the flow sensor are less accurate because the fuel flow only relies on the force of gravity.
Back-matter V. 18, No. 2 Andi Trimulyono
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Cover V. 18, No. 2 Andi Trimulyono
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Front-matter V. 18, No. 2 Andi Trimulyono
Kapal: Jurnal Ilmu Pengetahuan dan Teknologi Kelautan Vol 18, No 2 (2021): June
Publisher : Department of Naval Architecture - Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Page 1 of 1 | Total Record : 9

 1 

Filter by Year

2021 2021


Reset
Filter By Issues
All Issue Vol 23, No 1 (2026): Article in Press Vol 22, No 3 (2025): October Vol 22, No 2 (2025): Article in Progress (Accepted Papers) Vol 22, No 2 (2025): June Vol 22, No 1 (2025): February Vol 21, No 3 (2024): October Vol 21, No 2 (2024): June Vol 21, No 1 (2024): February Vol 20, No 3 (2023): October Vol 20, No 2 (2023): June Vol 20, No 1 (2023): February Vol 19, No 3 (2022): October Vol 19, No 2 (2022): June Vol 19, No 1 (2022): February Vol 18, No 3 (2021): October Vol 18, No 2 (2021): June Vol 18, No 1 (2021): February Vol 17, No 3 (2020): October Vol 17, No 2 (2020): June Vol 17, No 1 (2020): February Vol 16, No 3 (2019): Oktober Vol 16, No 2 (2019): Juni Vol 16, No 1 (2019): Februari Vol 15, No 3 (2018): Oktober Vol 15, No 2 (2018): Juni Vol 15, No 1 (2018): Februari Vol 14, No 3 (2017): Oktober Vol 14, No 2 (2017): Juni Vol 14, No 1 (2017): Februari Vol 13, No 3 (2016): Oktober Vol 13, No 2 (2016): Juni Vol 13, No 1 (2016): Februari Vol 12, No 3 (2015): Oktober Vol 12, No 2 (2015): Juni Vol 12, No 1 (2015): Februari Vol 11, No 3 (2014): Oktober Vol 11, No 2 (2014): Juni Vol 11, No 1 (2014): Februari Vol 10, No 3 (2013): Oktober Vol 10, No 2 (2013): Juni Vol 10, No 1 (2013): Februari Vol 9, No 3 (2012): Oktober Vol 9, No 2 (2012): Juni Vol 9, No 1 (2012): Februari Vol 8, No 3 (2011): Oktober Vol 7, No 3 (2010): Oktober Vol 7, No 2 (2010): Juni Vol 7, No 1 (2010): Februari Vol 6, No 2 (2009): Juni Vol 5, No 3 (2008): Oktober Vol 5, No 2 (2008): Juni Vol 5, No 1 (2008): Februari Vol 4, No 1 (2007): Februari Vol 3, No 3 (2006): Oktober More Issue