cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
Risanuri Hidayat
Contact Email
ijitee.ft@ugm.ac.id
Phone
+62274 552305
Journal Mail Official
ijitee.ft@ugm.ac.id
Editorial Address
https://jurnal.ugm.ac.id/ijitee/about/contact
Location
Kab. sleman,
Daerah istimewa yogyakarta
INDONESIA
IJITEE (International Journal of Information Technology and Electrical Engineering)
Published by Universitas Gadjah Mada
ISSN : -     EISSN : 25500554     DOI : https://doi.org/10.22146/ijitee.48545
Core Subject : Engineering,
Electrical & Electronics Engineering
IJITEE (International Journal of Information Technology and Electrical Engineering), with registered number ISSN 2550-0554 (Online), is a peer-reviewed journal published four times a year (March, June, September, December) by Department of Electrical engineering and Information Technology, Faculty of Engineering, Universitas Gadjah Mada. IJITEE (International Journal of Information Technology and Electrical Engineering) invites manuscripts in the various topics include, but not limited to, Information Technology, Power Systems, Digital Signal Processing, Communication Systems
Arjuna Subject : Teknik (semua kategori) - Teknik Listrik dan Elektro
Articles 5 Documents
 1 
Search results for , issue "Vol 1, No 3 (2017): September 2017" : 5 Documents clear
Forecasting Analysis on Land Detection System Based on Geographic Information System Warnia Nengsih
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 1, No 3 (2017): September 2017
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1397.368 KB) | DOI: 10.22146/ijitee.31954

Abstract

Geographic Information System (GIS) is an information system that performs geographic-based data visualization. The system performs mapping between various data points based on geographical location. Difficulties in mapping land in a region is the basis for the development of GIS applications for the detection of land. This system does not only detect vacant land in a region, but it also provides identification of land, and provides information about the size of the land, the land position, as well as access to nearby public facilities. The system is developed using a mobile platform as a value system that is more flexible and dynamic. For the analysis of the forecasting in an area uses a multiple regression method involving three independent variables, namely the use of dry land, the use of building land and land use. The results of the predictive forecasting provides location points of interest and public facilities located in the location which make it easy to give consideration in selecting a location which is appropriate to build.
Determination of MS Location through Building Using AoA Method of Frequency 47 GHz Andrita Ceriana Eska
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 1, No 3 (2017): September 2017
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1686.755 KB) | DOI: 10.22146/ijitee.31955

Abstract

This research discusses the determination of mobile station (MS) location of the uplink communication system. The location determination mobile station is based on the angle-of-arrival (AoA) method. The communication propagation is influenced by building environment. The building environment was modeled with diffraction method. Several diffraction methods were used such as single knife edge, and multiple knife edge method. The communication frequency used was 47 GHz. The analysis used percentage value at coverage area and comparison of error percent values between two method to determine mobile station location. The percentage of the communication coverage area obtained was 71.4% or of 255 from 300 nodes. The comparison methods used for mobile station location determination were the selection of the best SNR and localization technique. The error percentage value based on the selection of the best SNR method is 0.95%. The error percentage value based on localization technique method is 0.78%.
Design of Electronic Mass Balance of Gram Scale Using a Gage Strain Sensor Muhammad Priyono Tri Sulistyanto; Kurriawan Budi Pranata; Endarko Endarko; Melania Suweni Muntini
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 1, No 3 (2017): September 2017
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1246.867 KB) | DOI: 10.22146/ijitee.31957

Abstract

This research is conducted by utilizing strain gage uniaxial sensor with internal resistance 120 ohms and brass cantilever beam that is to build electronic mass scale in gram level. Basically, the aim of this research is to study deflect phenomenon measured by the strain gage sensor attached in the end of brass cantilever beam. Brass material was chosen to build cantilever as its Young moudulus contanst is bigger than other materials. Whilst mass loads for analizing brass cantilever profile are calibrated by manual Ohaus mass scale (PA214 type) with 0.07 gram load variations. The test result of this electronic mass scale system gets relationship of mass load data variation versus output voltage data (from differential amplifier). The relationship between mass and voltage can be approached by polynomial formula m = 4.2372V2 – 2.4551V + 1.5606 where m in gram and V in volt, and it gets 0.07 or 7% average error (less than linear formula approach). This formula is used further for programming ADC in 8-bit microcontroller to calculate mass and the calculation is shown in LCD 16x2.
Feature Extraction Comparison in Handwriting Recognition of Batak Toba Alphabet Novie Theresia Br Pasaribu; M. Jimmy Hasugian
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 1, No 3 (2017): September 2017
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (2000.519 KB) | DOI: 10.22146/ijitee.31969

Abstract

Offline handwriting recognition is one of the most prominent research topics due to its tremendous application and high variability as well. This paper covers the offline Batak Toba handwritten text recognition, from the noise removal, the process of feature extraction until the recognition by using several classifiers. Experiments show that elliptic fourier descriptor (EFD) is the most discriminative feature and Mahalanobis distance (MD) outperforms the two others classifier.
Virtual Reality-based Platformer Games Development for Elevating Architectural Heritage Awareness Ahmad Nasikun; Bagas Y. Wijonarko; Raja Bagus Arief Rahman; Anugerah Galang Persada; Sunu Wibirama
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 1, No 3 (2017): September 2017
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (998.169 KB) | DOI: 10.22146/ijitee.33592

Abstract

As a country with abundant traditional culture, Indonesia is facing serious challenge in conserving them. There is a need to promote the traditional culture to a wider area of people, particularly to the younger generation. Virtual world offers a new way of promoting a nation’s culture via Virtual Reality (VR). This research aims to develop a VR-based platformer mobile game to promote cultural awareness in a new and creative way for younger generation. In the game, a player can observe one famous architectural heritage in Yogyakarta—Mesjid Gedhe Kauman—in fun way of game. A survey is conducted to measure its success in reaching the predetermined goals and to measure its user experience (UX). The survey confirm that the VR-based platformer game helps them in learning cultural value of the architecture (62.5/100) and it is relatively easy to navigate (72.5/100). Moreover, it has a good user experience (UX) score—all are above 0.8, meaning that its users are generally comfortable in playing the game.

Page 1 of 1 | Total Record : 5

 1 

Filter by Year

2018 2018


Reset
Filter By Issues
All Issue Vol 5, No 4 (2021): December 2021 Vol 5, No 3 (2021): September 2021 Vol 5, No 2 (2021): June 2021 Vol 5, No 1 (2021): March 2021 Vol 4, No 3 (2020): September 2020 (in progress) Vol 4, No 2 (2020): June 2020 Vol 4, No 1 (2020): March 2020 Vol 3, No 4 (2019): Desember 2019 Vol 3, No 3 (2019): September 2019 Vol 3, No 2 (2019): June 2019 Vol 3, No 1 (2019): March 2019 Vol 2, No 4 (2018): December 2018 Vol 2, No 3 (2018): September 2018 Vol 2, No 2 (2018): June 2018 Vol 2, No 1 (2018): March 2018 Vol 1, No 4 (2017): December 2017 Vol 1, No 3 (2017): September 2017 Vol 1, No 2 (2017): June 2017 Vol 1, No 1 (2017): March 2017 More Issue