cover
Article Per Year (5 Year)
All
Home Page
OAI Link
Editorial Team
Contact
Reviewer
Google Scholar
Contact Name
Risanuri Hidayat
Contact Email
ijitee.ft@ugm.ac.id
Phone
+62274 552305
Journal Mail Official
ijitee.ft@ugm.ac.id
Editorial Address
https://jurnal.ugm.ac.id/ijitee/about/contact
Location
Kab. sleman,
Daerah istimewa yogyakarta
INDONESIA
IJITEE (International Journal of Information Technology and Electrical Engineering)
Published by Universitas Gadjah Mada
ISSN : -     EISSN : 25500554     DOI : https://doi.org/10.22146/ijitee.48545
Core Subject : Engineering,
Electrical & Electronics Engineering
IJITEE (International Journal of Information Technology and Electrical Engineering), with registered number ISSN 2550-0554 (Online), is a peer-reviewed journal published four times a year (March, June, September, December) by Department of Electrical engineering and Information Technology, Faculty of Engineering, Universitas Gadjah Mada. IJITEE (International Journal of Information Technology and Electrical Engineering) invites manuscripts in the various topics include, but not limited to, Information Technology, Power Systems, Digital Signal Processing, Communication Systems
Arjuna Subject : Teknik (semua kategori) - Teknik Listrik dan Elektro
Articles 5 Documents
 1 
Search results for , issue "Vol 2, No 4 (2018): December 2018" : 5 Documents clear
One-Input Three-Output Current-Mode Universal Filter Using Translinear Current Conveyors Montree Kumngern
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 2, No 4 (2018): December 2018
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (984.612 KB) | DOI: 10.22146/ijitee.40843

Abstract

This paper presents a new current-mode universal filter with one-input three-output employing three translinear current conveyors and two grounded capacitors. The proposed filter provides low-pass, band-pass, high-pass current response with high output impedance output which can be directly connected for current-mode circuit. The band-pass and all-pass filters can also be obtained. The parameters wo and Q can be controlled separately and electronically by the bias currents of current conveyors. For realizing all filtering functions, no passive and active matching conditions are required. The active and passive sensitivities are low. The characteristic of the proposed circuit can be confirmed by SPICE simulations.
Bandwidth Upgrade in Printed Dipole Antennas Design for LTE Base Station Rahardian Luthfi Prasetyo; Iswandi Iswandi; Eny Sukani Rahayu
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 2, No 4 (2018): December 2018
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1666.657 KB) | DOI: 10.22146/ijitee.43842

Abstract

Abstract—In this study the research design development has been carried out by changing the radiating element field width. Radiating element field extension was administered by simulating it and trying to measure the value one by one in antenna simulator software.  The radiating element widening was administered so that the resulting bandwidth could be greater. After changing the width of the field, an element radiating field length adjustment was administered to adjust the operating frequency used in Indonesia. After the design worked at the desired frequency and produced a desired bandwidth, antenna fabrication was administered and its results was tested using Mini VNA Tiny to find out the antenna value if mass produced.
PTS and AICF Combined PAPR Reduction Techniques in Multi-Antenna OFDM Systems Arifin Arifin; Silvi Fitriah Ditasari; Yoedy Moegiharto; Ida Anisah; Hendy Briantoro
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 2, No 4 (2018): December 2018
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (945.825 KB) | DOI: 10.22146/ijitee.43846

Abstract

A high PAPR value is one of important weaknesses in OFDM systems. Several reduction techniques are applied to reduce PAPR including partial transmit sequence (PTS) as well as clipping and filtering (CF). Adaptive iterative clipping and filtering is a development of iterative clipping and filtering techniques. In this paper, a combination of Partial transmits sequence and adaptive iterative clipping filtering (PTS-AICF) techniques on multi-antenna OFDM transmitters was carried out. The simulation results showed that combined technique application had a better performance than non-combined technique (PTS), either for two or four antennas, and also for different sub block numbers. Performance was also influenced by iterations number on AICF section, the more iterations were used, the better the reduction technique performance was because it produced smaller PAPR 0 value.
Page Load Time Speed Increase on Disease Outbreak Investigation Information System Website Rahmat Oktrifianto; Dani Adhipta; Warsun Najib
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 2, No 4 (2018): December 2018
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1020.179 KB) | DOI: 10.22146/ijitee.46599

Abstract

Outbreaks or extraordinary events often become an issue that occurs in Indonesia. Therefore, an outbreak investigation information system is required to collect, manage and analyze data quickly and accurately. On the other hand, challenges in data accessing processes in certain locations are still constrained by a slow internet connection. This paper conducted speed increase of a page load or site speed time from disease outbreaks investigation information system website.Page load time speed testing was carried out using Google Chrome Developer Tools and using simulation speeds of 2.5 Mbps. Testing time was carried out by dividing the time into three sections, morning hours, working hours and night hours. Implementation of page load time increase includes reducing HTTP requests, utilizing GZIP compression, performing code minification, setting browser chache, using CDN, and using other enhancement techniques.The results showed that after implementing an increase in page load time by turning off cache and using cache, there was an increase in site speed. When the browser cache was turned off, an average page load time increased of 54.79% from the previous time. Whereas when using the browser cache, page load time speed increased by 55.28% from the previous time.
Ant Colony Optimization for Resolving Unit Commitment Issues by Considering Reliability Constraints Alan Abdu Robbi Afifi; Sarjiya Sarjiya; Yusuf Susilo Wijoyo
IJITEE (International Journal of Information Technology and Electrical Engineering) Vol 2, No 4 (2018): December 2018
Publisher : Department of Electrical Engineering and Information Technology,Faculty of Engineering UGM

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (959.129 KB) | DOI: 10.22146/ijitee.49422

Abstract

Unit Commitment or generator scheduling is one of complex combination issues aiming to obtain the cheapest generating power total costs. Ant Colony Optimization is proposed as a method to solve Unit Commitment issues because it has a better result convergence according to one of journals that reviews methods to solve Unit Commitment issues. Ant Colony Optimization modification into Nodal Ant Colony Optimization as well as addition of several elements are also conducted to overcome Ant Colony Optimization limitations in resolving Unit Commitment issues. Nodal Ant Colony Optimization simulations are then compared with Genetic Algorithm and Simulated Annealing methods which previously has similar simulations. Reliability index combination in a form of Loss of Load Probability and Expected Unserved Energy are also added as reliability constraints in the system. Comparison of three methods shows that Nodal Ant Colony Optimization is able to provide better results up to 0.08% cheaper than Genetic Algorithm or Simulated Annealing methods.

Page 1 of 1 | Total Record : 5

 1 

Filter by Year

2019 2019


Reset
Filter By Issues
All Issue Vol 5, No 4 (2021): December 2021 Vol 5, No 3 (2021): September 2021 Vol 5, No 2 (2021): June 2021 Vol 5, No 1 (2021): March 2021 Vol 4, No 3 (2020): September 2020 (in progress) Vol 4, No 2 (2020): June 2020 Vol 4, No 1 (2020): March 2020 Vol 3, No 4 (2019): Desember 2019 Vol 3, No 3 (2019): September 2019 Vol 3, No 2 (2019): June 2019 Vol 3, No 1 (2019): March 2019 Vol 2, No 4 (2018): December 2018 Vol 2, No 3 (2018): September 2018 Vol 2, No 2 (2018): June 2018 Vol 2, No 1 (2018): March 2018 Vol 1, No 4 (2017): December 2017 Vol 1, No 3 (2017): September 2017 Vol 1, No 2 (2017): June 2017 Vol 1, No 1 (2017): March 2017 More Issue