Claim Missing Document
Check
Articles

Found 3 Documents
Search

ANALISA KEMAMPUAN DAN KINETIKA ADSORPSI KARBON AKTIF DARI CANGKANG KETAPANG TERHADAP ZAT WARNA METIL ORANYE Eko Ariyanto; Dian Dwi Lestari; Dian Kharismadewi
Jurnal Dinamika Penelitian Industri Vol 32, No 2 (2021): JURNAL DINAMIKA PENELITIAN INDUSTRI
Publisher : Balai Riset dan Standardisasi Industri Palembang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28959/jdpi.v32i2.7028

Abstract

Ketapang (Terminalia catappa) merupakan tanaman pohon peneduh yang banyak ditanam di taman dan tepi jalan. Buah bercangkang keras dari pohon ketapang ini belum banyak dimanfaatkan oleh masyarakat, karenanya potensi pemanfaatannya masih terus diteliti. Cangkang buah ketapang dijadikan sebagai adsorben untuk menyerap zat warna metil oranye (MO) pada penelitian ini. Cangkang ketapang dibuat menjadi karbon aktif dengan diaktivasi menggunakan asam klorida 0,1 M. Penelitian ini bertujuan untuk mengetahui kapasitas adsorpsi dari karbon aktif yang telah diaktivasi dan mempelajari kinetika adsorpsinya, sehingga dapat dimanfaatkan sebagai adsorben dalam menanggulangi pencemaran air. Standar baku mutu SNI 06-3730-1995 digunakan untuk menguji karbon aktif yang dihasilkan yaitu untuk uji kadar air, abu, zat terbang, dan daya serap iodium. Hasil analisa uji mutu karbon aktif yang dihasilkan didapatkan persentase nilai kadar air sebesar 2,87%, kadar abu sebesar 0,66%, kadar zat terbang sebesar 14,55%, dan daya serap iodium sebesar 818,90 mg/g. Morfologi dan pori permukaan karbon aktif dikarakterisasi menggunakan Scanning Electron Microscopy, dimana didapatkan ukuran pori setelah diaktivasi yaitu antara 6 – 14 mm. Hasil analisa adsorpsi zat warna metil oranye didapatkan kapasitas adsorpsi optimum sebesar 3,77 mg/g pada pH 4,2 dan waktu optimum 15 menit. Proses adsorpsi dari karbon aktif cangkang ketapang mengikuti model kinetika Lagergren pseudo orde satu dengan nilai R2 sebesar 0,993 dan memenuhi model isoterm Freundlich dengan nilai R2 sebesar 0,984.
ANALYSIS THE EFFICIENCY OF BOILER 2011 UA WATER TUBE TYPE AT PT PERTAMINA RU III (PERSERO) PLAJU Dian Dwi Lestari; Isdaryanto Iskandar; Wendi Wendi
International Journal of Social Science Vol. 2 No. 4: December 2022
Publisher : Bajang Institute

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.53625/ijss.v2i4.4164

Abstract

One of the most important tools in steam production in the oil and gas industry is a boiler. Along with the increasing demand for steam, it is necessary to think about ways to increase the efficiency of the boiler. A boiler or steam boiler is a closed vessel-shaped device used to produce steam or steam. Boilers are designed to transfer heat from a combustion source. With Used the direct method (Direct Method) to calculate boiler efficiency. The pressure and temperature data of the feed water and steam is processed through the data interpolation process to obtain the enthalpy value of the feed water and steam enthalpy. Based on the calculation results obtained boiler efficiency results of 78.11%, 78.27%, and 79.75% with an average efficiency of 78.71%, and from the results of boiler efficiency calculations from the report of PT Pertamina RU III (Persero) obtained results of 89,75% in 1991. The efficiency of the above boiler has decreased by 11.04%. The decrease was caused by several factors, namely shells, valves, and instrumentation that had been eaten by age and damaged tubes.
PENENTUAN JUMLAH CAIRAN GLYCOL PADA PROSES DEHIDRASI GAS DI STASIUN PENGUMPUL GMB Dwi Putri Lestari; Dian Dwi Lestari
NETIZEN: JOURNAL OF SOCIETY AND BUSSINESS Vol. 1 No. 9 (2025): AGUSTUS
Publisher : CV. ADIBA AISHA AMIRA

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

In the activities of the Station PT Pertamina Hulu Rokan Regional I Zone 4 Alpa Field uses a separation system to separate fluids and gas. One of them is by using a Dehydration Unit (DHU) in the form of scrubbers, contactors, glycol storage tanks, flash tanks, carbon filters, particular filters, heat exchangers, still columns, reboilers, and accumulators. The purpose of this study is to determine the factors that cause glycol losses. The method used in this study is to technically examine the condition of the dehydration device, control the circulation rate and calculate the circulation rate. The DHU system uses the chemical TEG (Triethylene Glycol) which will continue to be added during the dehydration process. The large number of chemical uses is due to the incompatibility of the wet gas inlet with the glycol flow rate in the contactor. In March 2023 the actual flow rate is 12 gallons per minute (GPM) during the regeneration process. Meanwhile, the flow rate obtained from the glycol circulation rate formula only reached 4.39 GPM. This causes frequent losses when contacting the contactor because the incoming circulation rate is not the same as that coming out. The use of glycol per day reaches 9.4 gallons, while the standard losses are only 0.3 gallons. From these results it is known that the difference in the glycol flow rate with the calculation results is that there is an error in the flow rate (pump rate) in the field which results in losses.