Article Per Year (5 Year)
p-Index From 2021 - 2026
0.23
P-Index
This Author published in this journals
All Journal Jurnal Teknik Mesin, Industri, Elektro dan Informatika
Nur Aeni Ramadhani
Universitas Singaperbangsa Karawang
Computer Science & IT Electrical & Electronics Engineering Industrial & Manufacturing Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Pengaruh Proses Surface Treatment Anodizing terhadap Surface Roughness dan Densitas Aluminium 5058 Nur Aeni Ramadhani; Deri Teguh Santoso; Kosim Abdurohman
Jurnal Teknik Mesin, Industri, Elektro dan Informatika Vol. 5 No. 2 (2026): Jurnal Teknik Mesin, Industri, Elektro dan Informatika
Publisher : Lembaga Pengembangan Kinerja Dosen

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.55606/jtmei.v5i2.6160

Abstract

Aluminum 5058 is widely used in engineering components because it has low density, good corrosion resistance, and stable surface performance. However, anodizing can change its surface characteristics through an electrochemical oxidation reaction that forms an aluminum oxide layer and modifies surface topography. This study aims to analyze the effect of anodizing on the surface roughness and density of aluminum 5058 compared with non-treatment specimens. The research used a quantitative experimental method with aluminum specimens measuring 2×2 cm. Surface roughness was tested at the BRIN Laboratory according to ISO 21920-2:2021 at three measurement points using , , and  parameters, while density was measured using the Archimedes method. The results showed that anodized specimens had average values of  0.59 µm,  4.78 µm, and  0.77 µm, whereas non-treatment specimens had  0.20 µm,  1.54 µm, and  0.28 µm. These results indicate that anodizing forms a rougher oxide texture on the aluminum surface. Density testing showed values of 2.7058 g/cm³ for non-treatment specimens and 2.7088 g/cm³ for anodized specimens, with a very small difference of 0.0030 g/cm³. Therefore, anodizing significantly affects surface topography but does not substantially change material density. This finding confirms that anodizing is mainly a surface modification process.
Co-Authors Deri Teguh Santoso Kosim Abdurohman