Claim Missing Document
Check
Articles

Found 1 Documents
Search

Analysis of the Effect of Post-Printing Treatment of 3D Printer DLP Machine for Polylactic Acid on Surface Hardness I.A. Rosid; P.N.N. Pratama; G.S. Dewi; M.G.D. Jatiningsih; S.D. Auvia; C. Finansia; N.P. Al-Bana
Dinamika Teknik Mesin Vol 16, No 2 (2026): Dinamika Teknik Mesin: Jurnal Keilmuan dan Terapan Teknik Mesin
Publisher : Universitas Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29303/dtm.v16i2.1326

Abstract

This study aims to determine the effects of factors and levels, specifically, exposure times of 30 and 60 minutes; low and high spinning speeds; and washing times of 5 and 10 minutes on surface hardness using a 2k full factorial design. Statistical analysis revealed that the Washing Time factor had a statistically significant effect on surface hardness with a P-value of 0.036 (alpha = 0.05). Increasing the washing time from 5 to 10 minutes increased the mean surface hardness from 85.31 to 86.19 Shore D, or approximately 1.04%, indicating a statistically significant but modest practical effect within the tested experimental range. Meanwhile, the factors Exposure Time and Spinning Speed, as well as all interactions between the factors, did not have a statistically significant effect on surface hardness. The relatively low R-squared of 36.63% and predicted R-squared of 0.00% indicate that the model has limited explanatory and predictive capability. Residual analysis showed that the assumptions of normality and independence of the residuals were met. Overall, washing time showed a statistically significant but modest effect on surface hardness. Given the limited explanatory and predictive capability of the model, these findings should be interpreted only within the tested experimental range.