Chanachai Thongchom
Department of Civil Engineering, Faculty of Engineering, Thammasat School of Engineering, Thammasat University, Pathumthani 12120

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Damage-Sensitive Mechanical and Transport Properties of Concrete Under Cryogenic Exposure Akkadath Abdulmatin; Penpichcha K. Sanit-in; Pitchayut Sanguthai; Sutep Sachdav; Suban Sanit-in; Weerachart Tangchirapat; Chai Jaturapitakkul; Chanachai Thongchom
Civil Engineering Journal Vol. 12 No. 9 (2026): September
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-09-09

Abstract

This study investigates the residual performance of concrete after repeated cryogenic thermal shock and evaluates how water-to-binder (W/B) ratio, binder content, and fly ash replacement influence damage development. Seven concrete mixtures were tested at 28 days after up to three 1-hour liquid-nitrogen immersion cycles. Compressive strength, elastic modulus, reinforcing-bar bond strength and slip, length change, void content, and water permeability were examined to characterize load-bearing capacity, stiffness, interfacial behavior, deformation, and transport integrity. After three cycles, the control mixture retained 84% of its initial compressive strength but only 46% of its elastic modulus, demonstrating that stiffness was more sensitive to accumulated internal damage. First-cycle compressive-strength retention ranged from 65% to 99%, with mixtures having lower W/B ratio and higher binder content generally showing better retention. Bond strength decreased more modestly, whereas length-change records revealed rapid expansion during immersion and residual deformation after recovery. Void content increased after exposure, and measurable permeability generally increased, indicating development of connected transport paths; values unavailable after cracking were reported as N/A. The combined results show that elastic modulus, deformation, and transport properties complement compressive strength in assessing cryogenic damage and support performance-based selection of concrete mixtures for LNG-related structures.
Composite Damage Mechanics of Beams on Winkler–Pasternak Foundations: A Two-Mechanism Stiffness Degradation Model Piti Sukontasukkul; Worathep Sae-Long; Suchart Limkatanyu; Amorn Pimanmas; Chanachai Thongchom; Thanet Thongdetsri; Jaroon Rungamornrat
Civil Engineering Journal Vol. 12 No. 10 (2026): October
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-010-07

Abstract

This study develops a two-mechanism composite damage model for Euler–Bernoulli beams on Winkler–Pasternak foundations. Damage is introduced independently into the Winkler spring layer and the Pasternak shear layer through separate damaged volume fractions, and the corresponding effective stiffnesses are evaluated using the Voigt, Reuss, and generalized self-consistent-inspired formulations. The governing differential equation and boundary conditions are derived using the principle of virtual displacement, and analytical solutions are obtained for uniformly damaged foundations. Under the undamaged condition, the present solution reproduces the reference Winkler–Pasternak bending-moment response. For the baseline simulations, the residual Winkler and Pasternak stiffnesses are prescribed as approximately 50% of their corresponding intact values. With the Pasternak damaged volume fraction fixed at = 0.5, the normalized damage ratio  is varied from 0 to 1, corresponding to an increase in the Winkler damaged volume fraction from = 0 to 0.5. Over this range, the midspan deflection increases from 7.775 to 9.977 mm for the Voigt model and from 7.798 to 11.099 mm for the Reuss model, corresponding to increases of 28.32% and 42.33%, respectively. The corresponding increases in maximum bending moment are 1.98% and 2.74%. The proposed predictions remain between the Voigt and Reuss bounds. The results further indicate that the Winkler interaction primarily affects beam deflection, whereas the Pasternak interaction has a comparatively greater influence on bending-moment redistribution.