Piti Sukontasukkul
Construction and Building Materials Research Center, Department of Civil Engineering, King Mongkut’s University of Technology North Bangkok, Bangkok 10800

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Impact Response of RC Beams Under Mass–Velocity Variations and Axial Compression: Constitutive Model Comparison Nutchanok Ueatrongchit; Chinnapat Buachart; Worathep Sae-Long; Piti Sukontasukkul; Panatchai Chetchotisak; Suchart Limkatanyu; Chayanon Hansapinyo
Civil Engineering Journal Vol. 12 No. 10 (2026): October
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-010-022

Abstract

This study aims to investigate the impact response of reinforced concrete (RC) beams under equal-energy mass–velocity combinations and combined axial compression and to compare the predicted responses obtained from different concrete constitutive models. Nonlinear finite element simulations were performed using LS-DYNA and validated against a published drop-weight impact experiment. Three concrete models, KCC (*MAT_072R3), CSCM (*MAT_159), and Winfrith (*MAT_084), were compared using consistent fundamental material properties. Five mass–velocity combinations, ranging from 50 kg–13.72 m/s to 1000 kg–3.07 m/s at a constant impact energy of approximately 4.7 kJ, and axial compression ratios of 0–30% were investigated. The results show that equal impact energy does not produce equivalent structural responses. Low-mass/high-velocity impacts generated higher peak forces, shorter contact durations, and localized shear-dominated damage, whereas high-mass/low-velocity impacts produced greater displacement and flexural behavior. Increasing axial compression generally increased peak force while reducing displacement and contact duration. The three models predicted similar global responses but showed greater differences in local impact responses, particularly peak force and damage localization. The novelty of this study lies in systematically comparing the predictions of different concrete constitutive models under varying mass–velocity combinations and axial compression, providing guidance for constitutive-model selection in RC impact simulations.
Composite Damage Mechanics of Beams on Winkler–Pasternak Foundations: A Two-Mechanism Stiffness Degradation Model Piti Sukontasukkul; Worathep Sae-Long; Suchart Limkatanyu; Amorn Pimanmas; Chanachai Thongchom; Thanet Thongdetsri; Jaroon Rungamornrat
Civil Engineering Journal Vol. 12 No. 10 (2026): October
Publisher : Salehan Institute of Higher Education

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28991/CEJ-2026-012-010-07

Abstract

This study develops a two-mechanism composite damage model for Euler–Bernoulli beams on Winkler–Pasternak foundations. Damage is introduced independently into the Winkler spring layer and the Pasternak shear layer through separate damaged volume fractions, and the corresponding effective stiffnesses are evaluated using the Voigt, Reuss, and generalized self-consistent-inspired formulations. The governing differential equation and boundary conditions are derived using the principle of virtual displacement, and analytical solutions are obtained for uniformly damaged foundations. Under the undamaged condition, the present solution reproduces the reference Winkler–Pasternak bending-moment response. For the baseline simulations, the residual Winkler and Pasternak stiffnesses are prescribed as approximately 50% of their corresponding intact values. With the Pasternak damaged volume fraction fixed at = 0.5, the normalized damage ratio  is varied from 0 to 1, corresponding to an increase in the Winkler damaged volume fraction from = 0 to 0.5. Over this range, the midspan deflection increases from 7.775 to 9.977 mm for the Voigt model and from 7.798 to 11.099 mm for the Reuss model, corresponding to increases of 28.32% and 42.33%, respectively. The corresponding increases in maximum bending moment are 1.98% and 2.74%. The proposed predictions remain between the Voigt and Reuss bounds. The results further indicate that the Winkler interaction primarily affects beam deflection, whereas the Pasternak interaction has a comparatively greater influence on bending-moment redistribution.