Abstract. Prasetyo MY, Amal I, Hendri M, Shiyan S, Hessami MJ. 2026. Physicomechanical, morphological, and thermal characterization of glycerol-plasticized and chitosan-modified Gracilaria sp. hydrocolloid-based edible films. Biodiversitas 27 (10): d271011. https://doi.org/10.13057/biodiv/d271011. Edible films based on locally sourced Gracilaria sp. hydrocolloid were prepared using glycerol as a plasticizer and chitosan as a reinforcing biopolymer. The seaweed was collected from Ketapang Waters, Lampung, Indonesia, and the films were produced by solvent casting using a fixed hydrocolloid concentration of 2% (w/v), glycerol levels of 0.20, 0.60, and 1.00 mL, and chitosan levels of 1.00, 1.50, and 2.00 g. This work evaluates the characteristics of Ketapang-derived Gracilaria sp. hydrocolloid-based films through physicomechanical, morphological, and thermal characterization. Two-Way ANOVA showed significant glycerol × chitosan interactions for all evaluated physicomechanical properties (p≤0.005), while the significance of the main effects varied by response variables. Dry film yield ranged from 30.60% to 62.60%, with formulation H giving the highest recovery. Film thickness ranged from 0.09 to 0.21 mm, while tensile strength ranged from 4.7 to 12.0 MPa, with formulation I showing the strongest tensile performance. All formulations had thicknesses below the selected JIS Z 1707 reference value and tensile strengths above the corresponding reference value. However, elongation at break remained very low (1.40% to 3.10%), indicating that flexibility remained the main limitation. SEM showed heterogeneous surfaces with pores, cracks, cavities, and particle agglomeration, suggesting the matrix was not uniform. TGA indicated an initial moisture-related mass loss of 8.5-15.4% and a residual mass at 600°C of 12.9-19.6%, reflecting the presence of retained moisture, volatile components, and thermally stable residues in the crude seaweed-based hydrocolloid films. These findings indicate that Ketapang-derived Gracilaria sp. hydrocolloid has potential as an experimental edible film material. However, further optimization of the glycerol-chitosan ratio, homogenization, and drying conditions is required to improve flexibility and evaluate its suitability for practical applications.