Biodiversitas Journal of Biological Diversity
Vol. 27 No. 10 (2026)

Physicomechanical, morphological, and thermal characterization of glycerol-plasticized and chitosan-modified Gracilaria sp. hydrocolloid-based edible films

M. YOSI PRASETYO (Program of Environmental Management, Graduate Program, Universitas Sriwijaya. Jl. Padang Selasa No. 524, Palembang 30139, South Sumatra, Indonesia)
IKHLASUL AMAL (Department of Marine Science, Faculty of Mathematics and Natural Sciences, Universitas Sriwijaya. Jl. Raya Palembang-Prabumulih Km. 32, Ogan Ilir 30862, South Sumatra, Indonesia)
MUHAMMAD HENDRI (Department of Marine Science, Faculty of Mathematics and Natural Sciences, Universitas Sriwijaya. Jl. Raya Palembang-Prabumulih Km. 32, Ogan Ilir 30862, South Sumatra, Indonesia)
SHAUM SHIYAN (Department of Pharmacy, Faculty of Mathematics and Natural Sciences, Universitas Sriwijaya. Jl. Raya Palembang-Prabumulih Km. 32, Ogan Ilir 30862, South Sumatra, Indonesia)
MOHAMMAD JAVAD HESSAMI (Faculty of Applied Science, UCSI University. UCSI Heights, Cheras 56000, Kuala Lumpur, Malaysia)



Article Info

Publish Date
31 Oct 2026

Abstract

Abstract. Prasetyo MY, Amal I, Hendri M, Shiyan S, Hessami MJ. 2026. Physicomechanical, morphological, and thermal characterization of glycerol-plasticized and chitosan-modified Gracilaria sp. hydrocolloid-based edible films. Biodiversitas 27 (10): d271011. https://doi.org/10.13057/biodiv/d271011. Edible films based on locally sourced Gracilaria sp. hydrocolloid were prepared using glycerol as a plasticizer and chitosan as a reinforcing biopolymer. The seaweed was collected from Ketapang Waters, Lampung, Indonesia, and the films were produced by solvent casting using a fixed hydrocolloid concentration of 2% (w/v), glycerol levels of 0.20, 0.60, and 1.00 mL, and chitosan levels of 1.00, 1.50, and 2.00 g. This work evaluates the characteristics of Ketapang-derived Gracilaria sp. hydrocolloid-based films through physicomechanical, morphological, and thermal characterization. Two-Way ANOVA showed significant glycerol × chitosan interactions for all evaluated physicomechanical properties (p≤0.005), while the significance of the main effects varied by response variables. Dry film yield ranged from 30.60% to 62.60%, with formulation H giving the highest recovery. Film thickness ranged from 0.09 to 0.21 mm, while tensile strength ranged from 4.7 to 12.0 MPa, with formulation I showing the strongest tensile performance. All formulations had thicknesses below the selected JIS Z 1707 reference value and tensile strengths above the corresponding reference value. However, elongation at break remained very low (1.40% to 3.10%), indicating that flexibility remained the main limitation. SEM showed heterogeneous surfaces with pores, cracks, cavities, and particle agglomeration, suggesting the matrix was not uniform. TGA indicated an initial moisture-related mass loss of 8.5-15.4% and a residual mass at 600°C of 12.9-19.6%, reflecting the presence of retained moisture, volatile components, and thermally stable residues in the crude seaweed-based hydrocolloid films. These findings indicate that Ketapang-derived Gracilaria sp. hydrocolloid has potential as an experimental edible film material. However, further optimization of the glycerol-chitosan ratio, homogenization, and drying conditions is required to improve flexibility and evaluate its suitability for practical applications.

Copyrights © 2026






Journal Info

Abbrev

biodiv

Publisher

Subject

Agriculture, Biological Sciences & Forestry Biochemistry, Genetics & Molecular Biology

Description

The Biodiversitas Journal was first published in 2000 by the Department of Biology, FMNS, Universitas Sebelas Maret, Surakarta, Indonesia, then in 2006 it was co-published by the Society for Indonesian Biodiversity and that department; since 2017 it was also hosted by Smujo. From 2003-2012 it was ...