Claim Missing Document
Check
Articles

Found 1 Documents
Search

PROSES PEMBUATAN PART BRACKET CABLE CLAMP MENGGUNAKAN MESIN STAMPING PRESS DI PT. TRI JAYA TEKNIK KARAWANG Ridho Maulana Padmawidjaya; Dony Susandi
SEMINAR TEKNOLOGI MAJALENGKA (STIMA) Vol 10 (2026)
Publisher : Universitas Majalengka

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

This article describes the manufacturing process of the Bracket Cable Clamp using mechanical stamping presses at PT. Tri Jaya Teknik Karawang. The component is produced from SPCC steel according to JIS G 3141 with a working material size of 1.4 mm × 142 mm × 1219 mm. The production sequence consists of planning, material preparation, die selection and installation, die-height setting, blanking, three bending stages, two piercing stages, quality control, and final product inspection. Four dies are used: two single-station dies for blanking and the third bending stage, and two combination dies for bending stages 1-2 and piercing stages 1-2. The blanking and piercing operations use a 110-ton SHING TAI press, while the bending operations use a 150-ton AIDA press. Experimental die-height adjustment produced standard settings of 329 mm for blanking, 336 mm for bending, and 350 mm for piercing. Calculated forming forces were 25.7 kN for blanking, 7.13 kN for bending stages 1-2, 1.69 kN for bending stage 3, and 17.94 kN for piercing. The allowable punch-die clearance for 1.4 mm SPCC was 0.07-0.112 mm. Production observation recorded an average output of 300 pieces per hour with a cycle time of about 12 seconds per piece. Final inspection using visual checks, dimensional measurements, and a JIG fixture confirmed that accepted parts met the specified geometry and quality requirements.