SEMINAR TEKNOLOGI MAJALENGKA (STIMA)
Vol 10 (2026)

PROSES PEMBUATAN PART BRACKET CABLE CLAMP MENGGUNAKAN MESIN STAMPING PRESS DI PT. TRI JAYA TEKNIK KARAWANG

Ridho Maulana Padmawidjaya (Fakultas Teknik, Universitas Majalengka)
Dony Susandi (fa)



Article Info

Publish Date
01 Oct 2026

Abstract

This article describes the manufacturing process of the Bracket Cable Clamp using mechanical stamping presses at PT. Tri Jaya Teknik Karawang. The component is produced from SPCC steel according to JIS G 3141 with a working material size of 1.4 mm × 142 mm × 1219 mm. The production sequence consists of planning, material preparation, die selection and installation, die-height setting, blanking, three bending stages, two piercing stages, quality control, and final product inspection. Four dies are used: two single-station dies for blanking and the third bending stage, and two combination dies for bending stages 1-2 and piercing stages 1-2. The blanking and piercing operations use a 110-ton SHING TAI press, while the bending operations use a 150-ton AIDA press. Experimental die-height adjustment produced standard settings of 329 mm for blanking, 336 mm for bending, and 350 mm for piercing. Calculated forming forces were 25.7 kN for blanking, 7.13 kN for bending stages 1-2, 1.69 kN for bending stage 3, and 17.94 kN for piercing. The allowable punch-die clearance for 1.4 mm SPCC was 0.07-0.112 mm. Production observation recorded an average output of 300 pieces per hour with a cycle time of about 12 seconds per piece. Final inspection using visual checks, dimensional measurements, and a JIG fixture confirmed that accepted parts met the specified geometry and quality requirements.

Copyrights © 2026






Journal Info

Abbrev

stima

Publisher

Subject

Computer Science & IT Control & Systems Engineering Industrial & Manufacturing Engineering Mechanical Engineering Transportation

Description

Prosiding SEMINAR TEKNOLOGI MAJALENGKA (STIMA) adalah publikasi ilmiah yang memuat hasil-hasil penelitian orisinal dan terkini dari para akademisi, peneliti, dan praktisi di berbagai bidang teknik dan manajemen. Prosiding ini memiliki sifat multidisiplin, berfokus pada integrasi ilmu pengetahuan ...