Article Per Year (5 Year)
p-Index From 2021 - 2026
0.23
P-Index
This Author published in this journals
All Journal Jurnal Mekanova : Mekanikal, Inovasi dan Teknologi
Rusdi Kaimuddin
Unknown Affiliation
Aerospace Engineering Automotive Engineering Engineering Industrial & Manufacturing Engineering Mechanical Engineering

Published : 1 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 1 Documents
Search

 1 
Evaluasi Sudut Potong Pahat Bubut terhadap Kekasaran Permukaan Poros Baja AISI 1045 Hasil Build-up Welding SMAW Zainal Sudirman; Laode Abdul Gamsir; Astuty Astuty; Rusdi Kaimuddin
Jurnal Mekanova : Mekanikal, Inovasi dan Teknologi Vol 12, No 2 (2026): Oktober
Publisher : universitas teuku umar

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35308/jmkn.v12i2.16642

Abstract

Carried out through the build-up welding process, followed by turning to restore the component dimensions and surface quality. One of the challenges encountered is obtaining a smooth turned surface on materials that have undergone welding. Tool geometry, particularly the cutting angle, is one of the factors that may affect cutting forces, process stability, chip formation, and surface quality. This study aimed to evaluate and compare the surface roughness of an AISI 1045 steel shaft after SMAW build-up welding using three turning tool angle configurations, namely 65°, 75°, and 85°, under the applied cutting conditions. The experimental study used an AISI 1045 steel shaft with an initial diameter of 36 mm. The build-up welding process was performed using an RD-460 E6013 electrode with a diameter of 3.2 mm and a welding current of 116 A. Turning was carried out using a conventional lathe at a spindle speed of 225 rpm and a depth of cut of 2 mm. Surface roughness was measured using a Mitutoyo SJ-310 roughness tester, with two measurements taken for each configuration. The results showed that the average surface roughness values for tool angles of 85°, 75°, and 65° were 1.19 µm, 1.80 µm, and 7.46 µm, respectively. The lowest surface roughness was obtained at a tool angle of 85°, whereas the highest was recorded at 65°. These results indicate that the 85° tool angle produced the smoothest surface among the three angle configurations tested. Keywords— ST-45 steel, SMAW, build-up welding, lathe machine, cutting angle, surface roughness.
Co-Authors Astuty Astuty Laode Abdul Gamsir Zainal Sudirman