Claim Missing Document
Check
Articles

Found 4 Documents
Search

MEMPERKIRAKAN KEDALAM RETAK PADA BETON MENGGUNAKAN GELOMBANG ULTRASONIK Linggasari, Dewi
Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan Vol 3, No 1 (2019): Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan
Publisher : Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmstkik.v3i1.3912

Abstract

Tulisan ini mendiskusikan penggunaan gelombang ultrasonik untuk memperkirakan kedalaman retak terbuka. Teknik yang digunakan sangat berguna dalam pekerjaan di lapangan.  Metode pengukuran menggunakan dua metode acuan  yaitu standard BS 1881 bagian 203 sebagai metode 1 dan manual buku pada alat PUNDIT CNS Electronics sebagai metode ke 2, dengan gambaran persamaan matematika untuk menentukan kedalaman retak terbuka. Gelombang ultrasonik bekerja didasarkan pada pengukuran waktu tempuh gelombang ultrasonik yang menjalar dalam struktur beton. Gelombang ultrasonik disalurkan dari pengirim yang ditempatkan dipermukaan beton melalui material beton menuju penerima dan waktu tempuh gelombang tersebut diukur oleh Read-Out unit  dalam mikro detik. Sejumlah balok uji disiapkan dengan penandaan arah keretakan untuk pengukuran. Hasil pengujian menunjukkan kedua metode yang digunakan untuk mengukur kedalaman keretakan memiliki  kesesuain hasil antar satu terhadap yang lainnya. This paper discusses the use of ultrasonic waves to estimate the depth of open cracks. The technique used is very useful in work in the field. The measurement method uses two reference methods namely standard BS 1881 section 203 as method 1 and the book manual on the PUNDIT CNS Electronics tool as the second method, with an overview of mathematical equations to determine the depth of open cracks. Ultrasonic waves work based on measurements of the travel time of ultrasonic waves that propagate in concrete structures. Ultrasonic waves are transmitted from the sender placed on the concrete surface through concrete material to the receiver and the wave travel time is measured by the Read-Out unit in micro seconds. A number of test beams were prepared by marking the direction of the crack for measurement. The test results show that the two methods used to measure the depth of the crack have the suitability of the results between one another.
MEMPERKIRAKAN PERBANDINGAN KADAR AIR SEMEN PADA BETON KERAS Kushartomo, Widodo; Sutandi, Arianti; Linggasari, Dewi
Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan Vol 4, No 1 (2020): Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan
Publisher : Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmstkik.v4i1.7416

Abstract

Comparison of cement water content (w / c-ratio) is one important factor to determine the strength of concrete, so it is important to know the ratio of the amount of water used in a concrete mix. Many problems that arise related to the quality of concrete in ready-made buildings require an in-depth investigation of the composition of concrete materials in order to estimate the quality of concrete including the ratio of the amount of water to cement. Estimating the ratio of the amount of water to the amount of cement in hard concrete is not an easy matter, there are many factors that influence it. A number of special tests are needed on hard concrete to get the accuracy of the ratio of cement water content (w / c-ratio). A number of test specimens were prepared for testing with known water content and amount of cement. After going through the treatment process for 28 days, at the age of 60 days all test specimens are examined both chemically and volumetricly to recalculate the amount of water and cement that has been used. The calculation results show the technique used has a suitability of 99% to the planning. ABSTRAKPerbandingan kadar air semen (w/c-ratio) merupakan salah satu faktor penting untuk menentukan kekuatan beton, sehingga penting sekali mengetahui perbandingan jumlah air yang digunakan dalam suatu adukan beton. Banyak permasalahan yang muncul terkait mutu beton pada bangunan yang sudah jadi memerlukan penyelidikan     yang mendalam terhadap komposisi material beton tersebut guna memperkirakan mutu beton termasuk didalamnya perbandingan jumlah air terhadap semen. Memperkirakan perbandingan jumlah air terhadap jumlah semen pada beton keras bukan merupakan suatu perkara yang mudah, ada banyak faktor yang mempengaruhinya. Diperlukan sejumlah pengujian khusus pada beton keras untuk mendapatkan akurasi nilai perbandingan kadar air semen (w/c-ratio). Sejumlah benda uji disiapkan untuk pengujian dengan kadar air dan jumlah semen yang telah diketahui. Setelah melalui proses perawatan selama 28 hari, pada umur 60 hari seluruh benda uji diperiksa baik secara kimiawi maupun secara volumetrik untuk menghitung ulang jumlah air dan semen yang telah digunakan. Hasil perhitungan menunjukkan teknik yang digunakan  memiliki kesesuaian sebesar 99% terhadap perencanaan.
Effek Ukuran Butiran Maksimum terhadap Nilai Modulus of Rupture Reactive Powder Concrete Kushartomo, Widodo; Linggasari, Dewi; Sutandi, Arianti
MEDIA KOMUNIKASI TEKNIK SIPIL Volume 26, Nomor 1, JULI 2020
Publisher : Department of Civil Engineering, Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (588.359 KB) | DOI: 10.14710/mkts.v26i1.25088

Abstract

Modulus of rupture (R) is a measurement of a tensile strengh of a concrete beam. The value of R is affected by the size of fine aggregat grain, the density of the concrete beam and the water-cement ratio. The unit of R is MPa expressing the tensile strength of the concrete beam without reinforcement to withstand a buckling failure. The distance between the supports of the concrete beam should not be less than three times of the height of the beam. In this research the size of the concrete beam speciment was 100 mm x 100 mm x 350 mm, the maximum fine aggregate size was varied (300 µm, 425 µm, and 600 µm) and the water-cement ratio was also varied (0.25, 0.22 and 0,20). All speciments were cured by steam curing and were tested after seven days. The results show that the larger the size of the fine aggregat grain and the higher the water-cement ratio, the smaller the R.
OPTIMASI BIAYA PENCAPAIAN PREDIKAT BANGUNAN HIJAU PADA BANGUNAN TERBANGUN Linggasari, Dewi
Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan Vol 3, No 2 (2019): Jurnal Muara Sains, Teknologi, Kedokteran dan Ilmu Kesehatan
Publisher : Universitas Tarumanagara

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24912/jmstkik.v3i2.5941

Abstract

Existing buildings are buildings that have operated for at least a year after construction. Green building concept application on buildings is aimed to maintain environment continuity, which is absolutely needed to prevent damage to human habitat and to create a continuous ecosystem to be inherited by the generations to come. A building can be categorized as green building if it fulfills the green building assessment criteria. This becomes a challenge in itself if a building succeeds to achieve Green Building Predicate. The efforts made to achieve Green Building Predicate, of course, requires funding. Therefore, optimal funding to achieve Green Building Predicate according to Greenship “Green Building Assessment Device for Existing Building version 1.0” needs to be determined. To achieve maximum quality enhancement with minimum cost, value consideration on each criteria is needed. Value consideration on each criteria that is determined is done based on five levels which are referred to as level 1 to 5. Each value consideration level has criteria based on value achievement difficulty level as well as amount of funding needed to achieve it. Based on analysis results, buildings J, L, K, and R achieved Gold Predicate, and building M achieved Silver Predicate with additional funding of 16.61%. To achieve that predicate, the building must fulfill the value consideration level that is included in criteria level 1+2, which is a criteria that is achieved relatively easily and without large funding, as well as criteria that is achieved relatively easily but includes obstacles in it’s application. Other enhancements that are done is considered ineffective because enhancement cost isn’t proportional to the resulted value. ABSTRAKBangunan terbangun yaitu bangunan yang sudah lama beroperasi minimal satu tahun setelah gedung selesai dibangun. Penerapan konsep Bangunan Hijau pada bangunan bertujuan untuk menjaga keberlanjutan lingkungan, yang mutlak diperlukan untuk mencegah rusaknya habitat manusia dan untuk menciptakan suatu ekosistem yang berkelanjutan agar dapat diwariskan kepada generasi yang akan datang. Suatu bangunan dapat dikategorikan sebagai bangunan hijau apabila telah memenuhi kriteria-kriteria penilaian bangunan hijau. Menjadi tantangan tersendiri apabila suatu bangunan berhasil memperoleh Predikat Bangunan Hijau. Upaya yang dilakukan untuk memperoleh Predikat Bangunan Hijau tersebut tentunya membutuhkan biaya. Dengan demikian perlu ditentukan biaya optimal untuk mencapai tingkat Predikat Bangunan Hijau sesuai Greenship "Perangkat Penilaian Bangunan Hijau untuk Gedung Terbangun versi 1.0". Untuk mencapai peningkatan nilai yang maksimum dengan biaya yang minimum perlu adanya pertimbangan penilaian pada setiap kriteria. Pertimbangan penilaian setiap kriteria yang ditetapkan dilakukan berdasarkan lima tingkat yaitu tingkat 1 sampai tingkat 5. Masing-masing tingkat pertimbangan nilai memiliki kriteria yang didasarkan pada tingkat kesulitan pencapaian nilai serta besaran biaya yang dibutuhkan untuk mencapainya. Berdasarkan hasil analisis, bangunan J, L, K, R memperoleh Predikat Gold dan Gedung M memperoleh Predikat Silver dengan tambahan biaya sebesar 16,61%. Untuk mencapai predikat tersebut maka gedung harus memenuhi tingkat pertimbangan nilai yang termasuk dalam kriteria tingkat 1+2, yaitu kriteria yang pencapaiannya relatif mudah dan tanpa biaya besar, serta kriteria yang untuk pencapaiannya relatif mudah tapi terdapat hambatan dalam penerapannya. Peningkatan lain yang dilakukan dipandang tidak efektif karena biaya peningkatan tidak sesuai dengan nilai yang dihasilkan.