Claim Missing Document
Check
Articles

Found 4 Documents
Search

Analisis Perkuatan Lereng Menggunakan Finite Element Method Ongko, Andarsin; Nugroho, Soewignjo Agus; Yusa, Muhamad
Jurnal Online Mahasiswa (JOM) Bidang Teknik dan Sains Vol 5 (2018): Edisi 2 Juli s/d Desember 2018
Publisher : Jurnal Online Mahasiswa (JOM) Bidang Teknik dan Sains

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Landslides are ones of disasters which oftenly occurred in Indonesia. This research aims to analyze some slope reinforcements which are modeled by using a based finite element method software, i.e. plaxis v.8.2. As initial data, slope`s dimension was measured from real field, and soil samples were taken to obtain the soil properties. Those data were used as input parameters in modeling. The slope was modeled in several conditions, i.e. existing condition, variation of ground water table, reinforcement with backfill model, terraces model, and soil nailing model. The results shown that safety factor has decreased due to the increment of ground water table. The highest safety factor was reached when the slope was reinforced with soil noiling model, with the magnitude of 2,044.Keywords : landslides, finite element method, soil nailing, safety factor.
Behavior of High-plasticity Clay Stabilized with Lime and Rice Husk Ash Fatnanta, Ferry; Nugroho, Soewignjo Agus; Ongko, Andarsin; Ihsan, Adnan Ruziq
Makara Journal of Technology Vol. 25, No. 3
Publisher : UI Scholars Hub

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Soil is an important and fundamental element for building and road construction. However, poor properties of soil can affect the entire construction since the soil will resist the loads transferred from the upper structures. Additives such as cement, lime, and rice husk ash (RHA) can be used as stabilization materials to increase soil strength. This study examined the behavior of stabilized plastic clay mixed with cement, lime, and RHA. The clay stabilization success rate can be measured by the California Bearing Ratio (CBR), unconfined compression strength, and swelling potential. In this study, different mixtures were prepared as samples and tested under various loads: 1, 2, 3, 4, and 5 kPa. The results indicated that the addition of cement, lime, and RHA could effectively reduce the swelling potential of clay. The mixture variations of soil–cement composite 90% + RHA 10% and soil–cement composite 90% + lime 4% + RHA 6% showed the lowest swelling rate.
The Effect of WHA and Lime for Shear Strength of Clay Stabilized by Cement Nugroho, Soewignjo Agus; Ongko, Andarsin; Fatnanta, Ferry; Putra, Agus Ika
Jurnal Teknik Sipil dan Perencanaan Vol 24, No 1 (2022)
Publisher : Universitas Negeri Semarang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.15294/jtsp.v24i1.34380

Abstract

With the use of the additive, the clay's shear strength and bearing capacity increased. Usage waste material, Wooden Hush Ash (WHA), is tiny. The silicate content of WHA is almost the same as RHA. This study aims to utilize ASK for a stabilization material of high plasticity clay to increase shear strength. Unconfined Compression Strength (UCS) tests were performed to compare the UCS value of clay; clay with 5% cement; clay with lime; clay-cement with WHA; clay-cement with lime and WHA; and clay with lime and WHA. Before the UCS test, the sample was separated into two groups: with and without curing for 28 days, and with and without soaking for 4 days. While in conditions unsoaked, the qu value is uniform. Results show, without curing and soaked, qu values of all variations have the same value in the range of 350 kPa to 380 kPa. In conditions with curing 28 days with and without soaked, qu values range from 365 kPa to 485 kPa for mixtures with WHA and a combination of lime with ASK. While adding of 10% lime additive increases the qu value to 1100 kPa UCS testing results prove, with and without curing and soaked, lime is more optimal to increase the value of UCS than WHA. Replacement lime with WHA by 4% to 6% increases the qu value from 160 kPa to 465 kPa and 485 kPa and 110 kPa to 440 kPa to 475 kPa of soaked and unsoaked condition respectively. WHA can be used to reduce lime in soil stabilization.
Water and Reinforced Effects on Slope: Case Study on District Koto Panjang, Riau, Indonesia Nugroho, Soewignjo Agus; Yusa, Muhamad; Sujatmoko, Bambang; Ongko, Andarsin
Journal of Geoscience, Engineering, Environment, and Technology Vol. 9 No. 2 (2024): JGEET Vol 09 No 02 : June (2024)
Publisher : UIR PRESS

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.25299/jgeet.2024.9.2.12604

Abstract

This paper discussed a study case related to slope stability and its analysis. The observation and also research object was a hill side on border area between West Sumatera-Riau, Indonesia. This border area consists of numerous slopes with heterogeneous soil characteristics. This location is also susceptible for having landslides, especially on rainy season. The schemes of this research consisted of collecting samples, laboratory tests, finite element method analysis, and slope`s reinforcement planning with anchors or geosynthetic plates. The soil samples were tested on their actual condition and liquid limit condition. This purposed to predict the failures on slope. Afterwards, some reinforcement plannings need to be done. The results of this researach have shown that on existing condition, the safety factor was 1.262. If the soil reach its liquid limit, the safety factor decreased to 0.568. After the reinforcement planning was done, the safety factor went up to 1.120 and the slope stability could be maintained.