Article Per Year (5 Year)
p-Index From 2020 - 2025
0
P-Index
This Author published in this journals
All Journal Bulletin of Electrical Engineering and Informatics Bulletin of Electrical Engineering and Informatics Bulletin of Electrical Engineering and Informatics Indonesian Journal of Electrical Engineering and Computer Science
Belal Ahmed Hamida
International Islamic University Malaysia
Computer Science & IT Electrical & Electronics Engineering Engineering

Published : 4 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 4 Documents
Search

 1 
Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (489.392 KB) | DOI: 10.11591/eei.v8i3.1497

Abstract

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.
Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (489.392 KB) | DOI: 10.11591/eei.v8i3.1497

Abstract

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.
Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (489.392 KB) | DOI: 10.11591/eei.v8i3.1497

Abstract

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.
Black Phosphorus Saturable Absorber for Pulse Generation Using Q-switched Teachnique Belal Ahmed Hamida; L A Hussein; Sheroz Khan; Mohamed Hadi Habaebi; Ahmad Anwar Zainuddin; T Eltaif; S W Harun
Indonesian Journal of Electrical Engineering and Computer Science Vol 11, No 1: July 2018
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijeecs.v11.i1.pp36-40

Abstract

This paper reported a passive Q-switched erbium doped fiber laser (EDFL) using two-dimensional (2D) material of black phosphorus saturable absorber (BP-SA). The maximum output power reached is 3.54 mW, which is generated by pump power of 42.327 mW. The results show that a stable pulse was generated with repetition rate starts at about 9.606 kHz and ends at about 44.72 kHz and very narrow pulse width between 40.01 µs and 9.84 µs and pulse energy 80 nJ. Clearly, the stability of the Q-switched pulse train was achieved because the BP-SA film was inserted in the laser ring cavity.
Co-Authors Ahmad Anwar Zainuddin Farhan Daniel Bin Mohd Noh L A Hussein Mohamed Hadi Habaebi S W Harun Sheroz Khan T Eltaif Tawfig Eltaif