Garuda - Garba Rujukan Digital

Farhan Daniel Bin Mohd Noh

International Islamic University Malaysia

Author-ID : 2468511

Computer Science & IT Electrical & Electronics Engineering Engineering

Published : 3 Documents Claim Missing Document

Claim Missing Document

Articles

Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.

Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.

Investigation of output power in ring CW fiber laser using graphene saturable absorber Belal Ahmed Hamida; Tawfig Eltaif; Farhan Daniel Bin Mohd Noh; Sheroz Khan
Bulletin of Electrical Engineering and Informatics Vol 8, No 3: September 2019
Publisher : Institute of Advanced Engineering and Science

This paper reported the effect of different coupling ratio in continuous wave fiber laser in a ring cavity configuration. Different coupling ratios of 10/90 and 50/50 were tested. Where the output power may vary depending on the ratio and it can be applied to specific area that requires either high or low output power. In addition, generation of passive Q-switched erbium doped fiber laser (EDFL) using graphene based saturable absorber in ring cavity using different coupling ratio was experimentally investigated. As a result, wavelength centered at 1566.62nm is obtain from EDFL cavity. Moreover, the cavity using coupler of 50/50 is capable to achieve Q-switched pulses as compared to the cavity using coupler of 10/90. Where the maximum output power recorded is 336mW with pulse repetition rate of 23.74 kHz. In addition, the pulse width is 3.84µs, and pulse energy is 14.15nJ.

Title

Found 3 Documents
Search

Abstract

Abstract

Abstract

Title Search

Found 3 Documents Search

Abstract

Abstract

Abstract

Title

Found 3 Documents
Search