Claim Missing Document
Check
Articles

Found 4 Documents
Search

ANALISA PENGHEMATAN ENERGI LISTRIK MENGGUNAKAN KAPASITOR BANK BERBASIS ELECTRICAL TRANSIENT ANALYZER PROGRAM (ETAP) (STUDI KASUS LABORATORIUM TEKNIK LISTRIK POLSRI) Sutan Marsus; Mohammad Noer
TELISKA Vol. 4 No. 3 (2012): Edisi 12: Volume 4, Nomor 3, September 2012
Publisher : Teknik Elektro Polsri

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (666.774 KB)

Abstract

Pemakaian energy listrik yang tidak disiplin dan sembarangan maka berakibat pemborosan energy dan pada akhirnya membengkaknya biaya rekening listrik. Seperti studi kasus di Laboratorium Teknik Listrik Polsri dengan daya beban terpasang 140 KVA dan beban aktif 85,7 KW dengan faktor daya 0,65 akibatnya pemakaian daya listrik jadi boros. Dengan memperbaiki faktor daya menjadi 0,90 menggunakan kapasitor bank maka akan menghemat daya sekitar 5899 KWH dan setara dengan Rp.67.734.372,00 per tahun. Penempatan dan pemasangan kapasitor bank yang tepat dan benar menggunakan simulasi Electrical Transient Analyzer Program (ETAP) dan hasilnya yang akan ditampilkan dalam bentuk tabel. Untuk pemasangan kapasitor bank perlu dana investasi yang cukup besar yaitu Rp.35.236.000,00 maka perlu sekali diperhitungkan dengan teliti. Pemakaian formulasi Return on Investment (ROI) akan didapatkan cara pengembalian modal investasi tersebut dalam jangka waktu lebih kurang 2 tahun. Serta diasumsikan umur kapasitor bank 10 tahun tanpa ada masalah yang berarti.Kata kunci : Hemat pemakaian energi listrik, Faktor daya, Kapasitor bank, ETAP, ROI, Laboratorium.
Analisa Setting Over Current Relay Pada Penyulang Banteng Gardu Induk Bukit Siguntang Mohammad Noer; Yessi Marniati
Jurnal Teknik Elektro Vol 8, No 1 (2019): Jurnal Teknik Elektro
Publisher : Situs resmi ITP Press

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (275.602 KB)

Abstract

Short circuit fault current magnitude is affected by the disorder point distance, the greater distance the smaller the interference point of the fault current in short-circuited. Based on the analysis on the calculation of the value of setting TMS with existing field is still under appropriate conditions, the calculation of the value obtained at the feeders Banteng Tms OCR is 0.11 seconds while the data field is 0.1 seconds, and to the values calculated on the incoming side of the OCR TMS is 0,249 seconds while data in the field by 0.25 seconds. So also for the OCR setting on the incoming side is for the calculation of 952.63 A and for field of 1000 A. However, for the current setting of the OCR obtained at feeders is 609.125 A computed value that is much larger than the results on the field that is equal to 320 A. So it can be concluded that the existing OCR settings cannot be said to be a good setting in the field. Seen from TMS settings and current values, where the value of the setting on the feeder faster than setting the incoming. This is because if an interruption occurs, the feeders will be used to overcome the disorder so that interference can be minimized to the incoming side.
Penerapan Teknologi Pompa Air Otomatis Tenaga Surya Berbasis Arduino sebagai Solusi Irigasi Lahan Persawahan di Desa Ulak Depati Mohammad Noer; Sudirman Yahya; Pertiwi Nurul Utami; M. Bagus Ramadhani
AJAD : Jurnal Pengabdian kepada Masyarakat Vol. 6 No. 3 (2026): DECEMBER 2026
Publisher : Divisi Riset, Lembaga Mitra Solusi Teknologi Informasi (L-MSTI)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.59431/ajad.v6i3.1047

Abstract

This community service program aims to implement an Arduino-based solar-powered automatic water pump for rice field irrigation in Ulak Depati Village to improve watering efficiency and reduce dependence on fossil fuels. Using a participatory approach, partners were actively involved in socialization, system design, control panel assembly, field installation of solar panels, a Solar Charge Controller, a battery, a water pump, and a soil moisture sensor, as well as training, mentoring, and evaluation. Following field adjustments to solar panel positioning and sensor calibration, testing confirmed that the sensor accurately detected soil moisture and transmitted data to the Arduino to automatically control the water pump based on a predetermined threshold. Questionnaire evaluation results indicated high community acceptance, averaging 93.6% in the very good category across technology comprehension, ease of operation, suitability to local needs, irrigation benefits, and participant satisfaction. An operational guide was also provided to support independent and sustainable system operation and maintenance by the community.
Edukasi Manajemen Kebutuhan Energi Surya Untuk Sistem Pompa Irigasi Otomatis Dalam Rangka Ketahanan Air Pertanian Di Desa Ulak Depati Nurhaida Nurhaida; Dyah Utari Yusa Wardhani; Yessi Marniati; Mohammad Noer; Haidar Al Fair
SENTRI: Jurnal Riset Ilmiah Vol. 5 No. 9 (2026): SENTRI : Jurnal Riset Ilmiah, September 2026
Publisher : LPPM Institut Pendidikan Nusantara Global

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.55681/sentri.v5i9.7280

Abstract

Agricultural irrigation in Ulak Depati Village remains constrained by dependence on diesel-powered pumps, limited water availability during the dry season, and unstable electricity supply. This study aimed to design an Arduino-based automatic irrigation pump powered by a Solar Power Generation System (PLTS), determine the energy requirements and capacity of solar panels and batteries, and evaluate system performance in supporting agricultural water resilience. The study employed literature review, observation, discussion, and consultation methods. The designed system consisted of three 200 Wp solar panels connected in parallel, a 40 A MPPT Solar Charge Controller, two 12 V 100 Ah batteries connected in series, an Arduino Uno, a soil moisture sensor, and a DC water pump. The results showed that the total daily energy requirement was 706.5 Wh, with the water pump being the largest energy consumer at 671.38 Wh/day. The minimum required solar panel capacity was 141.3 Wp based on an effective peak sun hour of 5 hours/day, while the installed capacity was 600 Wp. The minimum battery capacity was 60 Ah at 24 V, whereas the system used a 100 Ah battery with stored energy of 2,400 Wh. Testing showed that the pump operated at 23.23–24.30 V and 6.43–7.20 A, while water volume reached 2,513.60 L after 246 minutes of operation. The PLTS was theoretically capable of producing 3,000 Wh/day, exceeding the daily energy requirement. These results indicate that the proposed system can meet the energy needs of the automatic irrigation pump and provide energy reserves to support irrigation continuity under reduced solar irradiation conditions.