Vemi Ridantami
Unknown Affiliation

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

PENGARUH PH PADA PENURUNAN KADAR THORIUM DALAM LIMBAH MENGGUNAKAN PROSES ELEKTROKOAGULASI DENGAN ELEKTRODA ALUMUNIUM DAN TEMBAGA Prayitno; Vemi Ridantami; Indah Muji Mulyani Mulyani
Urania: Jurnal Ilmiah Daur Bahan Bakar Nuklir Vol. 24 No. 3 (2018): Urania : Jurnal Ilmiah Daur Bahan Bakar Nuklir
Publisher : Badan Riset dan Inovasi Nasional

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/urania.2018.24.3.4396

Abstract

Reduction of thorium level by electrocoagulation process has been done. Electrocoagulation process is a method used in waste management, which is based on the use of electrodes with potential difference to produce coagulant. One of the process parameters in electrocoagulation is pH. This study aims to determine the effect of pH on the electrocoagulation process in order to lower the thorium level. The method used was batch electrocoagulation process in electrocoagulator tub of 22.5 × 14.5 × 20 cm dimension. The electrodes used were aluminum and copper of 20 × 20 cm2 size with active surface area of 250 cm2. Electrodes were installed in parallel with 1 cm distance between the electrodes. The electrocoagulation process was carried out with a working voltage of 2 V for 60 minutes. Sampling was done every 5-minute interval to prepare samples for subsequent thorium level analysis and pH measurement. The results show changes in pH value during the electrocoagulation process. Such changes result in the concentration change, which was indicated by coagulant separation efficiency. The separation efficiency of aluminum electrode was 98.06%, which was indicated by an increase in thorium level from the initial value of 439.274 ppm to 8.503 ppm within 5 minutes at a pH of 7.38. The copper electrode shows 96.35% efficiency in reducing thorium level from the initial value of 439.274 ppm to 16.015 ppm within 5 minutes at a pH of 7.29. Both electrodes used in the electrocoagulation processes show high separation efficiency and significant increase in pH values within 5 minutes, suggesting that the formation rate of coagulants is rapid during 5 minutes.
REDUKSI AKTIVITAS URANIUM DALAM LIMBAH RADIOAKTIF CAIR MENGGUNAKAN PROSES ELEKTROKOAGULASI Prayitno; Vemi Ridantami; Imam Prayogo
Urania: Jurnal Ilmiah Daur Bahan Bakar Nuklir Vol. 22 No. 3 (2016): Urania : Jurnal Ilmiah Daur Bahan Bakar Nuklir
Publisher : Badan Riset dan Inovasi Nasional

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.17146/urania.2016.22.3.3187

Abstract

Waste generated from the process of the industrial material development one of which waste containing uranium radioactive, can have negative impact on humans and the environment. In the present time, chemicals are still mostly use in radioactive waste treatment. To reduce pollutants with the use of chemicals is less efficient, because less environmentally friendly, take long time and costly. Therefore, a system of electrocoagulation process will be applied to decrease the activity of uranium from waste solution. The purpose of this study is to determine the efficiency of uranium activity decrease in waste water which is produced in the electrolysis process is conducted with voltage variations, the dwelling time, electrode spacing, and the waste inlet pH. The waste that will be treated has uranium contaminant levels of 500 mg/L. The experiment was conducted by a batch system with aluminum electrodes. Parameters affecting electrocoagulation process, such as voltage, time, distance electrode, and the pH have been studied and the best voltage optimization condition has been obtained of 12.50 V, a distance of 1 cm, pH 7, and in the processing time of 60 minutes efficiency of 97.20 % was obtained.