Article Per Year (5 Year)
p-Index From 2021 - 2026
0
P-Index
This Author published in this journals
All Journal Teknisia Journal of the Civil Engineering Forum
Atika Ulfah Jamal
Department Of Civil Engineering, Universitas Islam Indonesia, Yogyakarta, INDONESIA
Civil Engineering, Building, Construction & Architecture Engineering Environmental Science

Published : 3 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : Teknisia

 1 
PERILAKU LENTUR PERBAIKAN BALOK BETON BERTULANG DENGAN VARIASI LEBAR CARBON FIBRE REINFORCED POLYMER Atika Ulfah Jamal; Helmy Akbar Bale; Iqbal Haqiqi
TEKNISIA Vol. XX, No. 2, November 2015
Publisher : Jurusan Teknik Sipil, Fakultas Teknik Sipil dan Perencanaan, Universitas Islam Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

The retrofitting of reinforced concrete structural elements required in case of material degradation which results in decreased strength, stiffness, stability and resistance to environmental conditions. One material that can be used to retrofit concrete structures is the Carbon Fibre Reinforced Polymer (CFRP). Experimental research must be done toward the influence of CFRP width variations to retrofit reinforced concrete beam flexural capacity after damage. The specimen used for this research is a beam with 15x20x120 cm3 dimension. There were three beams used and divided into two groups, Control Beam (BK) and Carbon Beam (BC). These three beams were given a load until the first crack then had to retrofit with CFRP, and was given a load again upon the beams finally fallout and  the result of maximal load that able to be supported by the beam is obtained.  The research result shows that there is the significant increase in the beam flexural strength. The wider CFRP used for retrofitting, the greater beam flexural capacity increases. CFRP uses as retrofitting material in the beam bending area also able to prevent a new crack in the bending area.
PENGARUH VARIASI LEBAR CFRP PADA BAGIAN TARIK TERHADAP DAKTILITAS BALOK BETON BERTULANG PASKA PERBAIKAN Atika Ulfah Jamal; Novi Rahmayanti; Helmy Akbar Bale; Iqbal Haqiqi
TEKNISIA Vol. XXI, No. 1, Mei 2016
Publisher : Jurusan Teknik Sipil, Fakultas Teknik Sipil dan Perencanaan, Universitas Islam Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Retrofitting should be done on reinforced concrete beams were damaged the structure, it is to restore or improve the strength and ductility. One of the innovations of materials that can be used for retrofitting is Carbon Fiber Reinforced Polymer (CFRP). The width of the CFRP used for retrofitting an effect on load and deflection occurs in the beam, it will also affect the ductility of the beam. In this study examined the influence of the width of CFRP for retrofitting to the ductility of reinforced concrete beams with dimensions of 15x20x120 cm3. The beam is loaded until cracking occurred. Retrofitting performed on beams that have been fractured by adding CFRP on the tensile reinforcement of reinforced concrete beams. The wide variationCFRP is used to repair the beam, which is 5 cm, 10 cm, and 15 cm. The results showed that the width of CFRP placed on the tensile reinforcement in reinforced concrete beam elements repair after damage affects the curvature ductility. The wider the CFRP used for the retrofit of reinforced concrete beams lead to the greater percentage decrease in ductility curvature.
Co-Authors Helmy Akbar Bale Iqbal Haqiqi Iqbal Haqiqi Nobuoto Nojima Novi Rahmayanti Yunalia Muntafi