Claim Missing Document
Check
Articles

Found 4 Documents
Search

Penggunaan Zeolit Terpadu Proses Elektrokoagulasi untuk Menurunkan Kandungan Minyak dan Lemak dalam Air Limbah Sutanto Sutanto; Nanang Rohadi; Hidjan Hidjan
Prosiding 2nd Seminar Nasional IPTEK Terapan (SENIT) 2017 Vol 2, No 1 (2017): Mei 2017
Publisher : Politeknik Harapan Bersama Tegal

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Kandungan minyak dan lemak (bahan organik) dalam air limbah yang tidak terkontrol dapat menyebabkan terjadinya polusi dan kerusakan lingkungan. Peraturan Menteri Kesehatan RI No 416/Menkes/Per/IX/1990 menyebutkan bahwa kandungan maksimum polutan dalam air limbah harus dijaga masing-masing:  1,0 mg/l untuk besi (Fe), 0,5 mg/l untuk mangan (Mn), 500 mg/l untuk kesadahan (CaCO3), 0,05 mg/l untuk arsen (As), 200 mg/l untuk natrium (Na) dan 0,5 mg/l untuk timbal (Pb), kekeruhan 25 NTU,  6,5 -9,0 untuk pH dan 10 mg/l untuk bahan organik. Air limbah yang mengandung  bahan organik (minyak dan lemak) melebihi 10 mg/L, maka air limbah tidak aman terhadap lingkungan dan akan menimbulkan bau yang menyengat. Oleh karena itu air limbah harus diolah supaya dihasilkan air yang sesuai dengan standar Menteri Kesehatan RI. Salah satu proses pengolahan yang dilakukan dalam penelitian ini adalah menerapkan penggunaan zeolit yang dipadu dengan proses elektrokagulasi untuk menurunkan kadar  bahan organik yang terdapat dalam air limbah. Penelitian dilakukan dengan mengalirkan air limbah sebanyak 4,5 liter kedalam bak proses  yang telah diisi zeolit teraktifkan sebanyak 200 gram dengan waktu proses 60 menit. Dilanjutkan proses elektrokoagulasi dengan variasi arus 0,05 A, 0,1 A dan 0,2 A. Analisis kandungan minnyak dan lemak dilakukan secara  gravimetri. Hasil analisis  pada kondisi  prosess elektrokoagulasi terbaik, yaitu  arus 0,1 amper selama 60 menit menunjukkan bahwa kandungan minyak  dan  lemak (bahan organik)  dapat diturunkan dari 20 mg/L  menjadi 7 mg/L atau setara dengan 65 %
MODEL ALAT PENAWAR AIR TANAH TERINTRUSI AIR LAUT (AIR PAYAU) DENGAN PROSES ELEKTROKOAGULASI Danang Wijayanto; Sutanto Sutanto
Jurnal Poli-Teknologi Vol. 10 No. 2 (2011)
Publisher : Politeknik Negeri Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (461.34 KB) | DOI: 10.32722/pt.v10i2.8

Abstract

Brackish water or fresh water that tastes a bit salty due to seawater mixed is a frequent problem faced by people living close to the beach area. Ground water areas near shore are often caused by sea water intrusion inland. In general, brackish water can not be used as drinking water, and less feasible to be used for much else. To be used as drinking water and appropriate for use in domestic use brackish water needs special treatment to reduce the levels of minerals in it, primarily to reduce levels of salt in it. For this purpose an equipment model has been made. This model works based on the electrocoagulation process. This electrocoagulation equipment model consists of a rectangular bathtub equipped with stirrer, and square shaped settling tanks. The sizes of electrocoagulation process tank are 20 cm length, 20 cm width and 40 cm high. Motor with capacity of 0.5 hp used to stirred, equipped with 4 pieces blades. While the sizes of settling tank are 20 cm long, 20 cm wide and 40 cm high. Performance testing of this model implemented by filling 4.5 liters of brackish water into the electrocoagulation tank and each test processed using electric current of 1 ampere, 3 amperes and 5 amperes. Observation time for each test is 40, 80, 120, 160, 200, 240, 280, 320, 360, 400, 440 and 480 minutes. Concentration measurement of magnesium and sodium for each test performed by AAS. The final results of testing showed that the use of 3 amperes electric currents is able to reduce levels of magnesium from 100,000 mg/ltr to 81 mg/ltr and reduce sodium levels from 9600 mg/ltr to 185 mg/ltr with 400 minutes operating time. Key words: Brackish Water, Minerals Content, Electrocoagulation Process, Minerals Reduction, Fresh Water ABSTRAK Air payau atau air tawar yang rasanya agak asin karena tercampur air laut merupakan masalah yang sering dihadapi oleh masyarakat yang tinggal didaerah dekat dengan pantai. Air tanah daerah dekat pantai sering bersifat payau disebabkan adanya interusi air laut ke daratan. Pada umumnya air payau tidak dapat digunakan sebagai ari minum, dan kurang layak digunakan untuk keperluan yang lain. Agar dapat digunakan sebagai air minum dan layak digunakan untuk keperluan rumah tangga sehari-hari air payau perlu perlakuan khusus yang tujuannya mengurangi kadar mineral didalamnya terutama mengurangi kadar garam. Untuk keperluan ini telah dibuat model alat yang bekerja berdasarkan proses elektrokoagulasi. Model alat terdiri atas bak proses elektrokoagulasi berbentuk persegi yang dilengkapi pengaduk dan bak pengendap berbentuk persegi. Ukuran bak proses elektrokoagulasi panjang 20 cm, lebar 20 cm dan tinggi 40 cm. Ukuran motor pengaduk adalah 0,5 hp yang dilengkapi 4 buah sudu. Sedangkan bak pengendap berukuran panjang 20 cm, lebar 20 cm dan tinggi 40 cm. Pengujian kinerja alat dilakukan dengan mengisi 4,5 liter air payau ke dalam bak proses elektrokoagulasi dan untuk setiap pengujian digunakan arus listrik 1 ampere, 3 ampere dan 5 ampere. Waktu pengamatan untuk masing-masing pengujian adalah 40,80,120,160,200,240,280,320,360,400,440 dan 480 menit. Pengukuran konsentrasi magnesium dan natrium untuk setiap pengujian dilakukan dengan AAS. Hasil akhir pengujian menunjukkan bahwa pada penggunaan arus listrik 3 amper mampu menurunkan kadar magnesium dari 100.000 mg/l menjadi 81 mg/l untuk dan kadar natrium dari 9.600 mg/l menjadi 185 mg/l dengan waktu operasi 400 menit. Kata kunci: Air Payau, Kandungan Mineral, Proses Elektrokoagulasi, Reduksi Mineral , Air Tawar
PERBANDINGAN EFISIENSI BAK PROSES DUA SEL DAN TIGA SEL DALAM MENURUNKAN KANDUNGAN BESI (Fe) DALAM AIR LIMBAH SECARA ELEKTROKOAGULASI DENGAN KATODA DARI KARBON BEKAS BATERAI Sutanto Sutanto
Jurnal Poli-Teknologi Vol. 10 No. 1 (2011)
Publisher : Politeknik Negeri Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32722/pt.v10i1.537

Abstract

The content pollutants of iron (Fe) in waste water that uncontrolled can cause environmental pollution. Iron content in the waste water that exceeds 1 mg / L is not safe for the environment. Because the regulation of the Minister of Environment No.Kep-03/MENKLH/II/1991 explained that the maximum content of iron in the waste water is 1 mg / L If the iron content in the waste water exceeds that of such provision, the waste water must be treated until comply with the regulations of the Ministry of Environment. One of the processing carried out in this research is to apply the electrocoagulation process with aluminum as anode and waste carbon baterry as cathode. The research is conducted by flowing water of 7 liters of industrial waste water into the bath electrocoagulation process. The process is runing in the two and three cell of tank with an power electric 12 V and intervals of 2 minutes for observation iron content in waste water. The iron content in waste water is analyzed by Atomic Absorption Spectrophotometer (AAS). The results of process until 28 minutes showed that the iron content is reduced from 4.23 mg/L to 0.91 mg/L or equivalent with 78.49 % for process in two cells and from 4.23 mg/L to 0.33 mg/L or equivalent with 92.20 % for process in three cells. Conclusion, the efficiency of the three cells is the best than two cells to reduced iron content in the waste water. Keywords:Waste water, Pollutant of Copper,Electrocoagulation,Reduction of Pollutant
Sistem Pemilihan Ketua RW Menggunakan e-KTP Berbasis Aplikasi Android Shalsa Luthfita Chairiza; Mughni Tabroni; Shita Fitria Nurjihan; Sutanto Sutanto
Voteteknika (Vocational Teknik Elektronika dan Informatika) Vol 12, No 2 (2024): Vol. 12, No 2, Juni 2024
Publisher : Universitas Negeri Padang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24036/voteteknika.v12i2.128166

Abstract

Negara Republik Indonesia menganut sistem demokrasi dalam menentukan pemimpinnya, baik itu Kepala Negara, Pemimpin Daerah, atau Ketua RW dengan aturan yang dituangkan dalam peraturan daerah masing-masing. Ketua RW dipilih melalui pemungutan suara seluruh masyarakat di bawah naungan Rukun Warga setempat. Namun, sistem pemungutan suara pemilihan Ketua RW masih dilakukan secara manual, di atas kertas dan juga dengan sistem penghitungan suara, sehingga penerapan sistem pemilihan tersebut masih belum efektif. Pada penelitian ini, sistem pemilihan Ketua RW berbasis IoT direalisasikan dengan menggunakan Aplikasi Android yang bertujuan agar masyarakat dapat memilih dengan mudah dan dapat melihat perolehan suara secara langsung melalui aplikasi tanpa harus datang ke tempat pemungutan suara. Pemilih dapat menggunakan e-KTPnya untuk memilih calon dengan cara melakukan tapping KTP pada RFID dan menekan tombol pilih sesuai calon yang ingin dipilihnya. Hasil pemungutan suara keseluruhan pemilihan Ketua RW ditampilkan secara real time dan dapat dilihat di aplikasi Android. Hasil pengujian performansi jaringan didapatkan delay yang kecil yaitu 78,7 ???????? dan packet loss 0% dengan kategori sangat bagus. Pada throughput mendapatkan hasil 53,448 KB/s. Pemanfaatan teknologi IoT pada Sistem Pemilihan Ketua RW Menggunakan e-KTP Berbasis Aplikasi Android berjalan dengan baik.Kata kunci : e-KTP, IoT, Pemilihan Ketua RW, RFID The Republic of Indonesia adopts a democratic system in determining its leaders, whether it's the Head of State, Regional Leaders, or Neighbourhood Chief, with rules stipulated in each respective local regulation. Neighbourhood Chief are elected through a community-wide voting process under the umbrella of the local Neighborhood Association. However, the voting system for selecting Neighbourhood Chief is still conducted manually, using paper-based methods and vote tallying systems. Consequently, the implementation of this voting system is still not effective. In this research, an IoT-based Neighbourhood Chief selection system is realized by utilizing an Android Application, aiming to enable the community to vote easily and view voting results directly through the application without needing to physically go to the polling station. Voters can use their National Identity Cards (KTP) to choose candidates by tapping their e-KTP on the RFID reader and pressing the corresponding button for their preferred candidate. The overall voting results for the Neighbourhood Chief election will be displayed in real-time within the android application. The results of network performance testing showed a small delay, namely 78.7 ???????? and packet loss of 0% in the very good category. The throughput results were 53,448 KB/s. The utilization of IoT technology in the Neighbourhood Chief Election System Using  e-KTP Based on Android Application is running well.Keywords: e-KTP, IoT, Neighbourhood Chief Election, RFID