Garuda - Garba Rujukan Digital

Triyono Triyono

Chemistry Department, Faculty of Mathematics and Natural Sciences, Universitas Gadjah Mada, Yogyakarta

Author-ID : 3959592

Chemical Engineering, Chemistry & Bioengineering Chemistry

Published : 3 Documents Claim Missing Document

Claim Missing Document

Articles

MULTIPLE REGRESSION ANALYSIS OF THE INFLUENCE OF CATALYST CHARACTERS SUPPORTED ON γ-Al2O3 TOWARDS THEIR HYDROCRACKING CONVERSION OF ASPHALTENE Wega Trisunaryanti; Triyono Triyono; Mudasir Mudasir; Akhmad Syoufian
Indonesian Journal of Chemistry Vol 4, No 1 (2004)
Publisher : Universitas Gadjah Mada

Multiple regression study of the influence of catalyst's characters with γ-Al2O3 as a support, including acidity, specific area, average pore volume, average pore radius, Ni content, and Mo content the hydrocracking conversion of asphaltene has been conducted.A multivariable regression analysis method, including regression analysis and correlation analysis, was applied on this study. Using multivariable regression, the characters of catalyst was correlated together with the data of the asphaltene conversions. Furthermore, using this method, the characters of catalyst, which have the greatest influence on conversion, may be evaluated. The results showed that there was a high correlation between catalyst characters and hydrocracking conversion of asphalten (r = 0.983). It means that the conversion was 98.3% correlated with the catalyst characters. The value of the multivariable determination coefficient was 0.966, indicating that at least 96.6% variation on the conversions was determined by combination of catalyst characters on this research. From the parameter value of regression equation, it could also be known that average pore radius and specific surface area were the two characters that have the greatest influence on the hydrocracking conversion of asphalten.

PREPARATION OF Ni-Mo/MORDENITE CATALYSTS UNDER THE VARIATION OF Mo/Ni RATIO AND THEIR CHARACTERIZATIONS FOR STEARIC ACID CONVERSION Wega Trisunaryanti; Triyono Triyono; Denty Fibirna A
Indonesian Journal of Chemistry Vol 3, No 2 (2003)
Publisher : Universitas Gadjah Mada

The preparation of Ni-Mo/Mordenite catalysts with variation of Mo/Ni ratio and their characterizations for conversion of stearic acid have been conducted. The catalysts were prepared by loading a small amount of nickel and/or molybdenum on H-Mordenite (H-Mor) with total metal content = 1 wt% based on the mordenite. The metals was supported on to the mordenite by impregnation method using nickel nitrate and/or ammonium heptamolybdate solution. The Mo/Ni ratio was varied as follows 0/1, 1/0, 1/1, 2/1, and 3/1 produced Ni/Mor, Mo/Mor, Ni1-Mo1/Mor, Ni1-Mo2/Mor and Ni1-Mo3/Mor catalyst respectively. The catalysts were then calcinated with nitrogen, oxidized with oxygen and reduced by hydrogen.The characterizations of catalyst were carried out by measuring Ni and Mo contents using atomic absorbtion spectroscopy (AAS), acidity by ammonia vapour adsorption, specific surface area and pore size distribution by nitrogen gas adsorption (NOVA-1000). The catalyst characters on conversion of stearic acid were performed in a flow reaction system at 4000C under hydrogen stream (10 mL/min).The AAS analyses showed that the metal impregnated on to the H-Mor sample were consistent to the initial metal concentrations. The loading of Ni and/or Mo enhanced the acidity, however decreased the specific surface area and total pore volume of the H-Mor sample. The higher the acidity the higher the conversion of stearic acid and the lower the coke formation. The other catalyst characters gave the variation effects toward the stearic acid conversion. The conversions of stearic acid were 34,52%, 43,33%, 65,10%, 80,10%, 86,42% and 95,72% produced by Ni1-Mo3/Mor, H-Mor, Mo/Mor, Ni/Mor, Ni1-Mo2/Mor and Ni1-Mo1/Mor catalyst, respectively.

EFFECT OF IMPREGNATION PROCEDURE OF Pt/γ-AL2O3 CATALYSTS UPON CATALYTIC OXIDATION OF CO Triyono Triyono
Indonesian Journal of Chemistry Vol 3, No 2 (2003)
Publisher : Universitas Gadjah Mada

The oxidation of carbon monoxide by oxygen using two catalysts prepared by two different methods has been investigated. In the first method, catalyst prepared by immersing γ-Al2O3 into the hexa-chloroplatinic acid solution at 80oC for 4 h, resulted Pt/γ-Al2O3 catalyst having platinum highly dispersed on the support. While that of immersing γ-Al2O3 in the hexa-chloroplatinic acid solution at room temperature for 12 h, produced Pt/ γ-Al2O3 catalyst where platinum dispersion was much lower. Catalytic activity test showed that platinum well dispersed on the support enhanced the activity for oxidation of carbon monoxide. The platinum impregnated at room temperature resulted in the poor activity.

Title

Found 3 Documents
Search

Abstract

Abstract

Abstract

Title Search

Found 3 Documents Search

Abstract

Abstract

Abstract

Title

Found 3 Documents
Search