Article Per Year (5 Year)
p-Index From 2021 - 2026
0
P-Index
This Author published in this journals
All Journal Conference SENATIK STT Adisutjipto Yogyakarta Angkasa: Jurnal Ilmiah Bidang Teknologi
Agung Prakoso
Sekolah Tinggi Teknologi Adisutjipto
Aerospace Engineering Computer Science & IT Electrical & Electronics Engineering Industrial & Manufacturing Engineering Mechanical Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Influence of Gmelina Wood on Mechanical Properties and Morphology of Epoxy Composites Agung Prakoso; Henny Pratiwi
SENATIK STT Adisutjipto Vol 4 (2018): Transformasi Teknologi untuk Mendukung Ketahanan Nasional [ ISBN 978-602-52742-0-6 ]
Publisher : Institut Teknologi Dirgantara Adisutjipto

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.28989/senatik.v4i0.253

Abstract

Lignocellulosic filler such as gmelina wood flour is an alternative of synthetic reinforcements which is ecofriendly, abundant in nature and inexpensive. This research aims to investigate the effects of gmelina wood filler addition on tensile properties, impact strength and morphology of epoxy composites. Filler volume fractions evaluated were10, 20, 30 and 40 percent with 30 mesh filler size. Hand lay-up method was used to manufacture the composites. Tensile strength, tensile modulus, elongation and impact strength were determined based on ASTM standard. Results show that filler addition up to some extents improves the mechanical properties of materials. The optimum tensile properties and impact strength are achieved when 10 percent filler is added into epoxy matrix. Further addition of filler degrades the tensile and impact properties of composites. This phenomenon is due to the existence of weak interfacial interaction between the gmelina wood filler and epoxy matrix for higher filler volume concentration beyond 10 vol. %. The scanning electron micrograph of tensile fracture surface reveals that there are voids, agglomeration and pull-out mechanism which are the cause of the composites failure.
PERANCANGAN DAN PEMBUATAN PROTOTYPE SHANK PROSTHESES KAKI BAGIAN BAWAH LUTUT Agung Prakoso
Angkasa: Jurnal Ilmiah Bidang Teknologi Vol 8, No 2 (2016): November
Publisher : Institut Teknologi Dirgantara Adisutjipto

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (277.009 KB) | DOI: 10.28989/angkasa.v8i2.116

Abstract

The existence o f fe e t as the part of the human body is very important to support the daily activities which is to support the body and to walk. The lost of the under knee part (amputation) is the dominant case of the total cases of amputation in Indonesia. So that we need a tool to restore the balance of the human body to be able to do our daily activity. The tool is called prostheses. The design and manufacture of prototypeshank prostheses under knee is intended for persons who have 162 cm height and 57 Kg of average weight. Prostheses are aimed to the persons who only lost one limb below the knee. In this design, the length of the shank can be set according to the length of leg amputated and is intended to persons who are still experiencing high growth (teenager). The material is stainless steel 316L. The shank has a length 200-300 mm, width 67 mm and 2 mm thick.
Co-Authors Henny Pratiwi, Henny