Vahdat Nazerian
University of Mazandaran

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

Comparative detection and fault location in underground cables using Fourier and modal transforms Vahdat Nazerian; Mohammad Esmail Zakerifar; Mahmoud Zadehbagheri; Mohammad Javad Kiani; Tole Sutikno
International Journal of Electrical and Computer Engineering (IJECE) Vol 12, No 6: December 2022
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijece.v12i6.pp5821-5839

Abstract

In this research, we create a single-phase to ground synthetic fault by the simulation of a three-phase cable system and identify the location using mathematical techniques of Fourier and modal transforms. Current and voltage signals are measured and analyzed for fault location by the reflection of the waves between the measured point and the fault location. By simulating the network and line modeling using alternative transient programs (ATP) and MATLAB software, two single-phase to ground faults are generated at different points of the line at times of 0.3 and 0.305 s. First, the fault waveforms are displayed in the ATP software, and then this waveform is transmitted to MATLAB and presented along with its phasor view over time. In addition to the waveforms, the detection and fault location indicators are presented in different states of fault. Fault resistances of 1, 100, and 1,000 ohms are considered for fault creation and modeling with low arch strength. The results show that the proposed method has an average fault of less than 0.25% to determine the fault location, which is perfectly correct. It is varied due to changing the conditions of time, resistance, location, and type of error but does not exceed the above value.
Increasing the perovskite cell performance using comparative layering method between PTAA and PEDOT: PSS layers Vahdat Nazerian; Mehran Hosseinzadeh Dizaj; Amir Assari; Shahed Chehrdoust Shishvan; Fatemeh Shahnavaz; Tole Sutikno
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 22, No 5: October 2024
Publisher : Universitas Ahmad Dahlan

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.12928/telkomnika.v22i5.25153

Abstract

Today, perovskite solar cells are introduced and used as a suitable alternative with high efficiency for silicon solar cells. The main problem of this type of cells until now has been mostly about their instability, because these materials that are used in perovskite solar cells are rapidly destroyed in reaction with air or their efficiency is greatly reduced. In this article, we increase the productivity to an acceptable amount and also increase its stability by using new high-quality synthesized materials and also by changing the manufacturing method of perovskite solar cells. Using the hole transport layers (HTLs), in the inverse planar perovskite solar cell structure, the effect of two layers of poly (triarylamine) (PTAA) and poly (3,4-ethylenedioxythiophene) (PEDOT): PSS as the bottom layer of the perovskite film on the morphology of the nanoparticles, the crystallinity of the perovskite layer and the photovoltaic parameters affecting the efficiency of the solar cell made in a single-step method were investigated. The result shows the PTAA layer has been very effective in controlling the morphology of the perovskite layer, so the efficiency reached to 23.9% while the maximum efficiency per solar cell based on PEDOT: PSS is 11.37%.