Article Per Year (5 Year)
p-Index From 2020 - 2025
0.23
P-Index
This Author published in this journals
All Journal Jurnal Pendidikan Fisika Indonesia Indonesian Journal of Mathematics and Natural Sciences Journal of Community Service and Empowerment
S. Susanto, S.
Jurusan Fisika, FMIPA, Universitas Negeri Semarang, Indonesia
Education Mathematics Physics Social Sciences Other

Published : 5 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 5 Documents
Search

 1 
MULTILAYER POROUS COMPOSITE FROM WASTE GLASS FOR WATER FILTRATION Aji, M. P.; Wiguna, P. A.; Rosita, N.; Susanto, S.; Savitri, M. I.; Said, M. A.N.; Sulhadi, S.
Jurnal Pendidikan Fisika Indonesia Vol 11, No 2 (2015): July 2015
Publisher : Physics Department, Faculty of Mathematics and Natural Sciences, Semarang State University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.15294/jpfi.v11i2.4218

Abstract

Multilayer porous composite have been produced through the heating process at temperature T=700oC for 2.5 h. Single layered porous composite was made with a varied mass percentage of from PEG polymer  1% to 10%. Double-layered porous composite were made by the arrangement of porosity (4:3)%, (4:2)% and (3:2)%, while the three-layers porous composite have an arrangement (4:3:2)%. Performance of multilayer porous composite for water filtration with pollutants of methylene blue 100 ppm was estimated from the absorbance spectrum. Rejection of methylene blue pollutants from single layered porous composite increases when the fraction of PEG polymer tend to be smaller in the matrix. Meanwhile, the double layered porous composite has a degradation of methylene blue pollutants are better than one layer. Triple layered porous composite have good performance for the water filtration where all the pollutants of methylene blue be able to be filtered.   Komposit pori berlapis telah dihasilkan dengan proses pemanasan pada temperatur T=700oC selama 2.5 jam. Komposit pori satu lapis dibuat dengan variasi persen massa polimer PEG 1% hingga 10%. Komposit pori dua lapis dibuat dengan susunan porositas (4:3)%, (4:2)% dan (3:2)%, sedangkan komposit pori tiga lapis memiliki susunan porositas (4:3:2)%. Kinerja komposit pori berlapis untuk filter air dengan polutan methylene blue 100 ppm diestimasi dari spektrum absorbansi. Rejeksi polutan methylene blue dari komposit pori satu lapis meningkat saat fraksi polimer PEG cenderung lebih kecil dalam matrik komposit. Sedangkan, komposit pori dua lapis memiliki kemampuan untuk degradasi polutan methylene blue yang lebih baik dari satu lapis. Komposit pori tiga lapis memiliki kinerja yang baik untuk filter air dimana seluruh polutan methylene blue mampu disaring. 
PENGENDALIAN KELAJUAN KENDARAAN MENGGUNAKAN FUZZY LOGIC CONTROLLER (FLC) PADA SISTEM CRUISE KONTROL Susanto, S.; Sunarno, S.
Jurnal MIPA Vol 39, No 1 (2016): April 2016
Publisher : Jurnal MIPA

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Pengendalian kelajuan kendaraan menggunakan FLC pada cruise control telah dilakukan dengan menginjeksi sistem fuzzy pada sistem gerak kendaraan. Sistem fuzzy terdiri dari dua himpunan masukan berupa error kelajuan dan laju error kelajuan sistem. Penambahan Fuzzy Logic Controller pada sistem gerak kendaraan berpengaruh terhadap respon sistem untuk mencapai kecepatan yang diinginkan. Dengan penambahan FLC respon kecepatan dalam mencapai kecepatan yang diinginkan semakin cepat sehingga sesuai untuk diterapkan pada cruise control.Control vehicle speed using the cruise control FLC has been done by injecting a fuzzy system on the vehicle motion system. The system consists of two sets fuzzy input is the speed error and the error rate of the speed of the system. The addition of Fuzzy Logic Controller in the vehicle motion system affect the response of the system to achieve the desired speed. With the addition of FLC response speed in reaching the desired speed more quickly so appropriate to be applied to the cruise control.
MULTILAYER POROUS COMPOSITE FROM WASTE GLASS FOR WATER FILTRATION Aji, M. P.; Wiguna, P. A.; Rosita, N.; Susanto, S.; Savitri, M. I.; Said, M. A.N.; Sulhadi, S.
Jurnal Pendidikan Fisika Indonesia Vol 11, No 2 (2015)
Publisher : Department of Physics, Faculty of Mathematics and Natural Sciences

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.15294/jpfi.v11i2.4218

Abstract

Multilayer porous composite have been produced through the heating process at temperature T=700oC for 2.5 h. Single layered porous composite was made with a varied mass percentage of from PEG polymer  1% to 10%. Double-layered porous composite were made by the arrangement of porosity (4:3)%, (4:2)% and (3:2)%, while the three-layers porous composite have an arrangement (4:3:2)%. Performance of multilayer porous composite for water filtration with pollutants of methylene blue 100 ppm was estimated from the absorbance spectrum. Rejection of methylene blue pollutants from single layered porous composite increases when the fraction of PEG polymer tend to be smaller in the matrix. Meanwhile, the double layered porous composite has a degradation of methylene blue pollutants are better than one layer. Triple layered porous composite have good performance for the water filtration where all the pollutants of methylene blue be able to be filtered.   Komposit pori berlapis telah dihasilkan dengan proses pemanasan pada temperatur T=700oC selama 2.5 jam. Komposit pori satu lapis dibuat dengan variasi persen massa polimer PEG 1% hingga 10%. Komposit pori dua lapis dibuat dengan susunan porositas (4:3)%, (4:2)% dan (3:2)%, sedangkan komposit pori tiga lapis memiliki susunan porositas (4:3:2)%. Kinerja komposit pori berlapis untuk filter air dengan polutan methylene blue 100 ppm diestimasi dari spektrum absorbansi. Rejeksi polutan methylene blue dari komposit pori satu lapis meningkat saat fraksi polimer PEG cenderung lebih kecil dalam matrik komposit. Sedangkan, komposit pori dua lapis memiliki kemampuan untuk degradasi polutan methylene blue yang lebih baik dari satu lapis. Komposit pori tiga lapis memiliki kinerja yang baik untuk filter air dimana seluruh polutan methylene blue mampu disaring. 
PENGENDALIAN KELAJUAN KENDARAAN MENGGUNAKAN FUZZY LOGIC CONTROLLER (FLC) PADA SISTEM CRUISE KONTROL Susanto, S.; Sunarno, S.
Indonesian Journal of Mathematics and Natural Sciences Vol 39, No 1 (2016): April 2016
Publisher : Universitas Negeri Semarang

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Pengendalian kelajuan kendaraan menggunakan FLC pada cruise control telah dilakukan dengan menginjeksi sistem fuzzy pada sistem gerak kendaraan. Sistem fuzzy terdiri dari dua himpunan masukan berupa error kelajuan dan laju error kelajuan sistem. Penambahan Fuzzy Logic Controller pada sistem gerak kendaraan berpengaruh terhadap respon sistem untuk mencapai kecepatan yang diinginkan. Dengan penambahan FLC respon kecepatan dalam mencapai kecepatan yang diinginkan semakin cepat sehingga sesuai untuk diterapkan pada cruise control.Control vehicle speed using the cruise control FLC has been done by injecting a fuzzy system on the vehicle motion system. The system consists of two sets fuzzy input is the speed error and the error rate of the speed of the system. The addition of Fuzzy Logic Controller in the vehicle motion system affect the response of the system to achieve the desired speed. With the addition of FLC response speed in reaching the desired speed more quickly so appropriate to be applied to the cruise control.
Robotics training to improve STEM skills of Islamic boarding school students in Batam Jamzuri, Eko Rudiawan; Soebhakti, Hendawan; Prayoga , Senanjung; Fatekha, Rifqi Amalya; Wibisana, Anugerah; Nakul, Fitriyanti; Hasnira, H.; Analia, Riska; Susanto, S.; Wijaya, Ryan Satria; Suciningtyas, Ika Karlina Laila Nur; Puspita, Widya Rika; Lubis, Eka Mutia; Jefiza, Adlian; Budiana, B.; Firdaus, Ahmad Riyad
Journal of Community Service and Empowerment Vol. 5 No. 1 (2024): April
Publisher : Universitas Muhammadiyah Malang

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.22219/jcse.v5i1.26895

Abstract

One potential approach to addressing the challenges posed by the advent of Industry 4.0 and Society 5.0 is to offer robotics training. This endeavor aims to enhance students' foundational understanding of STEM (Science, Technology, Engineering, and Mathematics) disciplines. The study involved collaborating with the Pondok Pesantren Granada, an Islamic Boarding School located in Batam, to provide robotics training as community service activities. The study included 29 trainees: 15 from class XI and 7 from classes X and XII. The teaching was conducted using a combination of didactic instruction, interactive discourse, and hands-on exercises. Trainees are administered a written examination to assess their proficiency level before and after the training program. The training outcomes exhibited a significant improvement in the mean STEM proficiency of trainees, with an increase of 38.15%. Furthermore, a series of activities have been effectively implemented, resulting in trainee satisfaction ratings exceeding 50% concerning course materials, trainer, and teaching equipment. A mere 17% of the individuals undergoing training expressed dissatisfaction with the allocated time, particularly the hands-on component's duration.
Co-Authors Ahmad Riyad Firdaus Analia, Riska ANUGERAH WIBISANA Budiana, B. Eko Rudiawan Jamzuri Fatekha, Rifqi Amalya Hasnira, H. Ika Karlina Laila Nur Suciningtyas Jefiza, Adlian Lubis, Eka Mutia M. A.N. Said, M. A.N. M. I. Savitri, M. I. M. P. Aji, M. P. N. Rosita, N. Nakul, Fitriyanti P. A. Wiguna, P. A. Prayoga , Senanjung Puspita, Widya Rika Ryan Satria Wijaya Soebhakti, Hendawan Sulhadi - Sunarno -