Article Per Year (5 Year)
p-Index From 2020 - 2025
0.408
P-Index
This Author published in this journals
All Journal International Journal of Renewable Energy Development International Journal of Renewable Energy Development
Fauzi Yusupandi
Department Of Chemical Engineering, Faculty Of Industrial Technology, Institut Teknologi Bandung, Jl. Ganesha No. 10, Bandung 40132 Department Of Chemical Engineering, Institut Teknologi Sumatera, Jl. Terusan Ryacudu, Way Huwi, Kec. Jati Agung, Lampu
Chemistry Control & Systems Engineering Earth & Planetary Sciences Electrical & Electronics Engineering Energy Engineering

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
Performance Evaluation of An Electrolyte-Supported Intermediate-Temperature Solid Oxide Fuel Cell (IT-SOFC) with Low-Cost Materials Fauzi Yusupandi; Hary Devianto; Pramujo Widiatmoko; Isdiriayani Nurdin; Sung Pil Yoon; Tae-Hoon Lim; Aditya Farhan Arif
International Journal of Renewable Energy Development Vol 11, No 4 (2022): November 2022
Publisher : Center of Biomass & Renewable Energy, Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/ijred.2022.46735

Abstract

Intermediate temperature solid oxide fuel cell (IT-SOFC) provides economic and technical advantages over the conventional SOFC because of the wider material use, lower fabrication cost and longer lifetime of the cell components. In this work, we fabricated electrolyte-supported IT-SOFC using low-cost materials such as calcia-stabilized zirconia (CSZ) electrolyte fabricated by dry-pressing, NiO-CSZ anode and Ca3Co1.9Zn0.1O6 (CCZO) cathode produced through brush coating technique. According to the XRD result, the monoclinic phase dominated over the cubic phase, and the relative density of the electrolyte was low but the hardness of the CSZ electrolyte was close to the hardness of commercial 8YSZ electrolyte. The performance of the single cell was performed with hydrogen ambient air. An open-circuit voltage (OCV) of 0.43, 0.46, and 0.45 V and a maximum power density of 0.14, 0.50, and 1.00 mW/cm2 were achieved at the operating temperature of 600, 700, and 800 °C, respectively. The ohmic resistance of the cell at 700 and 800 °C achieved 81.5 and 33.00 Ω, respectively due to the contribution of thick electrolyte and Cr poisoning in electrodes and electrolyte
Performance Evaluation of An Electrolyte-Supported Intermediate-Temperature Solid Oxide Fuel Cell (IT-SOFC) with Low-Cost Materials Fauzi Yusupandi; Hary Devianto; Pramujo Widiatmoko; Isdiriayani Nurdin; Sung Pil Yoon; Tae-Hoon Lim; Aditya Farhan Arif
International Journal of Renewable Energy Development Vol 11, No 4 (2022): November 2022
Publisher : Center of Biomass & Renewable Energy, Diponegoro University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.14710/ijred.2022.46735

Abstract

Intermediate temperature solid oxide fuel cell (IT-SOFC) provides economic and technical advantages over the conventional SOFC because of the wider material use, lower fabrication cost and longer lifetime of the cell components. In this work, we fabricated electrolyte-supported IT-SOFC using low-cost materials such as calcia-stabilized zirconia (CSZ) electrolyte fabricated by dry-pressing, NiO-CSZ anode and Ca3Co1.9Zn0.1O6 (CCZO) cathode produced through brush coating technique. According to the XRD result, the monoclinic phase dominated over the cubic phase, and the relative density of the electrolyte was low but the hardness of the CSZ electrolyte was close to the hardness of commercial 8YSZ electrolyte. The performance of the single cell was performed with hydrogen ambient air. An open-circuit voltage (OCV) of 0.43, 0.46, and 0.45 V and a maximum power density of 0.14, 0.50, and 1.00 mW/cm2 were achieved at the operating temperature of 600, 700, and 800 °C, respectively. The ohmic resistance of the cell at 700 and 800 °C achieved 81.5 and 33.00 Ω, respectively due to the contribution of thick electrolyte and Cr poisoning in electrodes and electrolyte
Co-Authors Aditya Farhan Arif Devianto, Hary Isdiriayani Nurdin Pramujo Widiatmoko Sung Pil Yoon Tae-Hoon Lim