Claim Missing Document
Check
Articles

Found 2 Documents
Search

PENGARUH VARIASI EMITTER PADA JARINGAN IRIGASI TETES PIPA PVC BERTINGKAT TERHADAP DISTRIBUSI DAN KESERAGAMANAN IRIGASI I DEWA GEDE JAYA NEGARA; ANID SUPRIYADI; EKO PRADJOKO; ATAS PRACOYO; YUSRON SAADI; I WAYAN YASA
GANEC SWARA Vol 18, No 1 (2024): Maret 2024
Publisher : Universitas Mahasaraswati K. Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35327/gara.v18i1.791

Abstract

Test efforts to find alternatives to increase the even distribution of irrigation water on service land. The results of previous research conducted by researchers show that drip irrigation which is designed in stages with a water source from a drip irrigation tank using two types of emitters in a multi-stage drip irrigation system provides different irrigation water distribution results, so it is necessary to find a solution. so that irrigation can occur evenly. To get an alternative that might be tested is to use several types of emitters in the PVC pipe drip point holes, because these tools already exist on the market. This research aims to determine the effect of using two types of emitters, namely 2 lt/min and 4 lt/min emitters on distribution of irrigation water in a 4-tiered drip irrigation network. The test data analyzed includes irrigation distribution data, flow discharge data and irrigation uniformity (Cu), and the results of the analysis are presented in the form of tables and graphs and discussed before conclusions are drawn. The analysis results show that the average Cu for the two types of emitters is above 97%, which is very good and the two emitters have a very even distribution. The difference in distribution volume for each emitter, for a 2ml/min emitter is around 1ml -2 ml and for a 4 ml/min emitter it is 1ml -2 ml, with an irrigation network flow rate of around 84ml/min – 99.7 ml/min.
Analisis Optimasi Aplikasi Sistem Irigasi Tetes PVC Ber-Amiter pada Variasi Lahan Bertingkat Untuk Mendukung Kegiatan Pertanian di Permukiman Perkotaan: Optimization Analysis of the Application of Emitter PVC Drip Irrigation Systems on Variations of Multistorey Land to Support Agricultural Activities in Urban Settlements I Dewa Gede Jaya Negara; Lilik Hanifah; Anid Supriyadi; Eko Pradjoko; Atas Pracoyo
JURNAL SAINS TEKNOLOGI & LINGKUNGAN Vol. 9 No. 3 (2023): JURNAL SAINS TEKNOLOGI & LINGKUNGAN
Publisher : LPPM Universitas Mataram

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.29303/jstl.v9i3.490

Abstract

Multilevel drip irrigation with PVC pipes is an efficient irrigation method that has the potential to be applied in urban settlements. Even though the land used is not very large, farming can be done effectively because it uses polybag land. This study aims to determine the effect of variations in PVC pipe drip irrigation networks with amiter on irrigation distribution, irrigation uniformity, and soil moisture levels with variations in irrigation duration. The test was carried out on four variations of tower water level and four variations of PVC drip irrigation networks in a multi-level system, with four variations of irrigation duration t1=5 minutes, t2=10 minutes, t3=15 minutes and t4=20 minutes. The test data analyzed includes irrigation distribution data and irrigation uniformity (Cu) and soil moisture recharge (Wt). The analysis results show that the best distribution of drip irrigation is obtained in network variation 3 with an average of 69 ml. The average uniformity obtained for Cu is above 97%, which is considered very good. Soil moisture Wt in variation 3 drip irrigation networks for a depth of 20 cm ranges from 0.69% - 21.65% at L1, at L2 around 2.16% - 21.65%, at L3 is 2.19% -21.68 % and at L4 it is 10.41% - 28.66%, so the higher the level position, the greater the soil moisture addition provided by irrigation.