Claim Missing Document
Check
Articles

Found 2 Documents
Search

Comparative Analysis of Network Development Local Area Network (LAN) Fiber Optical Cable with Unshielded Twisted Pair (UTP) Cat 6 Cable at SMK Negeri 2 Tasikmalaya Ashari, Ami; Rubiani, Hani; Manova, Yovi
International Journal of Global Operations Research Vol. 5 No. 1 (2024): International Journal of Global Operations Research (IJGOR), February 2024
Publisher : iora

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.47194/ijgor.v5i1.286

Abstract

The LAN Network at SMK Negeri 2 Tasikmalaya previously used media UTP Cat5e network with poor performance due to bandwidth UTP Cat5e is only 200 Mb/s, therefore the school choose to replace it network media with fiber optics, with a bandwidth that can reach 1 Gb/s. On the other there is still UTP Cat6 with the same bandwidth of 1Gb/s at a cost installation is lower than fiber optic network installation. Data collection on performance is carried out using the Quality of Service (QoS) approach with the parameters measured, namely Delay, Jitter, Packet loss and Throughput using Wireshark software. Performance of fiber optic and UTP Cat6 networks at SMK Negeri 2 Tasikmalaya in categorize “Good” according to Telecommunications and Internet Protocol Hormonization Over Network (TIPHON) standards. Test results from optical fiber obtained a delay of 2.58 ms, jitter of 2.38 ms, packet loss of 0.254 and throughput of 805.92 Mbps. The test results of the UTP Cat6 cable were obtained delay of 5.59 ms, jitter of 5.21 ms, packet loss of 0.559 and throughput of 623.73 Mbps.
Analisa Alat Kendali Suhu dan Kelembaban berbasis Arduino Mega 2560 Yuliati, Ari; Gumilar, Cecep; Manova, Yovi
ITEJ (Information Technology Engineering Journals) Vol 7 No 1 (2022): June
Publisher : Pusat Teknologi Informasi dan Pangkalan Data IAIN Syekh Nurjati Cirebon

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.24235/itej.v7i1.91

Abstract

Temperature and humidity control systems are widely applied in agriculture. To increase crop yields and make it easier for agricultural actors, especially in plant cultivation, it is important to innovate in the development of technology that is growing rapidly. This study aims to analyze the level of validity and reliability of temperature and humidity control devices in a cultivation test room based on Arduino Mega 2560 with the help of SPSS. The results of the analysis and test of temperature and humidity control devices, with a maximum coefficient of variation of 1.86% and a minimum reliability coefficient of 0.62.