Jurnal Teknik Kimia dan Lingkungan
Vol. 2 No. 2 (2018): October 2018

Simulasi CHEMCAD: Studi Kasus Distilasi Ekstraktif pada Campuran Terner n-Propil Asetat/n-Propanol/Air

Agung Ari Wibowo (Jurusan Teknik Kimia, Politeknik Negeri Malang, Jl. Soekarno Hatta No. 9, Malang 65141, Indonesia)
Cucuk Evi Lusiani (Jurusan Teknik Kimia, Politeknik Negeri Malang, Jl. Soekarno Hatta No. 9, Malang 65141, Indonesia)
Rizqy Romadhona Ginting (Department of Chemical Engineering, Graduate School of Engineering, Hiroshima University, 1-4-1 Kagamiyama, Higashi-Hiroshima, 739-8527, Japan)
Dhoni Hartanto (Jurusan Teknik Kimia, Fakultas Teknik, Universitas Negeri Semarang, Kampus Sekaran, Gunungpati, Semarang 50229, Indonesia)



Article Info

Publish Date
08 May 2023

Abstract

Pemisahan n-propil asetat dari campuran terner n-propil asetat/n-propanol/air merupakan salah satu proses yang tidak dapat dilakukan dengan distilasi sederhana. Adanya azeotrop terner minimum dari campuran tersebut menyebabkan n-propil asetat hanya dapat dipisahkan dari campuran n-propanol dan air salah satunya dengan metode distilasi ekstraktif. Distilasi ekstraktif merupakan proses vaporisasi parsial dengan menambahkan suatu agen pemisah non-volatil yang disebut sebagai sovent atau agen ekstraktif. Solvent yang digunakan dalam simulasi proses ini adalah campuran DMSO (Dimetil Sulfoksida) dan Gliserol dengan komposisi 50 % massa dengan perbandingan 1:2 untuk massa umpan kolom : solvent. Feed yang digunakan adalah n-propanol (10 kmol/jam) dan asam asetat (13 kmol/jam) masing-masing pada suhu 25°C dan tekanan 101,3 kPa. Hasil n-propil asetat terbaik diperoleh saat solvent diumpankan pada stage 5 dengan fraksi mol n-propil asetat pada distilat 0,9975 disertai dengan minimumnya energi reboiler yang digunakan pada konfigurasi kolom ini. n-Propyl acetate separation of the n-propyl acetate /n-propanol/water mixture composition can't be done by simple distillation. The existence of minimum ternary azeotrope on the mixture causes n-propyl acetate can be separated only by extractive distillation method. Extractive distillation is a partial vaporization process in the presence of a non-volatile separating agent called as solvent or extractive agent. Solvent used in the simulation process is DMSO (Dimethyl Sulfoxide)-Glycerol mixture (50% mass) with a ratio of 1: 2 for column feed : solvent. n-Propanol (10 kmol/hour) and acetic acid (13 kmol/hour) are fed into reactor (before extractive distillation process) at 25°C and 101.3 kPa, respectively. The best results of n-propyl acetate were obtained when the solvent was fed to stage 5 in which mole fraction of n-propyl acetate in distillate 0.9975 accompanied by the minimum reboiler energy used in this column configuration.

Copyrights © 2018






Journal Info

Abbrev

jtkl

Publisher

Subject

Chemical Engineering, Chemistry & Bioengineering Chemistry Energy Engineering Materials Science & Nanotechnology

Description

JTKL editors welcome manuscripts in the form of research articles, literature review, or case reports that have not been accepted for publication or even published in other scientific journals. Articles published in cover key areas in the development of chemical and environmental engineering ...