<![CDATA[In this research, Taguchi method is employed by focusing on spindle speed, feed rate, and depth of cut to optimize the CNC turning parameters for aluminum alloy 6063. The main goal of this study is to improve the surface roughness of the material. A L9 orthogonal array is used for experimentation, and the results are subsequently analyzed using ANOVA (Analysis of Variance). A spindle speed of 1300 rpm, a feed rate of 0.5 m/min, and a depth of cut of 1.5 mm are the optimal conditions to achieve the minimum average surface roughness (Ra). The main effect plot of the signal-to-noise (S/N) ratio provides significant evidence supporting the primary research goal. Furthermore, the ANOVA table reveals that spindle speed contributes 59.71%, feed rate contributes 29.80%, while depth of cut only contributes minimally at 0.72%. Based on the research findings, spindle speed and feed rate can be adjusted to control surface roughness. Both factors are highly significant in influencing the surface roughness of the material. The prediction equation from the linear regression analysis is Ra = 1.745 – 0.001024 spindle speed + 0.3000 feed rate – 0.0233 depth of cut. A coefficient of determination or R-squared value of 0.9115 indicates that the independent variables can explain 91.15% of the variation in the dependent variable. The experimental and predicted surface roughness (Ra) values have a predicted error percentage of 2.26%.]]>
Copyrights © 2023
