cover
Contact Name
Irwana Nainggolan
Contact Email
irwana@usu.ac.id
Phone
+6261-8214290
Journal Mail Official
jcnar@usu.ac.id
Editorial Address
Jalan Bioteknologi No. 1 Kampus USU Pd. Bulan, Medan 20155, Sumatera Utara - Indonesia
Location
Unknown,
Unknown
INDONESIA
JOURNAL OF CHEMICAL NATURAL RESOURCES (JCNaR)
Published by TALENTA PUBLISHER
ISSN : -     EISSN : 26561492     DOI : https://doi.org/10.32734/jcnar.v4i1.9353
Core Subject : Science,
Journal of Chemical Natural Resources (JCNaR) is a peer-reviewed biannual journal (February and August) published by TALENTA as an open access journal. The aim of the journal is to provide a medium to exchange ideas and information related to research and knowledge in disciplines of organic chemistry, biochemistry, analytical chemistry, inorganic chemistry and physical chemistry. The journal also receives systematic reviews, meta- analysis and review article on the new issues in the fields of chemistry and natural sciences. Submission to this journal implies that the manuscript has not been published or under consideration to be published in another journal.
Articles 156 Documents
Bioremediation of PET-Contaminated Wastewater Using Shrimp Waste Activated Sludge: A Combined In Silico–Experimental Study Edi Suswanto; Hanzhola G. Riyanto; Mayshah Purnamasari; Fakhrotun Nisa
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.26884

Abstract

Polyethylene terephthalate (PET) plastic pollution is a long-standing environmental problem because it is highly resistant to natural degradation. This study investigates a poorly studied low-cost biocatalytic approach for the degradation of PET-derived wastewater using esterase-producing bacteria isolated from activated sludge of shrimp waste. Theoretical binding affinity and degradation performance were evaluated by the dual-approach strategy of molecular docking simulation (MOE software) and laboratory-scale degradation experiments. The docking analysis revealed that PET had a strong and stable binding interaction with the esterase enzyme, suggesting its catalytic ability. Shrimp waste activated sludge treatment experimentally resulted in reduction of Total Suspended Solids (TSS), Chemical Oxygen Demand (COD) and Biological Oxygen Demand (BOD) up to 95% within 10 hours. The degradation product of diethylene glycol (DEG) was confirmed by gas chromatography. These studies demonstrate a promising pathway towards an eco-friendly PET wastewater treatment based on waste valorization.
Biochar for Wastewater Treatment: An Integrative Review of Feedstocks, Engineering Strategies, Adsorption Mechanisms, and Future Perspectives ST. Aisyah Humaerah; Sri Magfirah HS
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.26953

Abstract

The increasing volume and complexity of wastewater have driven the development of effective and sustainable treatment technologies. Biochar is a biomass-based adsorbent with considerable potential for wastewater treatment because its pore characteristics, surface area, functional groups, and mineral composition can be engineered according to target pollutants. This review aims to synthesize the relationships among biomass types, production conditions, activation and modification strategies, physicochemical characteristics, adsorption mechanisms, performance, and application readiness of biochar. Literature was searched through Scopus, ScienceDirect, SpringerLink, Wiley Online Library, Taylor & Francis, MDPI, and selected SINTA-indexed journals for 2021–2026. A total of 40 articles were selected based on relevance, credibility, and information completeness and analyzed using a descriptive-comparative approach. The synthesis indicates that biochar performance results from interactions among feedstock, production conditions, engineering strategies, pollutant properties, and operating conditions. Activation using H₃PO₄, KOH, and NaOH and modification with bentonite, magnetic materials, metal oxides, and carbon-based materials can alter surface characteristics and pollutant affinity. However, increased surface area does not necessarily result in proportional improvements in adsorption performance, highlighting the need to integrate characterization and adsorption data for mechanistic interpretation. Key research gaps include testing standardization, regeneration and stability, validation using real wastewater and multicomponent systems, continuous-flow development and scale-up, and sustainability assessment through Life Cycle Assessment and techno-economic analysis. The review highlights the need for engineered biochar that simultaneously considers performance, stability, safety, process feasibility, and sustainability.
Biosynthesis and Characterization of Copper-Based Particles Using Green Betel Leaf (Piper betle L.) Aqueous Extract as a Bioreductant Kurnia Ramadani Karim; Nur Indah Sari; Titik Andriani; Akira Syam
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.26971

Abstract

Green synthesis provides an alternative route for preparing copper-based materials using plant-derived reducing and stabilizing agents. This study evaluated copper-based particles obtained by reacting 0.1 M copper(II) nitrate trihydrate (Cu(NO3)2·3H2O) with an aqueous extract of green betel leaves (Piper betle L.). The extract was screened for secondary metabolites and combined with the precursor at extract-to-copper-solution volume ratios of 1:1, 1:2, 1:3, 1:4, and 1:5 at a fixed total volume of 50 mL, so that the extract fraction decreased from 50.0 to 16.7% (v/v) while the Cu2+ content increased from 2.50 to 4.17 mmol. After 24 h, the particle fraction was recovered by centrifugation, washed, redispersed in distilled water, and analyzed by UV-Vis spectrophotometry. The dried product from the ratio showing the highest measured absorbance was characterized by SEM-EDX. The extract showed maximum absorption at 280.0 nm (absorbance 1.034) and tested positive for flavonoids, alkaloids, phenols, saponins, and tannins. The 1:1 ratio gave the highest measured absorbance (3.390 at 207.0 nm); however, the differences among ratios were small (3.212–3.390), the band is not specific to copper, and no replicate data were available, so this value served only as a screening criterion. SEM revealed irregular surfaces and nonuniform spherical particle-like features with apparent sizes of 74.2–392 nm, indicating substantial agglomeration. EDX detected Cu (57.96 wt%), O (29.44 wt%), and C (12.59 wt%). The results support the formation of a copper-based particulate product, whose oxidation state and crystalline phase remain to be confirmed by XRD or XPS.
Effect of Increasing the Number and Changing the Diameter of Nozzle Holes on the Reduction of Moisture Content in CPO Ex Vacuum Dryer at PT Inti Indosawit Subur PMKS Buatan Dua Mhd Fauzan Affandi; Tengku Rachmi Hidayani; Taranipa Marfitania
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.27041

Abstract

The moisture content of Crude Palm Oil (CPO) at PT Inti Indosawit Subur, PMKS Buatan Dua, during August and September 2025 averaged 0.29%, exceeding the company's internal standard of below 0.25%. One of the efforts made to reduce the moisture content was modifying the vacuum dryer nozzle, which was found to be suboptimal, by increasing the number of nozzle holes from 9 to 10 and reducing the hole diameter from 7 mm to 6 mm. The data used consisted of 56 secondary data samples before modification (August-October 2025) and 56 samples after modification (October-December 2025), analyzed using descriptive statistics, a normality test, and a paired sample T-test. The results showed that the average moisture content decreased from 0.290% to 0.221% after the modification, a reduction of about 23.6%. The paired sample T-test produced a significance value (2-tailed) of < 0.05, so H0 was rejected, indicating that the increase in the number of nozzle holes and the reduction of their diameter had a statistically significant effect in reducing the moisture content of ex-vacuum dryer CPO at PT Inti Indosawit Subur PMKS Buatan Dua.
Phytochemical Profile and Preliminary Toxicity of Cumin Leaf (Plectranthus amboinicus) Infusion: UV–Vis Quantification and Brine Shrimp Lethality Test Rahma Diyan Martha; Sulastri Sulastri; Defi Wulandari; Danar Danar
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.27100

Abstract

Cancer research increasingly explores natural products because plant secondary metabolites may possess diverse biological activities. This study evaluated the phytochemical profile, total levels of selected metabolite groups, and preliminary toxicity of a water infusion of cumin leaf (Plectranthus amboinicus) against Artemia salina larvae. Dried cumin leaves were infused in distilled water at 90 °C for 15 min, and the resulting filtrate was concentrated. Qualitative phytochemical screening was performed for alkaloids, flavonoids, saponins, and tannins. Quantitative determination was conducted using UV–Vis spectrophotometry with reference standards and calibration curves. BSLT was performed at concentrations of 100–1000 ppm for 24 h, with three replicates per concentration. The infusion showed group-level UV–Vis responses corresponding to alkaloids, flavonoids, saponins, and tannins at 7.90%, 62.81%, 22.20%, and 6.70%, respectively. These values represent estimates based on the respective reference standards and should not be interpreted as the percentages of pure compounds. Mortality increased from 6.7% at 100 ppm to 86.7% at 1000 ppm. Probit regression yielded the equation y = 2.7423x − 2.3304 (R = 0.9579), corresponding to an LC50 of 467.73 ppm. The aqueous infusion therefore showed measurable preliminary toxicity toward A. salina under the tested conditions.
Phytochemical Screening, Cream Formulation, and Antibacterial Activity of Cyanthillium cinereum (L.) H. Rob. Leaf Ethanol Extract against Staphylococcus aureus Muhammad Taufik; Mariany Razali; Muharni Saputri; Nurmala Sari; Mia Ramayani Damanik; Siti Fathiyah Mawaddah; Putra Penyabar Gulo; Nazwa Amalia Apriani; Citra Marisa
Journal of Chemical Natural Resources Vol. 8 No. 2 (2026): Journal of Chemical Natural Resources (JCNaR)
Publisher : Talenta Publisher

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32734/jcnar.v8i2.27332

Abstract

Cyanthillium cinereum (L.) H. Rob. contains secondary metabolites with potential antibacterial activity. This study performed qualitative phytochemical screening of the leaf ethanol extract, formulated topical creams containing 0.75% (F1), 1.5% (F2), and 3% (F3) extract, and evaluated preliminary physical stability and antibacterial activity against Staphylococcus aureus ATCC 25923. Qualitative screening detected alkaloids, steroids, saponins, flavonoids, tannins, glycosides, and phenolic compounds. The creams were homogeneous; mean pH values ranged from 6.22 to 6.45 before cycling and from 6.00 to 6.05 after cycling. Antibacterial responses increased with concentration. F3 produced the greatest response among the creams (19.07 ± 0.45 mm, n = 3), while the blank base showed no inhibition; the corresponding unformulated 3% extract produced 19.23 ± 0.42 mm. Two-way ANOVA showed significant effects of preparation type (p < 0.001), concentration (p < 0.001), and their interaction (p = 0.003). The E3-F3 difference was not significant by Tukey HSD (p = 0.996), but this does not establish statistical equivalence. These findings indicate that an antibacterial response remains measurable after incorporation into a cream matrix and support further investigation of the 3% formulation.