Garuda - Garba Rujukan Digital

Article Per Year (5 Year)

All

Bulletin of Electrical Engineering and Informatics

EEI
Website

Published by Universitas Ahmad Dahlan

ISSN : - EISSN : - DOI : -

Core Subject : Engineering,

Electrical & Electronics Engineering

Bulletin of Electrical Engineering and Informatics (Buletin Teknik Elektro dan Informatika) ISSN: 2089-3191, e-ISSN: 2302-9285 is open to submission from scholars and experts in the wide areas of electrical, electronics, instrumentation, control, telecommunication and computer engineering from the global world. The journal publishes original papers in the field of electrical, computer and informatics engineering.

Arjuna Subject : -

Articles 2,901 Documents

21 22 23 24 25

ANN Controller Design for Lime Kiln Process Sandeep Kumar Sunori; Pradeep Kumar Juneja
Bulletin of Electrical Engineering and Informatics Vol 4, No 4: December 2015
Publisher : Institute of Advanced Engineering and Science

The lime kiln is a very complex multivariable process with severe non linearities, high degree of coupling and frequent disturbances. In this paper a 2x2 lime kiln process with two manipulated variables namely the fuel gas flowrate, and the percent opening of the induced draft damper and two controlled variables namely front end temperature and back end temperature has been considered. After its decoupling, artificial neural network (ANN) controllers have been designed to control the front end temperature. The performance of ANN controllers have been compared with that of conventional controllers.

Design of a Class F Power Amplifier With 60% Efficiency at 1800 MHz Frequency Neda Babapour; Javad Javidan
Bulletin of Electrical Engineering and Informatics Vol 4, No 4: December 2015
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/eei.v4i4.515

Based on the portable systems application, it is necessary to design blocks with high efficiency to increase battery lifetime. Power amplifier is the highest power consumption block in transmitter. The proposed circuit was simulated using ADS Agilent based on 0.18 μm TSMC RF CMOS technology and supply voltage of 3.3V on transistor level. The proposed power amplifier was designed by Class F type at 1800 MHz with 60% efficiency and output powers of 30 dBm.

Effective Cable Sizing model for Building Electrical Services M. Pratap Nair; K. Nithiyananthan
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

This paper mainly focuses on the sizing of electrical cables (i.e.cross-sectional area) and its accomplishment in various international standards. Cable sizing methods are at variance across international standards. For example, International Electrotechnical Commission (IEC), National Electrical Code (NEC), British Standard (BS) and Institute of Electrical and Electronics Engineers (IEEE). The basic philosophy underlying any cable sizing calculation is to develop a procedure model on cable sizing. The main objective of this research work is to develop effective cable sizing model for building services.

Transient Stability Enhancement Using Phasor Model of Superconducting Magnetic Energy Storage Mohamed Bey; Mohamed Moudjahed
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

Superconducting Magnetic Energy Storage (SMES) is one of most important device attracting researchers for enhancing the transient stability of power systems. To facilitate the use of this device in different simulations and studied, a phasor model is established and used to analyse the impact of this device using matlab/Simulink software. The phasor model has enough advantages like using the SMES without need detailed model that contains the electronic power converter and therefore minimize the simulation time. The Western Systems Council Coordinating (WSCC) 3 machine-9 bus system is taken as a power system test. Simulation results show that the phasor model of SMES unit is very effective to study their impact for enhancing the transient stability in large scale time.

Reconfiguration of Distribution Networks with Presence of DGs to improving the Reliability Amir Sabbagh Alvani; Seyed Mehdi Mahaei
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

In this paper, the network reconfiguration in the presence of distributed generation units with the aim of improving the reliability of the network is studied. For this purpose four reliability parameters in the objective function are considered, which is average energy not supplied system average interruption frequency index, system average interruption duration index and momentary average interruption frequency index. The new method will be normalized objective function. Another suggestion of this paper are considering the different fault rates, locating time of faults type and prioritization of customers based on their importance. This nonlinear problem has optimized by particle swarm optimization (PSO) algorithm.

Control of Power and Voltage of Solar Grid Connected Boucetta Abd Allah; Labed Djamel
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

Renewable energy is high on international agendas. Currently, grid-connected photovoltaic systems are a popular technology to convert solar energy into electricity. Control of power injected into the grid, maximum power point, high efficiency, and low total harmonic distortion of the currents injected into the grid are the requirements for inverter connection into the grid. Consequently, the performance of the inverters connected to the grid depends largely on the control strategy applied. In this paper the simulation and design of grid connected three phase photovoltaic system using Matlab/Simulink has examined. The proposed system consists photovoltaic panels, boost and inverter the PV system convert the sun irradiation into direct current, thereafter we have used a boost to track the maximum power point of the PV system, three-phase inverter and LC output filter. A VOC control strategy based on the phase shifting of the inverter output voltage with respect to the grid voltage. The proposed control strategy requires few hardware and computational resources. As a result, the inverter implementation is simple, and it becomes an attractive solution for low power grid connected applications.

New Model Reference Adaptive System Speed Observer for Field-Oriented Control Induction Motor Drives Using Neural Networks Hossein Rahimi Khoei; Mahdi Zolfaghari
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

One of the primary advantages of field-oriented controlled induction motor for high performance application is the capability for easy field weakening and the full utilization of voltage and current rating of the inverter to obtain a wide dynamic speed rangeThis paper describes a Model Reference Adaptive System (MRAS) based scheme using Artificial Neural Network (ANN) for online speed estimation of sensorless vector controlled induction motor drive. The proposed MRAS speed observer uses the current model as an adaptive model. The neural network has been then designed and trained online by employing a back propagation network (BPN) algorithm. The estimator was designed and simulated in Matlab/Simulink. Simulation result shows a good performance of speed estimator. The simulation results show good performance in various operating conditions. Also Performance analysis of speed estimator with the change in resistances of stator is presented. Simulation results show this estimator robust to parameter variations especially resistances of stator.

Application of PEM Fuel Cell for Stand-alone Based on a Fuzzy PID Control SM Rakhtala; E Shafiee Roudbari
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

Due to increasing concerns on environmental pollution and depleting fossil fuels, fuel cell (FC) has received considerable attention as an alternative to the conventional energy systems. Fuel cells have numerous stand-alone and grid-connected applications. This paper presents the control of the stand-alone application based on fuzzy PID (FPID) controller. The aim of the paper is to achieve the control of the fuel cell for stand-alone with suitable power conditioning unit (PCU) that consists of the two stages of DC/DC converter and DC/AC inverter. An analysis of cascade structure based on FPID controller for a single phase inverter is done and comprises two feedback control loops. The inductor current and capacitor voltage are measured and feedback to the inner loop and the outer loop, respectively. The analytical models of the h PEM fuel cells is designed and simulated by developing a detailed simulation software using Matlab, Simulink and SimPowerSystems Blockset for portable applications. The PEM fuel cell model is validated with NexaTM Power Module MAN5100078 by Ballard Power Systems at 80°C. In this paper shown that the proposed controller shows a robust behavior and good transient response.

Basis Weight Gain Tuning Using Different Types of Conventional Controllers Chandani Sharma; Anamika Jain
Bulletin of Electrical Engineering and Informatics Vol 5, No 1: March 2016
Publisher : Institute of Advanced Engineering and Science

Paper making is a vast, multidisciplinary technology that has expanded tremendously in recent years approaching to reach 20 million tons by 2020. As per demand implementation of necessary tools to optimize papermaking process and to increase the control precision, the precondition for stable operation and quality production is necessary. In the present work, an effort has been made to analyse gain tuning of Basis Weight output relative to the changing values of basis weight valve opening with step and variable input. The effects of the three constants KP, KD and KI for different types of conventional controllers as P, PD and PID controller are examined by adding a disturbance to the control system. The effects of various scaling gains are studied on the output of the system and are tuned to get the optimum output both for the step input as well as the varying input. Simulation results show that P, PD and PID controllers provide automatic tuning to preserve good performance for various operating conditions. An analysis of practical performance indices is presented by comparing results of three different conventional controllers. The system developed can be used to serve as platform for Control engineering techniques used in industries.

A Novel Grid Connected Photovoltaic System Ali Rahnamaei; Mahdi Salimi
Bulletin of Electrical Engineering and Informatics Vol 5, No 2: June 2016
Publisher : Institute of Advanced Engineering and Science

Inthispaper, a novel grid connected photovoltaic system is proposed which can function as an Active Power Filter (APF) with Maximum Power Point Tracking (MPPT). Filter reference current is derived using Fourier Transform. Considering 33% reduction in inverter switches, cost of the grid-connect photovoltaic power plant can be reduced considerably. Using this approach, it is also possible to compensate for reactive and harmonic components of the local loads; moreover it can inject generated active power into grid at maximum power point of the photovoltaic cells. According to this, during daytime, the proposed system injects active power to the grid and at the same time compensates for the reactive power of the load. When there is no sunlight, the inverter only compensates local loads. Considering cost reduction, such capabilities may result in more application of the grid connected photovoltaic systems. Main novelty of the proposed system is simultaneous APF and MPPT functioning using single DC/AC converter. In fact, extra DC-DC converter is not required in the proposed system for MPPT. In order to verify the performance of the proposed method, some simulation is done using MATLAB/Simulink software. Also, some experimental results are presented for practical verification of the proposed grid connected inverter.

Page 23 of 291 | Total Record : 2901

21 22 23 24 25

Filter by Year

2012 2025

Filter By Issues

All Issue Vol 14, No 6: December 2025 Vol 14, No 5: October 2025 Vol 14, No 4: August 2025 Vol 14, No 3: June 2025 Vol 14, No 2: April 2025 Vol 14, No 1: February 2025 Vol 13, No 6: December 2024 Vol 13, No 5: October 2024 Vol 13, No 4: August 2024 Vol 13, No 3: June 2024 Vol 13, No 2: April 2024 Vol 13, No 1: February 2024 Vol 12, No 6: December 2023 Vol 12, No 5: October 2023 Vol 12, No 4: August 2023 Vol 12, No 3: June 2023 Vol 12, No 2: April 2023 Vol 12, No 1: February 2023 Vol 11, No 6: December 2022 Vol 11, No 5: October 2022 Vol 11, No 4: August 2022 Vol 11, No 3: June 2022 Vol 11, No 2: April 2022 Vol 11, No 1: February 2022 Vol 10, No 6: December 2021 Vol 10, No 5: October 2021 Vol 10, No 4: August 2021 Vol 10, No 3: June 2021 Vol 10, No 2: April 2021 Vol 10, No 1: February 2021 Vol 9, No 6: December 2020 Vol 9, No 5: October 2020 Vol 9, No 4: August 2020 Vol 9, No 3: June 2020 Vol 9, No 2: April 2020 Vol 9, No 1: February 2020 Vol 8, No 4: December 2019 Vol 8, No 3: September 2019 Vol 8, No 2: June 2019 Vol 8, No 1: March 2019 Vol 7, No 4: December 2018 Vol 7, No 3: September 2018 Vol 7, No 2: June 2018 Vol 7, No 1: March 2018 Vol 6, No 4: December 2017 Vol 6, No 3: September 2017 Vol 6, No 2: June 2017 Vol 6, No 1: March 2017 Vol 5, No 4: December 2016 Vol 5, No 3: September 2016 Vol 5, No 2: June 2016 Vol 5, No 1: March 2016 Vol 4, No 4: December 2015 Vol 4, No 3: September 2015 Vol 4, No 2: June 2015 Vol 4, No 1: March 2015 Vol 3, No 4: December 2014 Vol 3, No 3: September 2014 Vol 3, No 2: June 2014 Vol 3, No 1: March 2014 Vol 2, No 4: December 2013 Vol 2, No 3: September 2013 Vol 2, No 2: June 2013 Vol 2, No 1: March 2013 Vol 1, No 4: December 2012 Vol 1, No 3: September 2012 Vol 1, No 2: June 2012 Vol 1, No 1: March 2012 List of Accepted Papers (with minor revisions) More Issue

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota yogyakarta,

Daerah istimewa yogyakarta

INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name -

Contact Email -

Phone -

Journal Mail Official -

Editorial Address -

Location Kota yogyakarta, Daerah istimewa yogyakarta INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota yogyakarta,

Daerah istimewa yogyakarta

INDONESIA