Claim Missing Document
Check
Articles

Found 3 Documents
Search
Journal : Jurnal Teknik Kimia Indonesia

Pengambilan ion cadmium (II) dari air limbah simulasi menggunakan fly ash aktif: studi kesetimbangan I Made Bendiyasa; D Setiawan; R. Octaviany
Jurnal Teknik Kimia Indonesia Vol 7, No 2 (2008)
Publisher : ASOSIASI PENDIDIKAN TINGGI TEKNIK KIMIA INDONESIA (APTEKIM)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.5614/jtki.2008.7.2.6

Abstract

The experimental study of equilibrium of Cadmium (II) adsorbed with fly ash has been performed. The experimental rig was consisted of a 0.5 L three neck flask, a stirrer, a condenser and a thermometer. The rig was immersed in a water bath that was used to control the experimental temperature. The three neck flask was filled with 0.3 L Cadmium solution of a fixed concentration and then 0.3 g of flay ash was put into the flask. Chemical composition of fly ash are as follows (weight %): SiO2 = 54,23; Al2O3 = 25,38; H2O = 2,5; MgO = 1,O; Ca0 = 4,63; Na20 = 0,32; K20 = 0,60; Mn0 = 0,014; Fe2O3 = 6,01; TiO2 = 0,007; P2O5 = 0,042 and loss of ignition (LOI) is 5,26. Cation exchange capacity is 990 meq/kg fly ash. Each run was conducted for 2 hours, and at the end of each experiment Cadmium (II) was analyzed with Atomic Absorbtion Spectrophotometer (AAS). Variables studied were temperature ranging from 303 to 323 K and initial concentration of Cadmium (II) from 7 to 10 mg Cadmium (II) L-1. Experimental data were evaluated with both Langmuir and Freundlich models. It is found that the experimental data is in a good agreement with Langmuir model. Relationships between K for Langmuir and Freundlich and temperature are, respectively, KLangmuir = 2,841066e(-35401,01/RT) and KFreundlich = 4, 75104e(-34403,20/RT) Keywords: fly ash, Langmuir, Freundlich, Cadmium, equilibrium Abstrak Pengambilan Cd(II) dari air limbah simulasi diteliti dengan menggunakan fly ash sebagai adsorben. Tujuan utama penelitian ini adalah mempelajari kesetimbangan adsorpsi Cd(II) dengan fly ash. Disamping itu juga bertujuan untuk mengetahui kapasitas maksimum adsorpsi fly ash. Setiap percobaan dilakukan dalam suatu reaktor batch yang suhunya dipertahankan tetap. Reaktor yang digunakan adalah labu leher tiga dengan volum 0, 5 L yang dilengkapi dengan pengaduk merkuri, pendingin balik, dan termometer. Fly ash dengan berat 0,3 gram dimasukkan ke dalam reaktor yang telah diisi dengan suatu larutan Cadmium dengan volume 0,3 L dan konsentrasi tertentu. Komposisi kimia fly ash adalah (% berat): %): SiO2 = 54,23; Al2O3 = 25,38; H2O = 2,5; MgO = 1,O; Ca0 = 4,63; Na20 = 0,32; K20 = 0,60; Mn0 = 0,014; Fe2O3 = 6,01; TiO2 = 0,007; P2O5 = 0,042 dan berat hilang = 5,26. Fly ash yang dipakai mempunyai nilai kapasitas pertukaran kation (KPK) yang nilainya sama dengan 990 meq/kg fly ash. Setiap percobaan dilakukan selama dua jam, dan kemudian konsentrasi Cd(II) di dalam larutan  dianalisis kadar Cd(II)-nya menggunakan Atomic Absorbtion Spectrophotometer (AAS). Variabel yang dipelajari adalah suhu (T) dan konsentrasi awal (Co) larutan. Kisaran suhu yang diteliti adalah 303 sampai 323 K dan konsentrasi awal (Co) antara 7 sampai 10 mg Cd(11) L-1. Data percobaan dievaluasi dengan model Langmuir dan Freundlich.  Hasil penelitian menunjukkan bahwa adsorpsi Cd(II) dengan fly ash lebih sesuai dengan model Langmuir. Hubungan K untuk Langmuir dan Freundlrich dengan suhu berturut adaIah KLangmuir = 2,841066e(-35401,01/RT) and KFreundlich = 4, 75104e(-34403,20/RT)Kata kunci: fly ash, Langmuir, Freundlich, Cadmium, kesetimbangan
Sistem penyimpanan energi panas kontak langsung menggunakan larutan Na2HPO4•12H2O Panut Mulyono; I Made Bendiyasa; Dita Budi Wibawa; Suryo Birowo
Jurnal Teknik Kimia Indonesia Vol 4, No 3 (2005)
Publisher : ASOSIASI PENDIDIKAN TINGGI TEKNIK KIMIA INDONESIA (APTEKIM)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.5614/jtki.2005.4.3.2

Abstract

The volumetric coefficient of heat transfer and the energy storage capacity in a direct contact thermal energy storage system using Na2HPO4.12H2O solution as thermal energy storage medium have been investigated. Hot kerosene was used as a heal transfer fluid. The experiments were carried out by bubbling hot kerosene from the bottom of a column containing Na2HPO4.12H2O solution. The column used in this experiment was made from glass of 3 mm in thickness with an inside diameter of 7 cm and a height of 100 cm. The effects of kerosene flow rate and kerosene bubble diameter on the volumetric coefficient of heat transfer and the storing rate of energy were studied. It was found that the volumetric coefficient of heat transfer was strongly affected by the flow rate of the kerosene and that the effect of the kerosene flow rate on the storing rate of energy was relative v high, while that of the effect of the bubble diameter was neglectable.Keywords: Direct Contact, Thermal Energy Storage System, Na2HPO4.12H2O Solution AbstrakPenelitian ini mempelajari sistem penyimpanan energi panas kontak langsung menggunakan larutan Na2HPO4.12H2O sebagai media penyimpan energi. Kerasin panas digunakan sebagai fluida alir sumber energi panas. Masalah yang dipelajari pada penelitian ini adalah nilai koefisien perpindahan panas volumetris dan kapasitas penyimpanan panasnya. Percobaan dilakukan dengan menggelembungkan kerasin panas dari dasar kolom yang berisi larutan Na2HPO4.12H2O. Kolom yang digunakan dibuat dari gelas dengan ketebalan 3 mm, mempunyai diameter dalam 7 cm, dan tinggi kolomnya adalah 100 cm. Parameter yang dipelajari dalam penelitian ini adalah pengaruh kecepatan volumetris kerosin dan pengaruh diameter gelembung kerosin terhadap nilai koefisien perpindahan panas volumetris  dan terhadap kecepatan penyimpanan panasnya. Hasil penelitian menunjukkan bahwa nilai koejisien perpindahan panas volumetris sangat dipengaruhi oleh kecepatan volumetris kerosin sehingga kecepatan penyimpanan panasnya juga sangat dipengaruhi oleh kecepatan volumetris kerosin. Pengaruh ukuran diameter gelembung terhadap nilai koefisien perpindahan panas volumetris dan terhadap kecepatan penyimpanan panasnya sangat kecil sehingga dapat diabaikan.Kata Kunci: Sistem Penyimpanan Energi Panas, Kontak Langsung, Larutan Na2HPO4.12H2O
Koefisien perpindahan massa volumetris keseluruhan pada ekstraksi Cu dari larutan CuSO4.5H2O dengan tributyl phosphate-kerosin dalam double-stage mixer-settler Panut Mulyono; I Made Bendiyasa; S Sarto; Tri Mustika; H Heriyanto
Jurnal Teknik Kimia Indonesia Vol 5, No 1 (2006)
Publisher : ASOSIASI PENDIDIKAN TINGGI TEKNIK KIMIA INDONESIA (APTEKIM)

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.5614/jtki.2006.5.1.4

Abstract

Copper is one of the hazardous materials and is found in some industrial waste waters. Extraction is thought to be an effective removal technique for copper from dilute solution. In this study, copper has been extracted by tributhyl phosphate-kerosene from a dilute aqueous solution with a double-stage mixer-settler extraction column. The extraction column used in this experiment was made of glass. The mixer diameter was equal to the diameter of settler was 13 cm. Both the mixer and settler heights were 8 cm. Drop coalescer was mounted in the middle of mixer and settler separator. The diameter of drop coalescer was 6 cm with the thickness of 1 cm. The hole diameter of drop coalescer was 1 mm. The stirrer used in this experiment was cross flat blade with the diameter and width of the impeller was 6 cm and 8 mm, respectively.  The overall volumetric coefficient of mass transfer (Kca) increased by increasing the flow rate of the continuous phase (Lo) at the constants stirring speed (N) and flow rate of the dispersed phase (Ld). The    increase of Lc from 4.1634 cm3/second to 17.9436 cm3 /second increased the Kca value from 6.6387x10-5/second to 23.1561x 10-5 /second or 248.8%. The value of Kca was also increase by increasing N at the constant values of Lc and Ld The increase of N from 3.3333 rps to8.3333 rps increased the Kca value from 6.0288x10-5 second to 6.6387x10-5 second or 10.1%.Keywords: Mass Transfer Coefficient, Extraction, Copper, Double-stage   Mixer-settler AbstrakTembaga (Cu) merupakan logam berat yang bila terbuang ke lingkungan merupakan zat pencemar yang berbahaya. Ekstraksi dapat digunakan dengan efektif untuk memungut Cu dari limbah cair walaupun dalam konsentrasi yang rendah. Penelitian ini mempelajari perpindahan massa antarfasa pada ekstraksi Cu dari larutan CuSO4.5H2O dengan menggunakan pelarut tributyl phosphate dalam kerasin yang dilakukan dalam kolom ekstraksi double-stage mixer-settler yang disusun vertikal. Kolom ekstraksi mixer-settler dibuat dari gelas dengan diameter mixer dan diameter settler 13 cm. Tinggi mixer 8 cm. Diameter drop coalescer 8 cm, tebal 1 cm, dan diameter lubangnya 1 mm. Pengaduk yang digunakan berbentuk flat blade dengan diameter 6 cm dan lebar blade 8 mm. Koefisien perpindahan massa volumetris keseluruhan (Kca) naik dengan naiknya kecepatan alir fasa kontinyu (Lc) pada kecepatan putaran pengaduk (N) dan kecepatan alir fasa  dispersi (Ld) tetap. Kenaikan nilai Lc dari 4,1634 cm3/detik  menjadi 17,9436 cm3/detik  meningkatkan  nilai Kca  dari 6,6387x10-5/detik menjadi 23,1561x10-5/detik  atau 248,8%. Kca juga naik dengan naiknya N pada Lc dan Ld yang tetap. Kenaikan nilai N dari 3,3333 rps menjadi 8,3333 rps meningkatkan nilai K.adari 6,0288x10-5 detik menjadi 6,6387x10-5 detik atau 10,1%.Kata Kunci: Koefisien Perpindahan Massa, Ekstraksi, Tembaga, Double-stage Mixer-settler