Article Per Year (5 Year)
p-Index From 2020 - 2025
0.444
P-Index
This Author published in this journals
All Journal International Journal of Power Electronics and Drive Systems (IJPEDS) Ganendra: Majalah IPTEK Nuklir
Dwiatmaja, Agus
Unknown Affiliation
Computer Science & IT Control & Systems Engineering Electrical & Electronics Engineering Other

Published : 2 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search

 1 
A character driver of amplifier for the RF-generator 77.78 MHz at cyclotron DECY-13 in Yogyakarta Atmono, Trimarji; Dwiatmaja, Agus; Piero, Muhamad Rangga Del; Suntoro, Achmad
International Journal of Power Electronics and Drive Systems (IJPEDS) Vol 15, No 3: September 2024
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijpeds.v15.i3.pp1719-1725

Abstract

Measurement of power supply for design of experimental cyclotron in Yogyakarta (DECY-13), i.e. RF-generator 77.78 MHz, especially driver amplifier as important part, has been carried out, in order to minimize the reflected power. Starting from direct digital synthesizer (DDS) as exciter of the radio frequency (RF) wave, having power up to 20 W, the signal sent then to the driver, that has an amplifying factor of around 50. Output of driver works as input for final power of designed DECY-13, which needs about 10 kW of RF power supply for operating the cyclotron. Using network analyzer to get the best position of the RF-power-coupler, it was found the value of dee impedance equals to (50.9 - j0.3) Ω. The signal detected has the behavior as capacitively having value of around 6 nF, that showed by smith chart. An output of 0.8 W by DDS has resulted of 300W to the driver. By a pure resistance 50 Ω dummy load, the system can achieve final power of almost 10 kW.
AN IMPROVEMENT OF ARJUNA 1.0 CONVEYOR SYSTEM FOR 3D IRRADIATION Saefurrochman, Saefurrochman; Purwanto, Agus Tri; Adabiah, Suhadah Rabi'atul; Sukaryono, Sukaryono; Setiaji, Galih; Arthanto, Dwi Handoko; Anggraeni, Karina; Rachmawati, Isti Dian; Dwiatmaja, Agus; Wijono, Wijono; Nuraini, Elin; Andriyanti, Wiwien; Darsono, Darsono; Adjie, Andreas Bimo Putro
GANENDRA Majalah IPTEK Nuklir Volume 26 Nomor 1, 2023
Publisher : Website

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.55981/gnd.2023.6826

Abstract

An improved design of the conveyor system of Arjuna 1.0 electron accelerator for 3D object irradiation has been done. The penetration of low energy electrons is less than 1 cm in the surface, causing a challenge for the irradiation process for sterilization of 3D objects. We design a conveyor that can be rotated 360o to irradiate objects evenly. The dimension of this conveyor is 1750 x 600 x 800 mm and the maximum diameter of the object is 7 cm. Based on the Frame Bending Stress analysis to calculate the strength of the conveyor frame, it is shown that the maximum displacement is only 0.029 mm, which is very small so it will cause no disturbance to power transfer from the motor to the conveyor. The normal stress (Smax) is 3.926 MPa and the bending stress for Smax (Mx) and Smax (My), are 2.391 MPa and 3.925 MPa respectively. We also calculate the stress analysis of the 3 mm-thickness of the motor mount and found that the Von-Misses Stress, first, and third Principal Stress are 4.425 MPa, 5.01 MPa, and 1.95 MPa respectively. These results confirm that the design and the material used for the conveyor are safe because the stress is very low than the material’s yield strength which is 207 MPa. The power needed for this conveyor is 0.01724 kW, with a maximum speed is 880 rpm. The new model of 3D conveyor has been constructed and can be implemented to ARJUNA 1.0 to irradiate objects on all its surfaces
Co-Authors Achmad Suntoro Adabiah, Suhadah Rabi'atul Adjie, Andreas Bimo Putro Anggraeni, Karina Arthanto, Dwi Handoko Atmono, Trimarji Darsono Darsono Elin Nuraini Galih Setiaji Piero, Muhamad Rangga Del Purwanto, Agus Tri Rachmawati, Isti Dian Saefurrochman Saefurrochman Sukaryono Sukaryono Wijono Wijono WIWIEN ANDRIYANTI