Claim Missing Document
Check
Articles

Found 2 Documents
Search

REKAYASA NANO KOMPOSIT TITANIUM OSKIDA SEBAGAI KATALIS PEREDUKSI ZAT WARNA TEKSTIL Iwan Susanto; Nugroho Eko Setijogiarto; Tia Rahmiati; Fachruddin Fachruddin; Arifia Ekayuliana; Jauhari Ali
Jurnal Poli-Teknologi Vol. 18 No. 3 (2019)
Publisher : Politeknik Negeri Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32722/pt.v18i3.2392

Abstract

The core shell structure of TiO2@SiO2@ferrite(Ni-Cu-Zn) as composite nanoparticles for magnetic photocatalyst were successfully prepared in this study. These particles were synthesized continually by the sol-gel method and they are tested for their performance using MB dye solution. The magnetic core particles used in the synthesis were (Ni-Cu-Zn) ferrite with size of 20-60 nm, while SiO2 and TiO2 layers were formed using tetraethoxysilane and tetrabutly titanate. Some characterizations and testinghavecarried out to investigate the crystal structure, magnetic properties, surface conditions and performance of these particles. The results show that the anatase crystal structure of TiO2 was obtained on the outer shell of the particle, while the magnetization value and surface area were achieved at 4.74 emu/g and 126,831 m2/g, respectively. The nanoparticles of composite size were obtained about 10 to 40 nm with the shell thickness up to 4 nm. The performance results of photodegradation was quite good for reducing MB dye up to 63.37%.
Design and Fabrication of Die and Punch Components for the Piercing-Coining Process of AA 1100-O Aluminum Plate Muhammad Khafidz Maulana; Dhiya Luqyana; Nugroho Eko Setijogiarto; Rafiel Syafa Budihardjo
Jurnal Mekanik Terapan Vol 7 No 2 (2026): August 2026
Publisher : Politeknik Negeri Jakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.32722/jmt.v7i2.8796

Abstract

The preparation of aluminium workpieces for anodizing at Jakarta State Polytechnic is currently performed manually using a hacksaw and metal file, resulting in a production time of more than 60 min/workpiece. This study focuses on the design and fabrication of punch and die components for an existing die machine by applying the Quality Function Deployment (QFD). User needs were identified through observation, interviews, and questionnaires, and subsequently translated into engineering specifications using the House of Quality (HoQ). Based on the design analysis, a die clearance of 0.21 mm and a required pressing force of 3 tons were determined. The fabricated punch and die components were then evaluated through trial production of aluminium specimens. The experimental result demonstrated that the developed tooling was successfully integrated into the die system and produced workpieces with consistent dimensions and satisfactory accuracy. In addition, the proposed system substantially improved production efficiency, increasing the production capacity from approximately one workpiece/hour using the conventional manual process to 240 workpieces/hour, assuming continuous machine operation without downtime. The proposed approach demonstrates the potential of integrating industrial press tooling into vocational laboratory applications to improve the efficiency and consistency of practical workpiece preparation. Furthermore, this approach can serve as a scalable model for implementing low-cost manufacturing technologies in vocational education.