Analisis Perbandingan Sifat Mekanik Sambungan Kampuh V Terhadap Kampuh U Hasil Pengelasan SMAW Menggunakan Posisi 3G pada Baja St 37

Rizky Maulana (Program Studi Teknik Mesin, Fakultas Teknik dan Perencanaan, Universitas Ekasakti)
Afdal Afdal (Program Studi Teknik Mesin, Fakultas Teknik dan Perencanaan, Universitas Ekasakti)
Risal Abu (Program Studi Teknik Mesin, Fakultas Teknik dan Perencanaan, Universitas Ekasakti)
Mukhnizar Mukhnizar (Program Studi Teknik Mesin, Fakultas Teknik dan Perencanaan, Universitas Ekasakti)
Veny Selviyanty (Program Studi Teknik Mesin, Fakultas Teknik dan Perencanaan, Universitas Ekasakti)

Jurnal Teknik Industri Terintegrasi (JUTIN)
Vol. 7 No. 1 (2024): January

Selection of the type of support that is appropriate to the load will affect the mechanical and physical properties. Using a good type of support and in accordance with welding procedures can have an influence on the welding results (weldability properties). The comparison of the mechanical properties of V-joints to U-joints is that the maximum tensile stress value between V-joints and U-joints is a maximum of 477.17 N/mm2, while the maximum tensile stress value of V-joints is 453.12 N/mm2. The strain value between the V seam connection and the U seam connection is 20%, while the strain value for the V seam connection is 30%. The yield stress value between the V seam joint and the U seam joint is found in the U seam joint with a yield stress value of 356.05 N/mm2, while the yield stress value for the V seam joint is 337.6 N/mm2. The modulus of elasticity value between the V seam connection and the U seam connection is 2,518.09 N/mm2, while the modulus of elasticity value for the V seam connection is 1,529.43 N/mm2.