Claim Missing Document
Check
Articles

Found 4 Documents
Search

Higher Body Mass Index and Waist Cicumference Have Correlation With the degree of Curvature of Hyperlordosis in Young Adult Fitriani Rahmawati; Nuryani Sidarta
Indonesian Journal of Physical Medicine & Rehabilitation Vol 5 No 02 (2016): Indonesian Journal Of Physical Medicine and Rehabilitation
Publisher : Indonesian Journal of Physical Medicine & Rehabilitation

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (324.115 KB) | DOI: 10.36803/ijpmr.v5i02.207

Abstract

BACKGROUND : Health problem that caused by higher BMI have grown broadly. Musculoskeletaldisorders due to higher BMI will cause an excessive burden on the lumbosacral joints. .Moreover, excess waistcircumference can also lead to malformation of lumbal curvature.Purpose: This study aims to determine the relationship between higher Body Mass Index (BMI) and excesswaist circumference with the higher curvature in young adult.Method: This study used observational study with cross-sectional design involving 88 students whoperformed measurement of body weight, height, and waist circumfrences, also lumbar curve examination. Themeasurement of waist circumference was done by circling the flexible tape on waist. For the measurement ofthe lumbar curve,each respondent is measured by a flexible ruler.Results: chi square test obtained p = 0,000 in high BMI with the increasing of lumbar curve and p = 0,000 inexcess waist circumference with the increasing of lumbar curve. So, there is a correlation between higher BMIand excess waist circumference with the increase of lumbar curve in the young adults.Conclusions: In this study showed that higher BMI and excess waist circumference have correlation with theincrease of lumbar curve in the students.Keywords: body mass index, waist circumference, tape measure, hyperlordosis, flexible ruler.
Higher Body Mass Index and Waist Cicumference Have Correlation With the degree of Curvature of Hyperlordosis in Young Adult Fitriani Rahmawati; Nuryani Sidarta
Indonesian Journal of Physical Medicine & Rehabilitation Vol 5 No 02 (2016): Indonesian Journal Of Physical Medicine and Rehabilitation
Publisher : Indonesian Journal of Physical Medicine & Rehabilitation

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (324.115 KB) | DOI: 10.36803/ijpmr.v5i02.207

Abstract

BACKGROUND : Health problem that caused by higher BMI have grown broadly. Musculoskeletaldisorders due to higher BMI will cause an excessive burden on the lumbosacral joints. .Moreover, excess waistcircumference can also lead to malformation of lumbal curvature.Purpose: This study aims to determine the relationship between higher Body Mass Index (BMI) and excesswaist circumference with the higher curvature in young adult.Method: This study used observational study with cross-sectional design involving 88 students whoperformed measurement of body weight, height, and waist circumfrences, also lumbar curve examination. Themeasurement of waist circumference was done by circling the flexible tape on waist. For the measurement ofthe lumbar curve,each respondent is measured by a flexible ruler.Results: chi square test obtained p = 0,000 in high BMI with the increasing of lumbar curve and p = 0,000 inexcess waist circumference with the increasing of lumbar curve. So, there is a correlation between higher BMIand excess waist circumference with the increase of lumbar curve in the young adults.Conclusions: In this study showed that higher BMI and excess waist circumference have correlation with theincrease of lumbar curve in the students.Keywords: body mass index, waist circumference, tape measure, hyperlordosis, flexible ruler.
IDENTIFIKASI PEMBUATAN BATAKO BETON MEKANIS Muhammad Zakaria Umar; Muhammad Nuh Arifiandi Hadiputra; Abdul Fattaah Mustafa; Fitriani Rahmawati
MUSTEK Vol 7 No 2 (2018): MUSTEK ANIM HA
Publisher : Universitas Musamus, Merauke, Papua

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35724/mustek.v7i2.909

Abstract

Batako beton dibuat dengan cara manual dan mekanis. Batako beton yang dibuat dengan menggunakan mesin cetak bertenaga dinamo volt (listrik) disebut batako mekanis. Sistem mekanis yang diterapkan pada mesin cetak batako antara lain, tuas, energi potensial, dan gaya sentrifugal. Di Kota Kendari potensi pasir tersedia, sehingga bahan bangunan berbasis pasir mudah dibuat oleh masyarakat. Produk batako yang dihasilkan dengan mesin cetak batako lebih berkualitas, efisien, presisi, daya serap rendah, kuat tekan tinggi, tidak mudah retak, dan ekonomis. Penelitian ini ditujukan untuk mengidentifikasi dan mengkaji pembuatan batako beton mekanis terhadap alat-alat kerja, bahan-bahan kerja, dan cara pembuatan di Kota Kendari. Jenis penelitian kualitatif dengan pendekatan studi kasus digunakan dalam penelitian ini. Data didapat dengan cara observasi dan diskusi mendalam terhadap pekerja dan pemilik pabrik batako. Teknik analisis deskriptif naratif digunakan dalam penelitian ini. Penelitian ini disimpulkan bahwa lori, sekop, sapu lidi, ember, kaus tangan, balon karet, mesin cetak batako, pengalas batako, kantong semen, alat penggosok mesin cetakan, sapu ijuk, oli tidak terpakai, kuas, pecahan pipa paralon, pemukul sekop, dan timba digunakan sebagai alat-alat kerja untuk membuat batako mekanis. Pasir, semen, dan air digunakan sebagai bahan-bahan pembuat batako beton mekanis. Batako beton mekanis dibuat dengan tahap pengadukan adonan kering, pengadukan adonan lembab, percetakan, pengeringan pertama, penyiraman, dan pengeringan kedua. Kata kunci: Batako, Beton mekanis, Kendari, Sulawesi Tenggara
REVITALIZATION OF STREET LIGHTING ON THE SELINDUNG BRIDGE OF PANGKALPINANG CITY USES SOLAR ENERGY TO IMPROVE NIGHTTIME AESTHETICS AND SAFETY aulia, mega; Arya Agustian; Fitriani Rahmawati; Marisa; M.Afdal Samsuddin
JAMBE: Jurnal Akuntansi Manajemen Bisnis dan Ekonomi Vol. 1 No. 2 (2024): JAMBE: Jurnal Akuntansi Manajemen Bisnis dan Ekonomi
Publisher : Fakultas Ekonomi dan Bisnis, Universitas Bangka Belitung

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

This study analyzes the opportunities for revitalizing street lighting on the Selindung Bridge, Pangkalpinang City using solar energy. The analysis used several financial analysis methods, including Net Present Value (NPV), Internal Rate of Return (IRR), Benefit Cost Ratio (BCR), and Payback Period (PP). This study aims to evaluate the planning of solar-based public street lights in improving aesthetics and nighttime safety. The results of the study indicate that this project is feasible and can be implemented financially based on the parameters evaluated. The budget used in the planning of the solar-powered public street lighting project along the Selindung Bridge road in Pangkalpinang City uses funds from the 2025 Pangkalpinang City Regional Revenue and Expenditure Budget. To consider the safety aspect of road users, it is necessary to plan public street lighting that utilizes solar energy.