Article Per Year (5 Year)
p-Index From 2021 - 2026
1.728
P-Index
This Author published in this journals
All Journal Jurnal Natur Indonesia Jurnal Penelitian Fisika dan Aplikasinya (JPFA) Jurnal Sains Materi Indonesia Journal of Education and Learning (EduLearn) JFA (Jurnal Fisika dan Aplikasinya) JURNAL ILMIAH PENDIDIKAN FISIKA AL BIRUNI Jurnal Fisika FLUX Jurnal Penelitian Pembelajaran Fisika Journal of Physics: Theories and Applications INDONESIAN JOURNAL OF APPLIED PHYSICS Molekul: Jurnal Ilmiah Kimia Jurnal Sains Materi Indonesia
Fahru Nurosyid
Physics Department, Faculty Of Mathematics And Natural Sciences, Universitas Sebelas Maret, Surakarta 57126, Indonesia
Agriculture, Biological Sciences & Forestry Humanities Astronomy Biochemistry, Genetics & Molecular Biology Chemical Engineering, Chemistry & Bioengineering Chemistry Earth & Planetary Sciences Education Electrical & Electronics Engineering Energy Engineering Industrial & Manufacturing Engineering Library & Information Science Materials Science & Nanotechnology Physics Social Sciences Other

Published : 21 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : INDONESIAN JOURNAL OF APPLIED PHYSICS

 1 
Pembuatan Ba0,8Sr0,2TiO3 menggunakan Metode Co-precipitation dengan Variasi Suhu Sintering Isma Alvia Nita; Yofentina Iriani; Fahru Nurosyid
INDONESIAN JOURNAL OF APPLIED PHYSICS Vol 7, No 1 (2017): April
Publisher : Department of Physics, Sebelas Maret University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.13057/ijap.v7i1.1776

Abstract

Ba0,8Sr0,2TiO3 was made by co-precipitation method with the sintering temperature of 600oC, 700oC, 800oC and 900oC for 4 hours. Sintering temperature was varied to investigate its effect on microstructure and dielectric constant of Ba0,8Sr0,2TiO3. microstructure characterization was performed by X-Ray Diffraction (XRD) instrument. Dielectric constant characterization was perform by LCR meter. The crystal size increased significantly with increasing sintering temperature. Measurements of dielectric constant were performed at range of frequency 0.01 to 100 KHz. Dielectric constant value is highest at the lowest frequency. Dielectric constant value size increased significantly with increasing sintering temperature.
Influence of High Sr2+ Substitution on the Structure and Photocatalytic Activity of Ba1‑XSrxTio3 for Dye Degradation Dianisa Khoirum Sandi; Trya Andini; Fahru Nurosyid; Yofentina Iriani
INDONESIAN JOURNAL OF APPLIED PHYSICS Vol 15, No 2 (2025): October
Publisher : Department of Physics, Sebelas Maret University

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.13057/ijap.v15i2.107609

Abstract

Barium strontium titanate or BST (Ba1-xSrxTiO3) photocatalysts with distinct Sr substitutions (x = 0.5, 0.6, 0.7, and 0.8) were fabricated using the co-precipitation technique. This study aimed to investigate the influence of the high Sr2+ contents on the structural property and photocatalytic activity to identify the optimal composition. X-ray diffraction (XRD analysis) confirmed cubic BST formation at all Sr concentrations and reduced lattice constants with increasing Sr²⁺ contents. Fourier transform infra-red (FTIR) investigation also validated the formation of the prepared BST with different Sr contents. The photocatalytic activity of the BST photocatalysts was evaluated by the degradation of methylene blue (MB) under UV light irradiation. Notably, the photocatalytic efficiency improved at x=0.5 to x=0.7, attributed to enhanced lattice distortion induced by Sr substitution. However, a further increase of x = 0.8 resulted in reduced photocatalytic activity, likely due to the formation of a more symmetric structure and reduced crystal distortion. Ba₀.₃Sr₀.₇TiO₃ exhibited the highest degradation rate (41%) among all samples tested. The results suggest that the high Sr level critically affects the structural properties and photocatalytic efficiency of BST and underline x = 0.7 as the optimal composition for photocatalytic applications.
Co-Authors Agung Bambang S.U. Agus Supriyanto Agus Supriyanto Antik Erlina Antik Erlina Aziza Hfii Ahliha Berliani, Rhiska Aria Budi Purnama Dianisa Khoirum Sandi Dianisa Khoirum Sandi Haq, Fat Hana Rizqi Isma Alvia Nita Kamsul Abraha Khoiria, Salsa Nurul Kusumandari, Kusumandari Mar Atun Shofwati Maura Trynovita Sakliressy Maya Dwi Fistiani Muhamad Yudatama Perdana Ningrum, Eka Silvia Nonoh Siti Aminah Nonoh Siti Aminah Nur Habib Rizki Saputro Pangesti, Desita Suci Pregia Anugratama Pusaka, Semerdanta Putri Lestari, Putri Ratna Mayasari Risa Suryana Sakliressy, Maura Trynovita Sandi, Dianisa Khoirum Sri Wahyuni Trya Andini Widha Sunarno Widha Sunarno Yofentina Iriani Yofentina Iriani Yofentina Iriani Yofentina iriani Zakaria Sandy Pamungkas