Claim Missing Document
Check
Articles

Found 6 Documents
Search
Journal : Infotekmesin

Pengaruh Diethyl Ether Terhadap Torsi dan Daya Mesin Diesel Injeksi Langsung Berbahan Bakar Solar Campuran Jatropa Faqih Fatkhurrozak; Firman Lukman Sanjaya; Syarifudin Syarifudin; Syaiful Syaiful
Infotekmesin Vol 11 No 2 (2020): Infotekmesin: Juli 2020
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v11i2.258

Abstract

Increasing consumption of fossil fuels, depleting oil reserves and increasingly expensive fuels have forced the use of alternative fuels. Diethyl ether (DEE) can be used as an alternative fuel because it has a high cetane number, low viscosity, and high oxygen content. This observation was carried out to determine the effect of the addition of Diethyl ether on 20% diesel-jatropha fuel mixture to the torque and power produced. Tests carried out on a 4JB1 type direct injection diesel engine with a constant speed of 2500 rpm. The DEE volume used is 5%, 10%, and 15% is volume-based. The test results show 20% jatropha content produces lower torque and power compared to pure diesel fuel (D100). Also, the addition of DEE to 20% diesel-jatropha fuel produces low torque and power but the value is higher than 20% of diesel-jatropha fuel. The highest torque and power reduction trends occurred in the use of DJ20 fuel by 0.0448% when loading 25%. While the lowest decrease in torque and power occurs in the DJ20DEE15 fuel by 0.0112% with 100% loading compared to D100 fuel.
Uji Eksperimental Emisi Gas Buang Mesin Bensin 160 cc Berbahan Bakar Campuran Pertalite-Butanol dan Pertalite-Diethyl Ether (DEE) Firman Lukman Sanjaya; Syarifudin; Faqih Fatkhurrozak; Nur Aidi Ariyanto
Infotekmesin Vol 13 No 2 (2022): Infotekmesin: Juli, 2022
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v13i2.1543

Abstract

Air pollution is increasing due to the high exhaust emissions of motorized vehicles using fossil fuels. The solution is the use of alternative energy. Butanol and Diethyl Ether (DEE) are alcohols that can be used as a fuel mixture and are environmentally friendly. This is because butanol and DEE have high oxygen levels so the oxidation process in the combustion chamber increases and the residual gas results from combustion is better. This study tested the residual gas from the combustion of a 160 cc gasoline engine using a mixture of pertalite-butanol and pertalite-DEE fuels with 5%, 10%, and 15% alcohol percentages. The test results show that adding DEE produces better engine exhaust emissions than adding butanol. CO emissions decreased by 87% using DEE15 while B15 reduced CO by 72%. DEE10 improves HC by 73% while B15 improves HC by 72%. However, DEE15 increases CO2 by 17% and B15 by 11%. Meanwhile, the oxygen content increased by 8% in DEE15 and 6% in B15 compared to pure pertalite.
Karakteristik Emisi CO dan HC Mesin bensin SOHC 110cc Berbahan bakar Pertalite-Alkohol Syarifudin; Faqih Fatkhurrozak; Firman Lukman Sanjaya; Eflita Yohana; Syaiful
Infotekmesin Vol 13 No 1 (2022): Infotekmesin: Januari, 2022
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v13i1.1067

Abstract

Community economic activities that encourage motorized vehicles are getting higher. This exacerbates dependence on fossil fuels and air pollution. The outside air that is contaminated with exhaust gases from combustion products is very dangerous for human health. Motorized vehicles such as motorcycles are the largest cause of air pollution. Alcohols have high octane number and low viscosity. The use of ethanol and methanol alcohols is very diverse, so they are easy to obtain. Therefore, alcohol ethanol and methanol are suitable as premium fossil fuel mixtures. This study aims to observe the CO and HC emission characteristics of the gasoline engine using a premium-alcohol mixture of ethanol, methanol. The alcohol concentration was varied from 5% to 15% at 5% intervals. The petrol engine is operated at 2000, 3000, and 4000rpm. Commercial Gas Analyzers are used to measure CO and HC emissions coming out of the exhaust. The results of the observations present the CO and HC emissions of the engine with premium-ethanol fuel, methanol is lower than pure premium (P100). CO emissions from PE15 fuel decreased to 66,30%, and PM15 decreased to 90,63%. Meanwhile, PE15 fuel HC emissions decreased by 58,94%, and PM15 decreased by 68,60%.
Pengaruh Penambahan methanol Terhadap Emisi Bahan Bakar Mesin Sepeda Motor Berbahan Bakar Pertamax 150 CC Faqih Fatkhurrozak; Firman Lukman Sanjaya; Syarifudin Syarifudin; Andre Budhi Hendrawan; M. Khumaidi Usman; Gunawan Gunawan
Infotekmesin Vol 14 No 2 (2023): Infotekmesin: Juli, 2023
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v14i2.1719

Abstract

Automotive vehicles have increased every year, especially motorcycles, which result in increased air pollution. The use of alternative fuel methanol is one of the solutions to control air pollution. methanol has a high oxygen content so it can improve emissions. This study aims to analyze the use of a mixture of Pertamax and methanol fuel on exhaust emissions using a 150 cc EFI gasoline engine. The percentage of methanol used in the test is 5%, 10%, and 15%. Variation of engine speed from 1000 to 3000 rpm with an interval of 1000 rpm. Measurement of exhaust emissions using a gas analyzer. The addition of methanol to Pertamax fuel reduced HC emission levels at PM15 by 34% at 3000 rpm and CO by 43% at 3000 rpm at PM15, while CO2 and O2 emission levels increased by 23% at 3000 rpm at CO2, mixing PM15 and at O2 emissions of 163% at a speed of 3000 rpm on PM5.
Analisis Penambahan Methanol 5%, 10% dan 15% Terhadap Torsi, Daya dan Exhaust Gas Temperature (EGT) Mesin Bensin 150 CC Berbahan Bakar Pertamax Faqih Fatkhurrozak; Firman Lukman Sanjaya; Syarifudin; Amin Nur Akhmadi; Nur Aidi Ariyanto; Gunawan
Infotekmesin Vol 15 No 1 (2024): Infotekmesin: Januari, 2024
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v15i1.2064

Abstract

Indonesia is one of the countries that uses the most motorized vehicles, which increases air pollution and fuel crises. Using biofuel is one solution to overcome this problem. Methanol is used as a mixture of Pertamax to produce environmentally friendly and renewable biofuel. This is because methanol has high octane and oxygen. Mixing methanol in Pertamax was carried out to analyze the impact of Torque, Power, and Exhaust Gas Temperature (EGT) of a 150cc petrol engine. Methanol 5%, 10%, and 15% was mixed into Pertamax with engine speed variations of 1000, 2000 and 3000 rpm. Dynotest is used to measure engine performance and thermocouples to measure EGT. Test results show the highest increase in engine torque and power of up to 25% at a speed of 2000 rpm with the PM15 mixture compared to P100. The highest reduction in EGT value occurred when using the PM15 mixture at a speed of 1000 rpm up to 28% compared to P100. This shows that the addition of methanol to Pertamax increases torque and power and reduces the EGT of the gasoline engine.
Brake Thermal Efficiency dan Exhaust Gas Temperature Mesin Bensin Berbahan Bakar Gasoline-Butanol Firman Lukman Sanjaya; Faqih Fatkhurrozak; Syarifudin; Amin Nur Akhmadi
Infotekmesin Vol 15 No 1 (2024): Infotekmesin: Januari, 2024
Publisher : P3M Politeknik Negeri Cilacap

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35970/infotekmesin.v15i1.2154

Abstract

The development of butanol as a gasoline additive is encouraged by the government to reduce pollution and the fuel crisis. This is because butanol is a green fuel that is environmentally friendly and can be produced. In addition, the octane number and high oxygen concentration in butanol optimize engine performance and improve exhaust emissions. This research correlates engine power and Brake specific fuel consumption (BSFC) with the BTE of gasoline-butanol-fueled engines and identifies the content of Nox compounds in exhaust gases through engine Exhaust Gas Temperature (EGT). The percentage of butanol in gasoline is 5% -15%. Engine speed from 1000-3000 rpm. Dynotest is used to measure BTE while the thermocouple is used to measure exhaust gas temperature. This research proves that the addition of butanol increases energy absorption which is converted into power with effective fuel consumption which means BTE increases. The highest BTE increase was 21.7% in the B15 blend. EGT decreased by 8.6% in the B16 mixture compared to B0. This identifies that the concentration of Nox in the exhaust gas also decreases.