Article Per Year (5 Year)
p-Index From 2020 - 2025
0
P-Index
This Author published in this journals
All Journal Semesta Teknika Prosiding Seminar Nasional Program Pengabdian Masyarakat
Nurcahyadi, Teddy
Universitas Muhammadiyah Yogyakarta
Agriculture, Biological Sciences & Forestry Chemical Engineering, Chemistry & Bioengineering Economics, Econometrics & Finance Engineering Medicine & Pharmacology Social Sciences

Published : 4 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 4 Documents
Search

 1 
Pengaruh Lokasi Ketebalan Maksimum Airfoil Simetris Terhadap Koefisien Angkat Aerodinamisnya Nurcahyadi, Teddy; Sudarja, Sudarja
Jurnal Semesta Teknika Vol 11, No 1 (2008): MEI 2008
Publisher : Jurnal Semesta Teknika

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Airfoil performance data is regarded as highly valuable data in its wide area of application since it will help the designer, for examples; to predict the influence of rear spoiler mounting to the maneuverability and top speed of racing car, the thrust and fuel consumption needed for an aircraft to take off and cruise, or the power delivered by a wind turbine rotor at certain wind speed. The performance of airfoil, which is measured with its lift and drag coefficient, is greatly affected by its geometry and operating condition. The influence of various geometric and operational parameters to the airfoil performance is needed to be studied experimentally and the airfoil performance data obtained can be added to enrich the airfoil performance data base. The experiment was done by testing airfoil models by lift force direct measurements in a sub-sonic wind tunnel.  The type of airfoil used in this experiment is the symmetric airfoil with maximum thickness location as the geometric parameter and angle of attack with wind speed as the operational parameter being investigated for their influence to the lift and drag coefficient. The maximum thickness location was varied in 30%, 40%, and 50% of chord length measured from leading edge. The angle of attack was varied from 0o to 20o with 4o increments. The wind speed was varied from 10 m/s to 20 m/s with 2 m/s increments.  Parameters being measured were the free stream velocity, and the lift force. The result of the research shows that the best airfoil performance with lift coefficient 3,16 is achieved by the airfoil that has maximum thickness location in 40% of its chord length measured from its leading edge and operates at 20o angle of attack and 8,9  m/s free stream velocity.
Performance of a 160 cc Four-Stroke Engine Using Non-Programmable Aftermarket CDI and Aftermarket Ignition Coil When Operating With Three Types of Gasoline Nurcahyadi, Teddy; Wahyudi, Wahyudi; Ruswanto, Dwi Isnaini; Ramadhani, Fithrio Manggala; Sidiq, Burhannudin; Handoko, Wahyu Tri
Semesta Teknika Vol 20, No 2 (2017): NOVEMBER 2017
Publisher : Semesta Teknika

Show Abstract | Download Original | Original Source | Check in Google Scholar

Abstract

Ignition timing and output voltage must be re-tuned when the engine used different types of fuel.  This research aimed to investigate the effectiveness of CDI and ignition coil upgrade, both separately and combined, when various types of fuel was used by the engine.  This research was done on a 160 cc four-stroke engine of a Honda motorcycle with compression ratio 9:1.  The types of fuel used by the engine in this research was RON 88, RON 90, and RON 95 gasoline fuels. The engine’s torque was measured on an inertial type motorcycle chassis dynamometer.  The fuel consumption data was obtained by on road test, the value of the data was calculated by dividing the distance being traveled with the volume of fuel being consumed. The result of this research showed that when RON 88 gasoline was used, the influence of aftermarket CDI and aftermarket ignition coil gave almost comparable impacts to the increase of torque.  The combination of aftermarket CDI and aftermarket ignition coil was found to influence the largest torque increase percentage of 5.3% when RON 90 gasoline was used.  When RON 95 gasoline was used, the aftermarket ignition coil influenced the largest torque increase percentage of 4.3% at lower engine speed and 7.4% at higher engine speed.  The aftermarket CDI and aftermarket ignition coil, whether used separately or combined, always gave worse impact to fuel consumption when RON 88 and RON 90 gasoline was used. The opposite is true when RON 95 was used.
Inisiasi Pembangunan Eco-Village Berbasis Masyarakat Gatot Supangkat Samidjo; Teddy Nurcahyadi; Fajar Junaedi
Prosiding Seminar Nasional Program Pengabdian Masyarakat 2019: 1. Pengembangan Pendidikan Masyarakat
Publisher : Universitas Muhammadiyah Yogyakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (359.281 KB) | DOI: 10.18196/ppm.21.560

Abstract

Implementasi program Eco-Village ditujukan untuk mengarahkan kehidupan masyarakat menjadi lebihbaik, dalam hal ekonomi, sosial, dan jaminan masa depannya. Program inisiasi ini diterapkan di DusunKuncen, Desa Cawas, Klaten selama empat bulan. Metode yang digunakan dalam implementasiprogram ini, yaitu Diskusi Kelompok Terfokus (DKT), penilaian partisipatif, implementasi bertahap(tahap inisiasi, pelaksanaan, dan evaluasi). Hasil implementasi inisiasi program Eco-Village di RW 09,Kuncen, Cawas, Klaten bahwa program yang ditawarkan sebagai solusi permasalahan masyarakat dapatditerima dan dilaksanakan. Perlu kelanjutan program yang terkait dengan pengembangan pemasaranproduk dan pengelolaan air dan komponen Eco-Village lebih lanjut. Di sisi lain, program perludidiseminasikan dan dikembangkan ke warga masyarakat terdekat dan desa secara umum dengan RW09 sebagai Pusat Pengembangannya.
Performance of a 160 cc Four-Stroke Engine Using Non-Programmable Aftermarket CDI and Aftermarket Ignition Coil When Operating With Three Types of Gasoline Teddy Nurcahyadi; Wahyudi Wahyudi; Dwi Isnaini Ruswanto; Fithrio Manggala Ramadhani; Burhannudin Sidiq; Wahyu Tri Handoko
Semesta Teknika Vol 20, No 2 (2017): NOVEMBER 2017
Publisher : Universitas Muhammadiyah Yogyakarta

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.18196/st.v20i2.3347

Abstract

Ignition timing and output voltage must be re-tuned when the engine used different types of fuel.  This research aimed to investigate the effectiveness of CDI and ignition coil upgrade, both separately and combined, when various types of fuel was used by the engine.  This research was done on a 160 cc four-stroke engine of a Honda motorcycle with compression ratio 9:1.  The types of fuel used by the engine in this research was RON 88, RON 90, and RON 95 gasoline fuels. The engine’s torque was measured on an inertial type motorcycle chassis dynamometer.  The fuel consumption data was obtained by on road test, the value of the data was calculated by dividing the distance being traveled with the volume of fuel being consumed. The result of this research showed that when RON 88 gasoline was used, the influence of aftermarket CDI and aftermarket ignition coil gave almost comparable impacts to the increase of torque.  The combination of aftermarket CDI and aftermarket ignition coil was found to influence the largest torque increase percentage of 5.3% when RON 90 gasoline was used.  When RON 95 gasoline was used, the aftermarket ignition coil influenced the largest torque increase percentage of 4.3% at lower engine speed and 7.4% at higher engine speed.  The aftermarket CDI and aftermarket ignition coil, whether used separately or combined, always gave worse impact to fuel consumption when RON 88 and RON 90 gasoline was used. The opposite is true when RON 95 was used.
Co-Authors Burhannudin Sidiq Dwi Isnaini Ruswanto Fajar Junaedi Fithrio Manggala Ramadhani Handoko, Wahyu Tri Ramadhani, Fithrio Manggala Ruswanto, Dwi Isnaini Sidiq, Burhannudin Sudarja Sudarja, Sudarja Wahyu Tri Handoko Wahyudi, Wahyudi