Claim Missing Document
Check
Articles

Found 11 Documents
Search
Journal : Journal of Electrical Power Control and Automation (JEPCA)

Rancang Bangun Turbin untuk PLTMH di Jalan Bintara Sungai Duren Kecamatan Jambi Luar Kota Kabupaten Muaro Jambi Ahmad Murtadho; Venny Yusiana
Journal of Electrical Power Control and Automation (JEPCA) Vol 2, No 2 (2019): Desember
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (698.096 KB) | DOI: 10.33087/jepca.v2i2.27

Abstract

This research was conducted to determine the characteristics of water turbine used on micro hydro Power Plant (PLTMH) by observing the influence of high variation falling water to the turbine generated round and rotation transmission variation with different pulley diameter to generate the rotation used for rotating the generator. The results showed that high water-falling water streams have an effect on the resulting rounds of turbines, and varying the pulley transmission system can also maximize the rotation on the generator.
Evaluasi Aktifitas Belajar Mahasiswa Berbasis Teknologi Informasi Pada Masa Pandemi Covid 19 di Fakultas Teknik Universitas Batanghari Jambi Venny Yusiana; Eko Suprapto
Journal of Electrical Power Control and Automation (JEPCA) Vol 4, No 2 (2021): Desember
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v4i2.52

Abstract

Information technology is an information service that is used as a form of interaction used by students during the COVID-19 pandemic. One of them as a medium of learning or communication. This study using quantitative methods that are analytical observational through the distribution of questionnaires through a google form. The distribution of the sample was 323 respondents with a research design in the form of a cross-sectional study approach. The results of data analysis based on univariate stated that 50.8% of respondents stated that learning dared to support learning activities but did not experience a significant increase, while bivariate analysis of information technology supported Unbari students' interactions with learning activities. during the covid 19 pandemic.
Sistem informasi yang berkualitas di bpjs kesehatan Kota palembang Venny Yusiana
Journal of Electrical Power Control and Automation (JEPCA) Vol 1, No 1 (2018): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (590.726 KB) | DOI: 10.33087/jepca.v1i1.6

Abstract

Information systems have evolved along with technological developments that are very fast and proven in various activities. The existence of information systems that encourage performance, effectiveness and variety for various institutions. This research is to see the representation of quality information system at Health BPJS Palembang city based on the right variables. The results of the research indicate the value of the variables in the quality information system using the AMOS converter for the SEM method in the early stages.
Rancang Bangun Fire Alarm dan Smoke Detector Berbasis Programmable Logic Controller (PLC) Tyfe SR3B261BD Hafis Darmawan; Venny Yusiana; Herberth Siregar
Journal of Electrical Power Control and Automation (JEPCA) Vol 5, No 2 (2022): Desember
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v5i2.77

Abstract

Programmable logic controller (PLC) can be design for various purposes, one of which is to design a fire extinguishing system, by assembling several components of PLC, solenoid, spingkle, power supply, adaptor,smoke detector, heat detector, pilot lamp, push button,relay, selector switch, Design the program setting to detect smoke and high temperetures that occur in the event of a fire. If the smoke detector detect smoke and high temperatures, the sensor will give a signal to the plc to turn on and activate all working components and extinguish the fire. . In the future, the use of this tool can be installed in lecture rooms in Unbari, especially the Faculty of Engineering room and developed for the use of Human Interface which is directly connected to firefighters.
Pengolahan Lindi Tempat Pemprosesan Akhir Sampah Talang Gulo Dengan Metode Elektrolisis S, Guntar Marolop; Kalsum, Siti Umi; Yusiana, Venny; Putri, Nur Juliana
Journal of Electrical Power Control and Automation (JEPCA) Vol 6, No 1 (2023): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v6i1.102

Abstract

The Talang Gulo control landfill waste final processing site (TPA) has been decommissioned and converted into a Sanitary Landfill TPA in the city of Jambi. Even though it has been deactivated, the waste resulting from the decomposition of waste at the TPA control landfill must be managed. One of the wastes that is managed is leachate. Before being released into the environment, leachate must be processed in leachate ponds so that the receiving environment is not polluted. Some of the leachate parameters that must be managed are mercury (Hg) and cadmium (Cd), because if these two parameters enter surface water they will have a negative impact on aquatic biota. The research is planned at the Batanghari University Engineering Laboratory. On a laboratory scale, the Hg and Cd parameters of leachate can be reduced using the electrolysis method. Electrolysis is an alternative method for processing leachate because the chemical reaction process using electrodes can reduce the Hg and Cd parameters. The hypothesis that can be taken is that the electrolysis method can reduce the Hg and Cd parameters of landfill leachate.
Studi Aliran Daya pada PT. PLN (Persero) UIWS2JB UP3 Jambi ULP Kotabaru Penyulang Palem dengan Menggunakan Software Electric Transient and Analysis Program (ETAP) Yono, Hadi Febra; Thamrin, NJ.; Yusiana, Venny
Journal of Electrical Power Control and Automation (JEPCA) Vol 7, No 1 (2024): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v7i1.112

Abstract

Planning in the use of components in a power system needs to be done correctly. The planning will affect the optimization of the system in distributing power. Suboptimal power distribution will have an impact on the continuity of the power being distributed. The analysis that will be carried out is a power flow analysis. This research was taken using data from ULP Kota Baru Penyulang Palem, the location of this research is located in the distribution system area of Jambi City, Jambi Province, with the connection center at Penyulang Palem which is located in Kota Baru District, Jambi City, Jambi Province. . KVA is used to measure the total power in an electrical system. Total power includes active power and reactive power, so KVA provides a more complete picture of the power requirements of an electrical system. In the KVA measurement, it is assumed that all loads connected on a single line are 85%, 90%, 95%. That the greater the assumed load of the transformer and the farther away from the source, the greater the voltage drop / the smaller the voltage The greater the resistance the smaller the voltage drop, if the smaller the resistance then the drop will be larger. The wider the cross-section, the smaller the strain drop. The highest measurement of all loads is 3918 kv at the base of the source located near the bus in JB1100 assuming all loads of 95%.  
Analisis Dugaan Kerusakan Rumah Yang Berdekatan Dengan Menara Telekomunikasi Suhendra, Suhendra; Yusiana, Venny
Journal of Electrical Power Control and Automation (JEPCA) Vol 6, No 1 (2023): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v6i1.103

Abstract

In general lightning will predominantly strike parts of the earth's surface that have tall structures (tall buildings, BTS towers, high voltage transmission towers) and prefer structures made of conductive materials such as metal. The existence of a house close to a Telecommunication Tower is the background for this research. The research aims to analyze suspected damage that occurred to residential buildings that are very close to telecommunications tower activity. The method used is a general study of the feasibility of telecommunications towers as well as the types and patterns of damage that occurred in the houses studied. The results show that the damage that occurs to houses is mostly caused by the bearing capacity of the soil which is less affected by the shrinkage of the concrete. A comprehensive assessment needs to be carried out for telecommunications towers, especially the lightning conduction and grounding systems.
Study Evaluasi Pemasangan Pembangkit Listrik Tenaga Surya Sistem Hybrid pada PT. Makmur Indah Selaras Internasional Kabupaten Muaro Jambi Provinsi Jambi Saputra, Hendi; Thamrin, NJ.; Yusiana, Venny
Journal of Electrical Power Control and Automation (JEPCA) Vol 7, No 1 (2024): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v7i1.113

Abstract

PT. Makmur Indah Selaras is an oil palm industry company operating in Muaro Jambi Regency, Jambi Province. For the industrial sector, electrical energy is needed for lighting as well as electric machines and motors. At PT. Makmur Indah Selaras Internasional this has led to an increase in the need for electrical energy. Solutions for the development of electrical energy needs at PT. Makmur Indah Selaras Internasional is by replacing the roof with solar panels with the use of new renewable energy (NRE) New renewable energy which is provided in the form of solar power plants. Roof to maximize the use of solar roofs as land in the application of solar panels. Calculating the power produced by PLTS HYBRID PT. Makmur Indah Selaras International. Calculating the number of materials and components used in PLTS HYBRID PT. prosperous Indah Selaras International. Electrical energy is produced during the day more than in the morning or evening. The average energy produced during the day is 379 -389 Volts.
Kajian Teknis Dan Finansial Interkoneksi Pembangkit Listrik Tenaga Biogas Dari Palm Oil Mill Effluent (POME) Pada Sistem 20 KV Di Kabupaten Musi Rawas Thamrin, Nj.; Yusiana, Venny
Journal of Electrical Power Control and Automation (JEPCA) Vol 6, No 1 (2023): Juni
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v6i1.104

Abstract

Using renewable energy is one way to reduce global warming. Minister of Energy and Mineral Resources Regulation No. 21 of 2016 concerning Purchase of Electricity and Biogas Power. The government has supported efforts to develop electrical energy from biogas. PT Evans Lestari is an oil palm plantation company operating in Mura with a plantation area of 9,220 ha and a mill of 60 tons/hour. In order to fulfill PLN's requirements to offer electricity supply, it is necessary to carry out a technical assessment of the connection and an economic analysis. The connection of the EBT PLT to PLN's 20 kV distribution system has been regulated in Directors' Decree No. 0357.K/DIR/2014. The benefits obtained from using DG include reducing power losses and improving the voltage profile of the distribution system. Among the types of DG that are commonly used, one of them is the Bio Gas Power Plant (PTBG) fueled by liquid palm oil waste.
Motor 3 Fasa Star Delta Menggunakan Outseal PLC (Programmable Logic Control) Nurcholis, Adi; Thamrin, Nj.; Yusiana, Venny
Journal of Electrical Power Control and Automation (JEPCA) Vol 6, No 2 (2023): Desember
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/jepca.v6i2.105

Abstract

With the development of science and technology, the use of electrical energy will continue to increase in households and industry. One of them is the use of a three-phase induction motor which is often used in industry in the production process. The many types of induction motors used require the selection of a more efficient system. The induction motor regulation system can be done manually or automatically. To automatically regulate the system, it can be done by applying programmable logic control (PLC). The aim of this research is to develop an automatic 3-phase electric motor control system using Outseal Programmable Logic Control (PLC).