Article Per Year (5 Year)
p-Index From 2021 - 2026
1.325
P-Index
This Author published in this journals
All Journal International Journal of Applied Power Engineering (IJAPE) PROtek : Jurnal Ilmiah Teknik Elektro Journal of Science and Engineering Patria Artha Technological Journal Jurnal Pengabdian Khairun
Rasyid, Ramly
Universitas Khairun
Religion Agriculture, Biological Sciences & Forestry Arts Civil Engineering, Building, Construction & Architecture Computer Science & IT Control & Systems Engineering Decision Sciences, Operations Research & Management Economics, Econometrics & Finance Education Electrical & Electronics Engineering Energy Engineering Industrial & Manufacturing Engineering Languange, Linguistic, Communication & Media Mechanical Engineering Transportation

Published : 7 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 7 Documents
Search

 1 
MONITORING SUDUT FASA MENGGUNAKAN MIKROKONTROLER BERBASIS INTERNET OF THINGS (IOT) ramly rasyid; Miftah Muhammad; Rahman R Rasyid
Journal of Science and Engineering Vol 6, No 2 (2023): JOURNAL OF SCIENCE AND ENGINEERING (JOSAE)
Publisher : Fakultas Teknik Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/josae.v6i2.6885

Abstract

Phase angle is very important in determining active power and reactive power parameters in AC power sources so it needs to be monitored. This research created a phase angle monitoring tool based on the Internet of Things (IoT) using the blynk application, apart from monitoring phase angles it also monitors voltage, current and power factor. The method used is an experimental method, which starts with hardware design using a Node MCU where the Node MCU will later convert analog electrical quantities to digital while the PZEM 004-V30 sensor contains a voltage sensor and a current sensor which detects analog quantities sent to Node MCU, software design using Arduino IDE and IoT using the Blynk application then testing the tool created. Testing for measuring and monitoring phase angles and reactive power will be compared with the Haiko clamb meter so that the measurement error presentation can be seen. The presentation of phase angle measurement errors for loads of 1x36 Watt, 2x36 Watt, 3x36 Watt and 4x36 Watt respectively are 4.32%, 3.40%, 1.77% and 1.32%. The error is below 5%, so the performance of this tool can be said to be good. The highest error presentation was 4.52% for the 1x36 Watt TL lamp load, while the smallest error presentation was 1.32% for the 4x36 Watt TL lamp load.
Single-phase distributed generations for power balanced using adaptive real coded genetic algorithm Umar, Umar; Faanzir, Faanzir; Iswan, Iswan; Rasyid, Ramly; Rahman, Muhammad Natsir; Khairan, Amal; Haryati, Haryati
International Journal of Applied Power Engineering (IJAPE) Vol 13, No 1: March 2024
Publisher : Institute of Advanced Engineering and Science

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.11591/ijape.v13.i1.pp11-19

Abstract

Easy access to distributed generation (DG) technology is promoting the utilization of single-phase DGs for residential purposes. Surplus energy generated by household DGs can be shared or sold to other communities through existing networks. However, the interconnection of single-phase DGs from residential generators to the distribution network requires careful handling to secure the reliability and quality of the electric power system. This paper focuses on the optimal placement of single-phase multi-type DGs on unbalanced distribution systems that are connected to nonlinear loads. The objective of this study is to minimize the power losses and voltage unbalances in the distribution networks. To verify the efficacy of this method in reducing voltage unbalances and harmonics, an optimization approach is also presented using three-phase DG. Optimal placement of DG is performed on a modified Kaliasin distribution system using an adaptive real coded genetic algorithm (ARC-GA). Simulation results demonstrate that the installation of single-phase DGs is highly effective in reducing power losses and voltage unbalances in the distribution networks.
Pelatihan Pemasangan Saklar Berbasis Mikrokontroler Pada Instalasi Listrik Untuk Pemuda Di Desa Bukit Durian Kota Tidore Kepulauan Rasyid, Ramly; Muhammad, Mifta; Saifuddin, Hafid
Jurnal Pengabdian Khairun Vol 3, No 2 (2024)
Publisher : Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/jepk.v3i2.9055

Abstract

Pelatih (trainer) memastikan bahwa setiap individu dapat secara efektif menggunakan teknologi-teknologi baru termasuk implementasi mikrokontroler pada instalasi listrik khususnya pada pemutus aliran listrik. Identifikasi masalah yang ditemukan adalah kurangnya sarana dalam memahami implementasi mikrokontroler dan keterbatasan pemuda desa dalam mengembangkan kreatifitas dan kemampuan diri, maka solusinya harus ada pelatihan yang bias menggabungkan pengetahuan yang didapatkan disekolah dengan keterampilan yang lain sehingga bisa membekali para pemuda menjadi seorang yang lebih trampil. Metode yang digunakan dalam pengabdian ini adalah dilakuka dengan ceramah singkat selanjutnya dilakukan tanya jawab dan demonstrasi untuk memperlihatkan langkah kerja setiap materi yang diberikan, kemudian dilakukan evaluasi agar dapat mengetahui apakah ada peningkatan pengetahuan dan keterampilan dalam menerapkan materi pelatihan yang diberikan. Kegiatan pengabdian ini berjalan sesuai dengan yang diharapkan yang hasilnya yaitu para pemuda di Desa Bukit Durian Kota Tidore Kepulauan  dapat meningkatkan pengetahuan dan ketrampilannya dalam memasang saklar pada instalasi listrik berbasis mikrokontroker.Kata kunci: Pelatihan, Saklar, Instalasi listrik, mikrokontroler
Pengaturan Kecepatan Motor Induksi Tiga Fasa Menggunakan Spwm Inverter dan Kontrol Pid dengan Metode Hibrid Volt/Herzt Konstan-Sensor Arus Rasyid, Ramly; Muhammad, Miftah; Rasyid, Rahman R.
PROtek : Jurnal Ilmiah Teknik Elektro Vol 9, No 1 (2022): Protek : Jurnal Ilmiah Teknik Elektro
Publisher : Program Studi Teknik Elektro Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/protk.v9i1.4201

Abstract

Three-phase induction motors are often used in every industry because three-phase induction motors are relatively cheap. On the three-phase induction motor in order to get a varied speed, one of the methods is the Three-Phase Induction Motor Speed Setting Using SPWM Inverter And Hybrid Volt/Herzt Constant-Sensor Current-Density PID Control in order to maintain the speed of the motor. This simulation was carried out with Matlab 2007 software. Induction motor speed performance set with a set point of 100 rad/detm 140 rad/sec, and 200 rad.det is a consecutive rise time of 0.002 seconds, 0.00116 seconds, and 0.006 seconds, a maximum overshoot of 5.4%, 1.25%, and 0.875% respectively and 0.1518 seconds, 0.1464 seconds, and 0.15 seconds respectively. The response torkanya values between 75 Nm, 90 Nm, and 100 Nm respectively, while the performance of the insulated current is very small
Pelatihan Pemasangan Saklar Berbasis Mikrokontroler Pada Instalasi Listrik Untuk Pemuda Di Desa Bukit Durian Kota Tidore Kepulauan Rasyid, Ramly; Muhammad, Mifta; Saifuddin, Hafid
Jurnal Pengabdian Khairun Vol 3, No 2 (2024)
Publisher : Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/jepk.v3i2.9055

Abstract

Pelatih (trainer) memastikan bahwa setiap individu dapat secara efektif menggunakan teknologi-teknologi baru termasuk implementasi mikrokontroler pada instalasi listrik khususnya pada pemutus aliran listrik. Identifikasi masalah yang ditemukan adalah kurangnya sarana dalam memahami implementasi mikrokontroler dan keterbatasan pemuda desa dalam mengembangkan kreatifitas dan kemampuan diri, maka solusinya harus ada pelatihan yang bias menggabungkan pengetahuan yang didapatkan disekolah dengan keterampilan yang lain sehingga bisa membekali para pemuda menjadi seorang yang lebih trampil. Metode yang digunakan dalam pengabdian ini adalah dilakuka dengan ceramah singkat selanjutnya dilakukan tanya jawab dan demonstrasi untuk memperlihatkan langkah kerja setiap materi yang diberikan, kemudian dilakukan evaluasi agar dapat mengetahui apakah ada peningkatan pengetahuan dan keterampilan dalam menerapkan materi pelatihan yang diberikan. Kegiatan pengabdian ini berjalan sesuai dengan yang diharapkan yang hasilnya yaitu para pemuda di Desa Bukit Durian Kota Tidore Kepulauan  dapat meningkatkan pengetahuan dan ketrampilannya dalam memasang saklar pada instalasi listrik berbasis mikrokontroker.Kata kunci: Pelatihan, Saklar, Instalasi listrik, mikrokontroler
Pelatihan Pengasutan Motor Induksi Tiga Fasa Berbasis Mikrokontroler Pada Siswa SMK Negeri 2 Kota Ternate rasyid, ramly; Hadi Sirat, Muhammad Apriyadi
Jurnal Pengabdian Khairun Vol 4, No 2 (2025)
Publisher : Universitas Khairun

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33387/jepk.v4i2.11150

Abstract

Kegiatan pengabdian ini bertujuan untuk meningkatkan penguasaan teknologi kelistrikan modern di SMK Negeri 2 Kota Ternate, khususnya dalam pengasutan motor induksi tiga fasa yang masih konvensional. Pelatihan berbasis mikrokontroler menggunakan NodeMCU ESP32 diadakan untuk menjembatani kesenjangan teknologi dan meningkatkan kompetensi siswa Jurusan Teknik Instalasi Tenaga Listrik. Metode pelatihan meliputi ceramah, tanya jawab, demonstrasi, dan praktik langsung di bawah bimbingan tim pelaksana, diikuti oleh 25 siswa. Fokus utama kegiatan ini adalah pemrograman menggunakan Arduino IDE dan perakitan perangkat keras untuk mengintegrasikan modul kontrol berbasis mikrokontroler dengan panel motor. Hasil akhir adalah sistem pengasutan motor induksi tiga fasa yang fungsional dan dapat dioperasikan secara nirkabel melalui aplikasi Blynk pada smartphone, menunjukkan keberhasilan transfer teknologi kepada siswa.Kata Kunci: Pelatihan, Starting, Motor Induksi, IoT
Perencanaan Pembangkit Listrik Tenaga Surya (PLTS) Atap Off Grid Di Mesjid Al-Anshar, Kelurahan Maliaro Ternate Abbas, Muhammad yunus Hi; Rasyid, Ramly; Syaifuddin, Hafid
Patria Artha Technological Journal Vol 9, No 2 (2025): Patria Artha Technological Journal
Publisher : Department of Electrical Engineering, University of Patria Artha

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33857/patj.v9i2.1020

Abstract

This solar power plant system illustrates a process of maximizing renewable energy utilization. Frequent power outages due to system disruptions cause damage to many electronic devices, so a system was designed to support electricity availability within the mosque. This research method utilizes qualitative research, systematically recording observations and interviews. The qualitative research process begins with establishing basic assumptions and the rules of thought that will be applied in the study. This study will utilize Helioscope software simulations, which simulate system operation to determine the arrangement and number of solar panels, batteries, and inverters used under specified conditions, as well as the system's operation. The results of the PLTS system simulation designed using Helioscope software include 4 units of Longi PLTS Modules, LRS-72HPH-550M (220) with a capacity of 550 W, 4 units with a total installed capacity of 2.20 kW, as well as 1 unit of SPF 5000 ES (5 kW) inverter and 3 units of Lithium iron Phosphate batteries (48 V, 100 Ah).  
Co-Authors Abbas, Muhammad Yunus Hi Amal Khairan Faanzir, Faanzir Hadi Sirat, Muhammad Apriyadi Haryati Haryati Iswan Iswan Muhammad, Mifta Muhammad, Miftah Muhammad, Miftah Rahman R Rasyid Rahman, Muhammad Natsir Rasyid, Rahman R. Saifuddin, Hafid Syaifuddin, Hafid Umar Umar