<![CDATA[Plastic waste accumulation poses a severe environmental burden, particularly in urban and archipelagic regions where centralized treatment infrastructure is limited. While thermal processing offers a pathway for volume reduction and material recovery, inadequate temperature control frequently leads to uncontrolled combustion and the formation of hazardous air pollutants. This study addresses this gap by developing and experimentally validating a low-emission, IoT-enabled mobile plastic melting system designed for decentralized paving block production. The proposed system integrates real-time thermal sensing using a K-type thermocouple and an ESP32-based controller with a compact three-nozzle water spray filtration unit. The control architecture maintains the melting process at approximately 270 °C, thereby preserving polymer viscosity for molding while preventing temperature excursions beyond 300 °C that may initiate combustion and toxic by-product formation. The filtration module operates as a simplified wet scrubber, capturing airborne particulates and simultaneously cooling the exhaust stream. Experimental evaluations confirm that the integrated control–filtration framework achieves stable thermal regulation and substantial suppression of visible exhaust emissions. Under these conditions, molten plastic was consistently transformed into dense paving blocks with smooth surface morphology and without evidence of polymer degradation or charring. The results demonstrate that combining IoT-based thermal governance with low-cost water-spray emission control provides an effective and scalable alternative to open burning for community-level plastic waste recycling. This mobile platform enables environmentally safer conversion of plastic waste into value-added construction materials, offering a practical pathway toward decentralized circular-economy implementation in resource-constrained regions.]]>
Copyrights © 2026
