Claim Missing Document
Check
Articles

Found 2 Documents
Search

Characteristics of PB 260 clone rubber coagulated with natural coagulants: type of Averrhoa Achmad, Feerzet; Deviany, Deviany; Yuniarti, Reni; Fikrah, Faizatul; Az-Zahra, Syifa; Qarimah, Akhlatul; Marlina, Titi; Tambunan, Yonathan Marasi; Rahmadini, Gustia; Damayanti, Damayanti; Suhartono, Suhartono; Suharto, Suharto
Konversi Vol 13, No 1 (2024): April 2024
Publisher : Universitas Lambung Mangkurat

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.20527/k.v13i1.18724

Abstract

The aim of this research was to determine the properties of the PB 260 clone rubber using the Averrhoa type coagulant. The natural coagulants used in this study were Averrhoa bilimbi and Averrhoa carambola. The latex used was 150 ml of PB 260 clone rubber with a concentration of 100% natural coagulant of 75 ml and 2% formic acid. The rubber properties that were tested were Po, PRI, DRC, ash content, dirt content, volatile matter content and Mooney viscosity. This research also uses a special treatment in the form of centrifugation speed. The higher the centrifugation speed, the higher the pH value of the natural coagulant and the lower the H+ ion value, which accelerates the coagulation time of the latex. In natural coagulant extract, the highest values of Po, PRI, DRC, ash content, dirt content and Mooney viscosity were obtained at 0 rpm for Averrhoa bilimbi extract with values of 40%, 94.17%, 32.83%, 0, 32%, 0.038% and 77 MU. Meanwhile, in the test for volatile matter content, the highest value was found in Averrhoa carambola at 5000 rpm with a value of 0.23%.
Intensifikasi Pengolahan Limbah Cair Laboratorium Melalui Proses Koagulasi dan Adsorpsi Studi Pengolahan Limbah Cair Laboratorium dengan Metode Kombinasi Fisika-Kimia Sufra, Rifqi; Panjaitan, Jabosar R.H; Alhanif, Misbahudin; Mustafa, Mustafa; Yusupandi, Fauzi; Adriansyah, Endi; Rahmadini, Gustia; Raqin, M. Rayhan; Herawati, Peppy; Suzana, Asih
Jurnal Talenta Sipil Vol 7, No 1 (2024): Februari
Publisher : Universitas Batanghari Jambi

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.33087/talentasipil.v7i1.460

Abstract

Laboratory is one of the generators of hazardous liquid waste derived from chemicals used in practice and research. The waste is very dangerous when discharged into the environment because of the pollutants it contains. Therefore, it is necessary to treat the waste before it is disposed of to minimize the impact of pollution caused by the waste. The study aims to compare the effectiveness of zeolite adsorbents and activated carbon in reducing COD, TSS, and Cr heavy metals. Waste treatment is carried out by coagulation and adsorption methods. The adsorption process is performed using two types of adsorbents: zeolite and activated carbon. This study was carried out by variing the mass of the adsorbents at the time of complaining for 120 minutes in batches. Variations in the masses of the used 3, 5, 7, and 10 grams of adsorbenes. The results of the study showed that the more adsorbanes used, the higher the reduction of pollutant levels. The use of 10 grams of activated carbon adsorbents can reduce TSS pollutants levels of 92%, COD 95%, Cr 65%, and pH 5,0-6,38.