Claim Missing Document
Check
Articles

Found 2 Documents
Search
Journal : journal of science and applicative technology

Perancangan Sistem Pemanenan Energi Surya Terintegrasi Kaca Bangunan, Studi Kasus: Gedung Bandar Lampung Koko Friansa; Rishal Asri; Monna Rozana; FX Nugroho Soelami
Journal of Science and Applicative Technology Vol 3 No 2 (2019): Journal of Science and Applicative Technology December Chapter
Publisher : Lembaga Penelitian dan Pengabdian Masyarakat (LPPM), Institut Teknologi Sumatera, Lampung Selatan, Lampung, Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (1196.838 KB) | DOI: 10.35472/jsat.v3i2.209

Abstract

In this paper, design of solar energy harvesting system which integrated in building glass window was proposed. The location as the design reference is Bandar Lampung Building. Bandar Lampung Building uses 90% of the glass on the outside walls building with facing the sunrise and sunset. The design solar energy harvesting system was consisted of solar glass and electronic power system. Solar glass using several mini PV affixed on the glass with space in between, so partially of sunlight pass into the room. The solar energy harvesting system used for DC house network and not connected to the grid system. The solar energy harvesting is also equipped with power electronic system such as MPPT, lead acid battery, and DC-DC converter. The design of solar energy harvesting system is using calculative method based on secondary data several references for this case. Area of the solar glass reaches 16.32 m2 for 1 office room scale. The ratio between PV and room glass about 0.35. The power average of the solar glass on the glass building with facing to the sunrise is about 74.35 W, and then the average power of the solar glass with facing to the sunlight about 161.32W.
Simulasi Energi dan Keekonomian Sistem Pembangkit Listrik Tenaga Surya (PLTS) untuk Fungsi Peak Load Shaving pada Bangunan di Lingkungan Kampus ITB Irsyad Nashirul Haq; Justin Pradipta; Muhamad Riezar Satria Sheba; Alief Widjoseno Damar Persada; F.X. Nugroho Soelami; Edi Leksono
Journal of Science and Applicative Technology Vol 5 No 1 (2021): Journal of Science and Applicative Technology June Chapter
Publisher : Lembaga Penelitian dan Pengabdian Masyarakat (LPPM), Institut Teknologi Sumatera, Lampung Selatan, Lampung, Indonesia

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35472/jsat.v5i1.449

Abstract

Pada paper ini, dilakukan simulasi produksi energi dan keekonomian dari sistem PLTS terintegrasi dengan jaringan listrik yang merupakan bagian dari proyek instalasi sistem smart microgrid di bangunan Center for Advanced Sciences (CAS) ITB. Terdapat dua sistem PLTS yang dianalisis yaitu sistem PLTS 40 kWp tanpa baterai, dan sistem PLTS 10 kWp dengan baterai yang terhubung ke beban kritis. Kedua sistem PLTS tersebut dirancang dengan tujuan peak load shaving yang dapat meminimalisir adanya ketidakseimbangan antara produksi energi surya dan permintaan listrik. Kedua sistem dianalisis dengan metoda simulasi berdasarkan aspek energi dan ekonomi menggunakan perangkat lunak PVsyst dan Homer. Dari hasil simulasi sistem PLTS 40 kWp didapatkan nilai performance ratio (PR) sebesar 0,833, renewable fraction (RF) sebesar 18,73%, dan cost of energy (COE) sebesar Rp 1.251,85/kWh yang mana nilai PR dan COE telah memenuhi target bisnis: PR > 0.8 dan COE < Rp 1.467,28/kWh tetapi tidak memenuhi target RF > 35%. Sementara dari hasil simulasi sistem PLTS 10 kWp didapatkan nilai PR sebesar 0,77, RF sebesar 44,38% hingga 52,19% pada rentang depth of discharge 20% - 80%, dan COE sebesar Rp 2.103/kWh hingga Rp 6.315/kWh pada rentang DoD 20% - 80% yang mana hanya nilai RF telah memenuhi target bisnis.