TELKOMNIKA (Telecommunication Computing Electronics and Control)
Submitted papers are evaluated by anonymous referees by single blind peer review for contribution, originality, relevance, and presentation. The Editor shall inform you of the results of the review as soon as possible, hopefully in 10 weeks. Please notice that because of the great number of submissions that TELKOMNIKA has received during the last few months the duration of the review process can be up to 14 weeks. Communication Engineering, Computer Network and System Engineering, Computer Science and Information System, Machine Learning, AI and Soft Computing, Signal, Image and Video Processing, Electronics Engineering, Electrical Power Engineering, Power Electronics and Drives, Instrumentation and Control Engineering, Internet of Things (IoT)
Articles
2,614 Documents
Stemming Influence on Similarity Detection of Abstract Written in Indonesia
Tari Mardiana;
Teguh Bharata Adji;
Indriana Hidayah
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 14, No 1: March 2016
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v14i1.1926
In this paper we would like to discuss about stemming effect by using Nazief and Adriani algorithm against similarity detection result of Indonesian written abstract. The contents of the publication abstract similarity detection can be used as an early indication of whether or not the act of plagiarism in a writing. Mostly in processing the text adding a pre-process, one of it which is called a stemming by changing the word into the root word in order to maximize the searching process. The result of stemming process will be changed as a certain word n-gram set then applied an analysis of similarity using Fingerprint Matching to perform similarity matching between text. Based on the F1-score which used to balance the precision and recall number, the detection that implements stemming and stopword removal has a better result in detecting similarity between the text with an average is 42%. It is higher comparing to the similarity detection by using only stemming process (31%) or the one that was done without involving the text pre-process (34%) while applying the bigram.
Design of LDPC Decoder Based On FPGA in Digital Image Watermarking Technology
Zhongxun Wang;
Tiantian Tang
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 15, No 1: March 2017
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v15i1.4044
LDPC code and digital image watermarking technology, which is an effective method of digital copyright protection and information security, has been widely used. But this is a multi-disciplinary, multi technology application scheme. In order to realize FPGA design of LDPC decoder in the application scheme, an effective implementation method of digital watermarking application system must be found. In this paper, MATLAB software and Qt development environment are combined to achieve the digital watermarking application software design. It could get real-time input data for the LDPC decoder. Then the hardware of the LDPC decoder is primarily implemented by FPGA in the digital image watermarking system. And the serial port is used to make the output data of the decoder back to computer for verification. Through the simulation results, the Modelsim time simulation diagram is given, and the watermark image compared with the original image is got. The results show that the resource usage of our system is few, and the decoding rate is fast. It has a certain practical value.
Exponential Tapered Balun with Different Sizes for UWB Elliptical Dipole Antenna
M A Zakwan;
S A Hamzah;
S M Shah;
K N Ramli;
M S Zainal;
L Audah;
N Abdullah;
A Ubin;
F C Seman;
A K Anuar;
Adeeb Salh;
M Esa;
N N N Abd Malik
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 16, No 1: February 2018
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v16i1.8360
This work presents a broadband tapered balun with different sizes using nonlinear transition particularly suitable for planar and three-dimensional (3-D) dipole antennas for ultra-wideband (UWB) applications such as communication, radar systems and geolocation precision. Four baluns with wideband microstrip-to-parallel-strip transition using an elliptical structure for an elliptical dipole antenna are proposed. The initial balun structure consists of a nonlinear profile with a quarter-wavelength for both height and width. By studying the current distributions at the balun surface, it can be reduced to 25%, 50% and 75% from the original size. Measured results based on the reflection coefficients for all baluns are shown to be better than -10 dB from 1.0 GHz to 10 GHz. These baluns are integrated with an elliptical dipole which acts as a feeding circuit. Eight set of antennas with a planar and 3-D configurations with four different sizes are proposed in this work. The planar configurations are named as Planar 1, Planar 2, Planar 3 and Planar 4 while the 3-D configurations are named as 3D Dipole 1, 3D Dipole 2, 3D Dipole 3 and 3D Dipole 4, respectively. The results show that all antennas with the proposed baluns operates within the UWB frequency range.
Controlling The Radiation Pattern of Patch Antenna Using Switchable EBG
M.K. Abdulhameed;
M.S. Mohamad Isa;
Z. Zakaria;
M.K. Mohsin
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 16, No 5: October 2018
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v16i5.10443
The advantages of the beam steering technique are the reduction of interference, save power and to maximize connectivity for point to multi points. Antenna gain degradation is a big problem in the beam steering technique. A new antenna structure is formed by combining the concept of mushroom-like EBG structure with the switching diode to produce the radation pattern control. All sides of the patch antenna are surrounded by several cells for EBG structure. In both of the the left and right sides, through a switching pin diode, the ground plane is attached to vias. The band-stop and band-pass properties of the EBG sector can be changed with the help of switching the diode between ON and OFF state, thus yielding the beam steering into that particular sector. At 6 GHz operational frequency, this structure has the ability to steer 40º (from -20º to +20º) while minimal diodes are utilized, directivity of 10 dBi, gain 9.86 dB and the efficiency is 96.5%. This approach is robust to gain degradation and the main lobe gain is approximately constant for all steering angles.
Low-cost communication system for explorer-class underwater remotely operated vehicle
Simon Siregar;
Muhammad Ikhsan Sani;
Muhammad Muchlis Kurnia;
Dzikri Hasbialloh
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 17, No 2: April 2019
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v17i2.11791
Disaster recovery from underwater earthquake, plane crashes into the sea, and monitoring underwater cables or piping for energy purpose are underwater missions for Remotely Operated Underwater Vehicle (ROV) in ASEAN MATE 2018 Competition. Two essentials factor to perform successfully in this ROV competition are design of an efficient communication protocol system and a low-cost communication hardware. In this research, an optimal communication system between RS-232 serial communication transmission and RS-485 serial communication transmission is developed to obtain the optimal solution. Both communication system is tested in Tech_SAS ROV-Telkom University Indonesia, a microcontroller underwater ROV based which used single microcontroller to control actuator, sensor and communication, and measured the Quality of Services (QoS) for end-to-end delay and packets loss. From the the experiment and evaluation for the two schemes, shows 12.57 ms end-to-end delay, 0% data packet error and $6 RS-485 communication system are the optimal solution for Tech_SAS ROV.
Characterization of silicon nanowire transistor
Hani Taha Al Ariqi;
Waheb A. Jabbar;
Yasir Hashim;
Hadi Bin Manap
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 17, No 6: December 2019
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v17i6.13084
This paper analyses the temperature sensitivity of Silicon Nanowire Transistor (SiNWT) depends on the diameter (D.ch) of channel. In addition, it also investigates the possibility of utilizing SiNWT as a Nano- temperature sensor. The MuGFET simulation tool has been utilized to conduct a comprehensive simulation to evaluate both electrical and temperature characteristics of SiNWT. Current-voltage characteristics with different values of temperature and with a varying diameter of the Nano wire channel (D.ch = 80, 40, 20 and 10 nm), were simulated. Diode operating mode connection of the transistor is suggested for measuring the temperature sensitivity of SiNWT. As simulation results demonstrated, the best temperature sensitivity was occurred at lower temperature with increasing the channel diameter. We also illustrate the impact of varying temperature and channel diameter on electrical characteristics of SiNWT including, Subthreshold Swing (SS), Threshold voltage (V.th), and Drain-induced barrier lowering (DIBL), which were proportionally increased with the operating temperature.
Area calculation based on GADM geographic information system database
Adi Setiawan;
Eko Sediyono
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 18, No 3: June 2020
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v18i3.14901
This paper aims to provide an overview of the calculation of the area of Indonesia based on the boundaries of sub-district/village, district, regency/city. The circle approach method is proposed as a fast method for determining the land area of Indonesia. The total area of Indonesia can be obtained by adding up to 33 provinces or 502 regencies/cities or 6696 districts or 77474 sub-districts. Calculation of the area of the area using district boundaries is better used in the calculation of the area of Indonesia which is obtained 1,965,443.51 km2. The results obtained are 2.53% bigger than the reference area.
Applying convolutional neural networks for limited-memory application
Xuan-Kien Dang;
Huynh-Nhu Truong;
Viet-Chinh Nguyen;
Thi-Duyen-Anh Pham
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 19, No 1: February 2021
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v19i1.16232
Currently, convolutional neural networks (CNN) are considered as the most effective tool in image diagnosis and processing techniques. In this paper, we studied and applied the modified SSDLite_MobileNetV2 and proposed a solution to always maintain the boundary of the total memory capacity in the following robust bound and applied on the bridge navigational watch & alarm system (BNWAS). The hardware was designed based on raspberry Pi-3, an embedded single board computer with CPU smartphone level, limited RAM without CUDA GPU. Experimental results showed that the deep learning model on an embedded single board computer brings us high effectiveness in application.
Numerical Analysis of the Factors about Combustion Stability on Boiler
Li Jun Li Jun;
Yan Weiping;
Gao Yang
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 10, No 2: June 2012
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v10i2.799
Through the research of the coal pulverized catches fire and steadily combustion mechanism, the numerical simulation of the 300MW tangentially pulverized coal fired boiler by Coal-fire software, and combine the operating data of the boiler, the corresponding relation between the result of numerical simulation and combustion stability have been established. The result indicates that the higher volatile matter, lower content of ash and moisture of the coal, it helps the coal pulverized air current to catch fire. More fineness coal pulverized is favorable to catch fire. When boiler load reduced, it will influence the characteristic"lighted by itself" of the tangentially pulverized coal fired boiler, and it will cause combustion unstably.
Quantized Feedback Control of Network Empowerment Ammunition with Data-Rate Limitations
Fang Jin;
Zhi-hua Yuan;
Qing-Quan Liu;
Zhang Xing
TELKOMNIKA (Telecommunication Computing Electronics and Control) Vol 12, No 3: September 2014
Publisher : Universitas Ahmad Dahlan
Show Abstract
|
Download Original
|
Original Source
|
Check in Google Scholar
|
DOI: 10.12928/telkomnika.v12i3.125
This paper investigates quantized feedback control problems for network empowerment ammunition, where the sensors and the controller are connected by a digital communication network with data-rate limitations. Different from the existing ones, a new bit-allocation algorithm on the basis of the singular values of the plant matrix is proposed to encode the plant states. A lower bound on the data rate is presented to ensure stabilization of the unstable plant. It is shown in our results that, the algorithm can be employed for the more general case. An illustrative example is given to demonstrate the effectiveness of the proposed algorithm.