Article Per Year (5 Year)
p-Index From 2020 - 2025
1.116
P-Index
This Author published in this journals
All Journal Abdimas Umtas : Jurnal Pengabdian kepada Masyarakat Jurnal Asiimetrik: Jurnal Ilmiah Rekayasa Dan Inovasi JURNAL ABDI MASYARAKAT INDONESIA (JAMIN)
Sentot Novianto
Universitas Trisakti
Religion Agriculture, Biological Sciences & Forestry Arts Civil Engineering, Building, Construction & Architecture Computer Science & IT Earth & Planetary Sciences Education Electrical & Electronics Engineering Energy Engineering Environmental Science Industrial & Manufacturing Engineering Social Sciences Other

Published : 5 Documents Claim Missing Document
Claim Missing Document
Check
Articles

Found 5 Documents
Search

 1 
Detection Of Water Levels In Sewering Channels As Flood Disaster Early Warning System Syah Alam; indra surjati; Lydia Sari; Sentot Novianto; Chairul Rizki; Rizka Shafira; Tri swasono adi
ABDIMAS: Jurnal Pengabdian Masyarakat Vol. 4 No. 2 (2021): ABDIMAS UMTAS: Jurnal Pengabdian Kepada Masyarakat
Publisher : LPPM Universitas Muhammadiyah Tasikmalaya

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (563.744 KB) | DOI: 10.35568/abdimas.v4i2.1354

Abstract

In 2020 a number of areas in DKI Jakarta were hit by floods, one of which was the North Tanjung Duren Village, Grogol Petamburan District, West Jakarta. The extreme rainfall of 377 mm/day has flooded almost all areas of DKI Jakarta and its surroundings. In addition, poor drainage causes water to stagnate, causing flooding. However, the absence of an early flood information system makes residents restless when the rainy season arrives. The Community Service (Community service activity) activity carried out aims to provide training to the community in the Tanjung Duren Utara Village area RW 04, RT 0010 regarding water level detection equipment placed in culverts. This tool serves to provide early information if the volume of water in the culvert is full of information in the form of a siren sound. The method used in this Community service activity activity is to provide online counseling and training to the community in RT 0010 / RW 04, North Tanjung Duren Village, Grogol Petamburan District, West Jakarta. The results obtained are an increase in public understanding regarding the dangers of flooding to household electricity, as indicated by the results of the pre-test and post-test which are obtained an average of 43 and 90, respectively. Public understanding of the dangers of flooding to electricity has increased up to 109.3%. In addition, the average partner satisfaction with the material presented is 92%, this shows that the material presented by the presenters team is very useful for the extension participants.
Rancang Bangun Sistem Pengukuran Alat Thermobath sebagai Alat Kalibrasi Temperatur dengan Sistem Arduino Uno Yogatama Wishnu Pandu Prayudha; Sayid Fadhil; Sentot Novianto
Jurnal Asiimetrik: Jurnal Ilmiah Rekayasa & Inovasi Volume 4 Nomor 1 Tahun 2022
Publisher : Fakultas Teknik Universitas Pancasila

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35814/asiimetrik.v4i1.2541

Abstract

A thermobath cooler is a device that contains water or other liquid as a coolant that can maintain a constant temperature. The control system designed in this study uses a K-type thermocouple temperature sensor and pressure transmitter microcontroller-based, namely Arduino Uno to be able to produce temperature and pressure measurement data on the thermobath through the software PLX-DAQ. This system thermobath requires a K-type thermocouple component and apressure transmitter JYB-KO-H. Before being placed in the system thermobath, the K-type thermocouple and pressure transmitter are required to calibrate. Based on the results of the temperature and pressure calibration equation, the coefficient of determination (R2) on the K-type thermocouple ranges from 0.9986 to 0.9998 and the coefficient of determination (R2) at the pressure transmitter is 0.9994. With the calibration results, the design of measuring thetool thermobath as a temperature calibration tool with the Arduino system can be applied to thecooling system thermobath.
Pembuatan Aerator Dengan Menggunakan Tenaga Surya Untuk Pemeliharaan Ikan Pada Kolam Berdimensi Kecil Sentot Novianto; Supriyadi Supriyadi; Abigunto Amoro Adji; Muhammad Faishal Ammar
Jurnal Abdi Masyarakat Indonesia (JAMIN) Vol 4 No 1 (2022): JURNAL ABDI MASYARAKAT INDONESIA (JAMIN)
Publisher : Universitas Trisakti

Show Abstract | Download Original | Original Source | Check in Google Scholar | Full PDF (474.959 KB) | DOI: 10.25105/jamin.v4i1.9652

Abstract

Kebutuhan udara pada kolam pemeliharaan ikan sangat vital untuk kelangsungan hidup ikan yang dipelihara. Beberapa kolam yang dikembangkan tidak memiliki suplai udara yang cukup, seperti pemeliharaan ikan di dalam terpal ataupun di dalam akuarium. Tumbuhnya ikan menyebabkan kebutuhan udara di dalam air meningkat. Solusi untuk menyuplai udara di kolam adalah dengan menggunakan aerator. Aerator yang biasa digunakan pada umumnya menggunakan energi listrik langsung dari PLN atau berbahan bakar diesel. Penggunaan energi tersebut menimbulkan biaya yang cukup besar dan berpengaruh terhadap keuntungan budidaya ikan. Kegiatan PkM ini bertujuan untuk membuat sistem aerator sebagai penyuplai udara pada kolam berdimensi kecil dengan sumber energi penggerak aerator menggunakan energi alternatif yaitu surya (panel surya). Metode yang digunakan adalah dengan membuat tracker panel surya untuk mengoptimalkan energi surya yang akan digunakan untuk aerator. Hasil yang telah dicapai berupa prototype aerator bertenaga surya 100 Wp yang dapat dipergunakan untuk mendukung budidaya ikan di lokasi mitra PkM yaitu di Griya Asri, Purwakarta.
The Effect of Heat Flux on the Frequency of Bubble Appearance in a Boiling Pool Muhammad Hasan; Supriyadi; Larasati Rizky Putri; Sofia Debi Puspa; Sentot Novianto
Jurnal Asiimetrik: Jurnal Ilmiah Rekayasa dan Inovasi Volume 6 Nomor 1 Tahun 2024
Publisher : Fakultas Teknik Universitas Pancasila

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35814/asiimetrik.v6i1.4812

Abstract

This research was conducted to determine the effect of heat flux on the frequency of bubbles appearing in boiling ponds. All fluid movement in pool boiling is caused by natural convection currents. The boiling pool consists of four areas of the pool boiling regime. The division of the four areas is based on the value of the heat flux and the difference between the surface temperature of the heater and the fluid. Using a two-phase heat transfer unit (H654 P.A. Hilton machine), The results showed that the power used greatly influences the boiling process, and besides that, the volume of water used also affects the duration of the boiling process. Based on tests using various power levels of 75 W, 110 W, 168 W, 237.5 W, and 290 W. The occurrence of bubbles will be faster and more numerous when using a lower volume of water and greater power. The heat transfer will be greater if a bubble appears, where latent heat plays a very important role. With mathematical analysis, an increase of 1 bubble per minute occurs for every increase in heat flux of 1.3 W/m2.
Study Characteristic Thermal Electric Generator (TEG) Type SP1848 27145 SA Sofia Debi Puspa; I Putu Budi Dharma; Sentot Novianto; Supriyadi; M. Alfian Gibran
Jurnal Asiimetrik: Jurnal Ilmiah Rekayasa dan Inovasi Volume 6 Nomor 1 Tahun 2024
Publisher : Fakultas Teknik Universitas Pancasila

Show Abstract | Download Original | Original Source | Check in Google Scholar | DOI: 10.35814/asiimetrik.v6i1.5561

Abstract

The TEG component, which operates on the Seebeck principle like a thermocouple, is widely used in the market, with TEG SP1848 27145 SA being one of the most common types. However, experiments must be conducted to determine its Seebeck coefficient, voltage, and power output when used with different heat and cold sources. This research aims to observe how the Seebeck coefficient, voltage, and power output of TEG SP1848 27145 SA change with variations in system temperature. To experiment, TEG SP1848 27145 SA is tested with a heater, and water flow rates are varied for cooling. Furthermore, the correlation between output voltage and ΔT has been determined through statistical analysis. The experiment results showed that the voltage output ranged from 0.54–1.03 V at a heater temperature of 86°C and an ΔT system value of 70.5-75°C. The Seebeck value was between 1,551.7-2,998.5 µV, and the power output was 43.5-67.7 mW. Additionally, the statistical analysis found a significant correlation between the temperature variable and output voltage variable, with an adjusted r square value of 89.2% for zero water flow rate and increasing to 95.8% for maximum water flow rate.
Co-Authors Abigunto Amoro Adji Chairul Rizki I Putu Budi Dharma Indra Surjati Larasati Rizky Putri Lydia Sari M. Alfian Gibran Muhammad Faishal Ammar Muhammad Hasan Rizka Shafira Sayid Fadhil Sofia Debi Puspa Supriyadi Supriyadi Supriyadi Syah Alam Tri swasono adi Yogatama Wishnu Pandu Prayudha